98%
921
2 minutes
20
In this study, the release of proteins and other biomolecules into an aqueous media from two red macroalgae ( and ) was studied using eight different cell disruption techniques. The contents of carbohydrates, pigments, and phenolic compounds coextracted with proteins were quantified. In addition, morphological changes at the cellular level in response to the different pretreatment methods were observed by an optical microscope. Finally, the antioxidant capacity of obtained protein extracts was evaluated using three tests. For both and , ultrasonication for 60 min proved to be the most effective technique for protein extraction, yielding values of 3.46 ± 0.06 mg/g DW and 9.73 ± 0.41 mg/g DW, respectively. Furthermore, the highest total contents of phenolic compounds, flavonoids, and carbohydrates were also recorded with the same method. However, the highest pigment contents were found with ultrasonication for 15 min. Interestingly, relatively high antioxidant activities like radical scavenging activity (31.57-65.16%), reducing power (0.51-1.70, OD at 700 nm), and ferrous iron-chelating activity (28.76-61.37%) were exerted by the different protein extracts whatever the pretreatment method applied. This antioxidant potency could be attributed to the presence of polyphenolic compounds, pigments, and/or other bioactive substances in these extracts. Among all the used techniques, ultrasonication pretreatment for 60 min appears to be the most efficient method in terms of destroying the macroalgae cell wall and extracting the molecules of interest, especially proteins. The protein fractions derived from the two red macroalgae under these conditions were precipitated with ammonium sulfate, lyophilized, and their molecular weight distribution was determined using SDS-PAGE. Our results showed that the major protein bands were observed between 25 kDa and 60 kDa for and ranged from 20 kDa to 150 kDa for . These findings indicated that ultrasonication for 60 min could be sufficient to disrupt the algae cells for obtaining protein-rich extracts with promising biological properties, especially antioxidant activity.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11083387 | PMC |
http://dx.doi.org/10.3390/foods13091362 | DOI Listing |
Ultrason Sonochem
September 2025
College of Science, Inner Mongolia University of Technology, Hohhot 010051, China.
In this study, the systematic investigation focused on how varying power levels of ultrasonic (US) pretreatment, when integrated with electrohydrodynamic (EHD) drying, influence the physicochemical properties of yam. Yam samples were subjected to ultrasonic pretreatment at 30 °C for 30 min using power levels of 0 W (Control), 150 W, 180 W, 210 W, 240 W, and 270 W, respectively, followed by drying in an EHD system. During the drying process, a range of metrics were measured, including moisture content, average drying rate, color change, as well as rehydration capacity.
View Article and Find Full Text PDFInt J Biol Macromol
September 2025
The Affiliated Dongguan Songshan Lake Central Hospital, Guangdong Provincial Key Laboratory of Research and Development of Natural Drugs, School of Pharmacy, Guangdong Medical University, Dongguan, 523808, China.
This study explores the extraction of polysaccharides from Nostoc commune Vauch. using ultrasonic-assisted three-phase partitioning with deep eutectic solvents (UA-TPP-DES). Response surface methodology was used to determine the optimized UA-TPP-DES conditions as follows: a 1: 2 M ratio of lauric acid to terpineol, 30 min of ultrasonication at 60 °C with 100 W power, 20 % moisture content, 20 % w/w (NH)SO concentration, and a 2: 1 top-to-bottom phase volume ratio.
View Article and Find Full Text PDFAnal Chim Acta
November 2025
Multidisciplinary Laboratory of Food and Health (LabMAS), School of Applied Sciences (FCA), Universidade Estadual de Campinas (UNICAMP), Rua Pedro Zaccaria 1300, Limeira, 13484-350, São Paulo, Brazil. Electronic address:
Background: Monitoring industrial processes is critical for ensuring consistent product quality, as consumers expect uniformity across different production batches. In the case of herbal extracts, such as rosemary hydroalcoholic extracts, it is essential to control the yield of target compounds to maintain both the expected quality and safety. Typically, these extracts are produced in an extractor and then analyzed separately in a laboratory (offline).
View Article and Find Full Text PDFFood Chem
September 2025
College of Food Science, Northeast Agricultural University, Harbin, Heilongjiang 150030, China. Electronic address:
Sodium alginate-combined ultrasonic (SA-US) modification of wheat flour and corn starch was characterized to investigate its effects on batter properties and fried fish crispiness. This modification significantly increased hydration properties, and gelatinization temperature of wheat flour and corn starch (P < 0.05), while decreasing short-range structure, double helices, crystallinity, and starch granules' integrity.
View Article and Find Full Text PDFACS Appl Mater Interfaces
September 2025
School of Material Science and Engineering, Beijing University of Chemical Technology, 15 North Third Ring Road, Chaoyang, Beijing 100029, China.
The construction of perfluoropolyether (PFPE) slippery liquid-infused porous surfaces (SLIPS) on gold coatings is one of the most effective strategies for bestowing anticoagulation and antimicrobial properties on the material. However, the poor chemical affinity between fluorinated porous precursors and gold substrates causes the agglomeration of nanostructures, resulting in uneven nanoporous morphology and accelerating lubricant leakage. Simultaneously, the weak interfacial adhesion between the nanostructures and the substrate may lead to the detachment of nanostructures under blood circulation.
View Article and Find Full Text PDF