Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Thermal transfer regulation of one-dimensional heterostructure is essential, but the influence of vacancy defects on interfacial thermal conductance (ITC) remains unclear. In this paper, we demonstrate that vacancy defects at the carbon/boron nitride heteronanotubes (CBNNT) significantly reduce the ITC, with N atoms vacancy exhibiting a more pronounced inhibitory effect than C atoms vacancy. This decline in ITC is attributed to vacancy-induced lattice distortions that diminish the overlap of the phonon density of states, ultimately enhancing phonon localization. Spectral heat current analysis confirms that vacancy defects markedly suppress phonon transport across the interface. Polarization-resolved decomposition further reveals that out-of-plane phonon modes dominate interfacial heat conduction but exhibit higher sensitivity to structural defects. Moreover, increasing temperature enhances phonon excitation and inelastic scattering, thereby facilitating low-frequency phonon transport and improving ITC. These findings provide atomic-scale insights into vacancy defect-modulated heat transport in low-dimensional nanostructures.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acs.langmuir.5c03302DOI Listing

Publication Analysis

Top Keywords

vacancy defects
16
defects carbon/boron
8
carbon/boron nitride
8
nitride heteronanotubes
8
atoms vacancy
8
phonon transport
8
vacancy
7
phonon
6
defects
5
thermal transport
4

Similar Publications

Levetiracetam-Assisted Perovskite Crystallization and Tripartite Lead Iodide Reduction in Perovskite Solar Cells.

Adv Mater

September 2025

Key Lab of Artificial Micro- and Nano-Structures of Ministry of Education of China, School of Physics and Technology, Wuhan University, Wuhan, 430072, China.

Sequential deposition technique is widely used to fabricate perovskite films with large grain size in perovskite solar cells (PSCs). Residual lead halide (PbI) in the perovskite film tends to be decomposed into metallic lead (Pb) under long-term heating or light soaking. Here, a chiral levetiracetam (LEV) dopant containing α-amide and pyrrolidone groups is introduced into the PbI precursor solution.

View Article and Find Full Text PDF

Controllable synthesis of -hexagonal ZnAl-LDHs nanosheets for high-performance room-temperature ethanol gas sensing.

Dalton Trans

September 2025

School of Electronics and Information Engineering, Hebei University of Technology, Tianjin Key Laboratory of Electronic Materials and Devices, 5340 Xiping Road, Beichen District, Tianjin, 300401, China.

Layered double hydroxides (LDHs) have attracted considerable attention in gas sensing applications due to their highly tunable chemical composition and unique two-dimensional layered architecture. In this study, a series of ZnAl-LDHs with varying Zn/Al molar ratios were synthesized a facile hydrothermal method, and their ethanol sensing performance at room temperature was systematically evaluated. The influence of composition on the structural, morphological, and electronic properties of the materials was thoroughly investigated using a suite of characterization techniques, including XRD, FTIR, SEM, TEM, BET, XPS, PL, and EPR.

View Article and Find Full Text PDF

Efficient and low-cost removal of dissolved organic phosphorus by visible light-enhanced Ti electrocoagulation with self-generated rutile photocatalysts.

Water Res

August 2025

State Key Laboratory of Environmental Aquatic Chemistry, Key Laboratory of Drinking Water Science and Technology, Research Center for Eco-Environmental Sciences, Chinese Academy of Sciences, Beijing 100085, China.

Phosphorus is recognized as a major pollutant in municipal and domestic wastewater, but the effective removal of organic phosphorus (OP) using conventional wastewater treatment technologies is difficult. Herein, a novel visible light-enhanced Ti electrocoagulation (EC) technology was proposed for the removal of OP using 2-amino-ethyl phosphonic acid (AEP) as a model compound to elucidate the removal efficiency and mechanisms. The results showed that the irradiation under visible light (670 Lux) effectively enhanced the removal of AEP by Ti EC.

View Article and Find Full Text PDF

Multijunction photoelectrodes, which generate active photocarriers with sufficient energy to drive unassisted solar-fuel conversion, represent a promising avenue for sustainable energy applications. However, achieving controllable p/n-type doping and high-quality growth remains a challenge for most emerging metal oxide semiconductors. In this study, we demonstrate the creation of in-plane ferroelectric p/n homojunction superstructures in BiFeO (BFO) films, enabling bias-free photoelectrochemical (PEC) reactions.

View Article and Find Full Text PDF

Room Temperature Flexible Gas Sensor Based on MOF-Derived Porous Carbon Skeletons Loaded with ZnO Nanoparticles and DMF Detection.

ACS Appl Mater Interfaces

September 2025

Key Laboratory of Atomic and Molecular Physics & Functional Materials of Gansu Province, College of Physics and Electronic Engineering, Northwest Normal University, Lanzhou 730070, China.

Overcoming the persistent challenges of high operating temperatures and poor selectivity in metal oxide semiconductor (MOS) gas sensors, this work enhances defect sites in the sensing material through heterostructure construction and builds mesoporous architectures using MOF-derived carbon skeletons as templates. The synergistic effects of multiple mechanisms significantly improve gas-sensing performance, successfully fabricating a ZnO/PCS flexible room-temperature gas sensor with exceptional room-temperature DMF detection capabilities. The nitrogen-containing porous carbon skeletons (PCSs) template shows a stable mesoporous microstructure with large pore volume.

View Article and Find Full Text PDF