98%
921
2 minutes
20
Bentonite is considered for use as a buffer material in the final disposal repositories of radioactive waste. Long-lived 135Cs with a half-life of 2.3 × 106 years is a key radionuclide in high-level waste, and lots of 137Cs with a half-life of 30.2 years exists in low-level waste. Therefore, the adsorption of Cs on bentonite is a critical issue in evaluating the long-term safety of radioactive waste disposal. In this study, EXAFS techniques were used to characterize the time-dependent process from the beginning of adsorption to equilibrium. From the results of this study, we found changes including to the Cs adsorption sites, the Cs-O distance between Cs and the oxygen atom, and that the adsorption of Cs ions occurred before the reaction reached equilibrium. The fraction of OS complexes when Cs was adsorbed on bentonite can refer to the CN (Cs-O1st)/CN (Cs-O2nd) ratio of coordination numbers, and this study found that the OS complex was the major adsorption species when Cs adsorbed onto bentonite. In addition to the ratio CN (Cs-O1st)/CN (Cs-O2nd) providing information on the adsorption site, we also discussed the change of Cs-O1st and Cs-O2nd bond distances to identify the adsorption sites at different times. Comparing the XRD patterns of montmorillonite and bentonite, we found that the interlayer collapsed after Cs was adsorbed onto montmorillonite, but it expanded after Cs was adsorbed onto bentonite. From the results of EXAFS fitting, we found that the movement of Cs ions was from regular interlayer sites to expanded interlayer sites, which caused the interatomic distance of Cs-O2nd to decrease with an increase in time. It was revealed that the adsorption of Cs on bentonite occurred in two steps. The first step includes the rapid uptake of Cs by attachment to the oxygen atoms of the H2O molecules at the regular interlayer sites, especially for the OS complexes. The second step includes a slower process where dehydrated Cs ions move from the regular interlayer sites to the expanded interlayer sites. In this study, Cs L3-edge EXAFS spectroscopy was conducted for the Cs adsorbed on bentonite to identify the Cs adsorption sites over time, as this is important in evaluating the mobility of Cs in the environment. These results are beneficial in finding the process of Cs adsorption on bentonite, which could be used for the design of the final disposal of spent nuclear fuel.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1039/c9em00124g | DOI Listing |
ACS Appl Mater Interfaces
September 2025
School of Materials and New Energy, South China Normal University, Shanwei 516600, China.
Nowadays, the continuous advancement of sodium-ion battery technology has made it an important choice in the new energy field and promoted the development of lithium-ion batteries. The cycling stability of cathode materials for sodium-ion batteries at high voltage (>4.0 V) is still a key challenge.
View Article and Find Full Text PDFChem Commun (Camb)
September 2025
Hunan Provincial Key Laboratory of Chemical Power Sources, College of Chemistry and Chemical Engineering, Central South University, Changsha, 410083, China.
The O3-type NaNiFeMnO material is modified by introducing Sr into the Na sites and Al into the transition metal (TM) sites. The inactive Sr and Al serve as structural pillars within the NaO and TMO slabs, respectively, expanding the interlayer spacing and boosting the stability of the structure. The optimized cathode demonstrates a good rate performance of 117.
View Article and Find Full Text PDFJ Colloid Interface Sci
August 2025
School of Energy, Soochow University, Suzhou 215006, China. Electronic address:
The lithium‑oxygen battery (LOB) has emerged as an appropriate candidate for next-generation power supply system, owing to the ultrahigh theoretical energy density (3480 Wh kg) and relatively low cost. However, some intrinsic challenges, including high redox overpotentials, limited rate capability, and poor cyclic life, continue to hinder the practical deployment of lithium‑ oxygen batteries. The fundamental limitations originate from sluggish oxygen reduction/evolution reaction (ORR/OER) kinetics and parasitic side reactions, which can be effectively mitigated by employing efficient cathode electrocatalysts.
View Article and Find Full Text PDFJ Am Chem Soc
August 2025
Key Laboratory of Synthetic and Natural Functional Molecule Chemistry of Ministry of Education, College of Chemistry and Materials Science, Northwest University, Xi'an 710127, China.
The ordered growth of semiconductor quantum dots (QDs) in confined environments remains a critical challenge in photocatalysis. Herein, CsBiBr (CBB) QDs were covalently anchored as single-rod nanocrystals (SRNCs) within Hf-based metal-organic framework (MOF) nanosheets (Hf-bpy, Hbpy = 2,2'-bipyridine-5,5'-dicarboxylic acid), forming a series of host-guest photocatalysts CBB@Hf-bpy. By modulation of the thickness of MOF nanosheets, the length of CBB SRNCs was effectively shortened to 18 nm, exhibiting strong quantum confinement effects.
View Article and Find Full Text PDFTalanta
August 2025
School of Electronic Information Engineering, Changchun University of Science and Technology, Changchun, Jilin, 130022, PR China. Electronic address:
Herein, a novel synthetic method is proposed to obtain hollow few-layer TiCT nanosheets@Ni-Fe layered double hydroxide microrods (TiCT@NiFe-LDH), which includes the coating process of MIL-88A microrods by two-dimensional TiCT nanosheets, the pre-adsorption process of 2-methylimidazole on the surfaces of MIL-88A@TiCT microrods, and the co-precipitation process of Ni and Fe with the interlayer of fumaric acid anions, resulting in the unique material structure of TiCT@NiFe-LDH. More importantly, hollow microrods composed of TiCT and NiFe-LDH nanosheets show the structural advantages, which are responsible for the high-performance behaviors towards the non-enzymatic detection of glucose, leading to 0.5-115.
View Article and Find Full Text PDF