Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

The impact tendency of coal is a necessary condition for the occurrence of pressure bumping and a measure of the degree of damage. Through the combination of self-made lateral restraint device and high-speed camera, the variation law and failure mode of burst tendency index of coal samples under real-time drilling and pressure relief of lateral restraint under different loads were studied. The results show that: (1) With the increase of real-time drilling load under lateral constraints, the burst tendency index of coal samples changes. (2) The failure order of coal samples is as follows: the corner coal flakes peel off and pulverized coal is sprayed out, cracks and deformations are generated around the borehole, and finally the coal flakes peel off and the cracks penetrate to cause large-area damage of the coal samples. At the same time, the internal energy of the coal samples is released through borehole, which significantly reduces the damage of the coal samples. (3) The lateral restraint device makes the coal samples always in a stable state before and after drilling, resulting in the weakening effect of the burst tendency of the coal sample is not significant, and the pressure relief effect is not obvious. The research results can provide new ideas and methods for drilling and pressure relief test, and also provide basis and guidance for the prevention of pressure bumping in coal mines.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC12000470PMC
http://dx.doi.org/10.1038/s41598-025-97898-0DOI Listing

Publication Analysis

Top Keywords

coal samples
32
tendency coal
16
coal
14
lateral restraint
12
burst tendency
12
pressure relief
12
impact tendency
8
samples
8
samples lateral
8
pressure bumping
8

Similar Publications

Naomaohu lignite (NL) from Hami, Xinjiang, was ultrasonically extracted with a mixed solvent of CS and acetone (in equal volumes) to obtain the extract residue (ER). The ER was then separated based on density differences with CCl to yield the corresponding light residue (NL-L). The composition and structural characteristics of the light residue were characterized by proximate, ultimate, infrared, and thermogravimetric analyses (TG-DTG).

View Article and Find Full Text PDF

The Influence of Embedded Properties on the Liberation Characteristics of Macerals in Subbituminous Coal.

ACS Omega

September 2025

CHN ENERGY CORNERSTONE CHEMICAL TECHNOLOGY (SHANGHAI) CO.,LTD, Shanghai 201100, China.

The utilization pathways of coal macerals exhibit a significant variability. The efficient separation of active and inert components in coal is critical for realizing their high value-added applications. The liberation efficiency of coal macerals directly influences the accuracy of subsequent separation processes.

View Article and Find Full Text PDF

Study on Permeability and Flow Characteristics of Composite Thermosensitive Hydrogel and Its Fire Prevention and Extinguishment Performance.

ACS Omega

September 2025

State Key Laboratory for Fine Exploration and Intelligent Development of Coal Resources, China University of Mining and Technology, Xuzhou, Jiangsu 221116, People's Republic of China.

This study focuses on the issues of poor fluidity, low penetration into residual coal, and suboptimal inhibition of coal spontaneous combustion associated with traditional coal mine gel fire retardants. The permeability and flow characteristics of a sodium alginate-based composite thermosensitive hydrogel, as well as its fire prevention and extinguishment performance, were investigated. The findings suggest that the thermosensitive hydrogel behaves as a pseudoplastic fluid at 40 °C and a yield-pseudoplastic fluid at 65 °C, exhibiting shear-thinning behavior with increasing shear rate.

View Article and Find Full Text PDF

Evaluation of advanced SEM-EDX tools for classification of complex particles in respirable dust.

J Hazard Mater

September 2025

Mining and Minerals Engineering, Virginia Tech, Blacksburg, VA, USA. Electronic address:

Occupational lung disease remains a serious concern among miner workers, underscoring the need for improved characterization of respirable dust. Scanning electron microscopy with energy dispersive X-ray spectroscopy (SEM-EDX) enables high-resolution analysis of filter samples, but accurate identification of complex, multi-constituent particles like agglomerates during direct-on-filter (DOF) analysis remains challenging. This is because standard tools for automated SEM-EDX treat each dust entity as an independent particle.

View Article and Find Full Text PDF

An improving spectral PTF for mining area soil water content prediction: combining 2D correlation spectroscopy and soil-crop indicators with ResGRU.

Spectrochim Acta A Mol Biomol Spectrosc

August 2025

State Key Laboratory for Safe Mining of Deep Coal Resources and Environment Protection, Anhui University of Science and Technology, Huainan 232001, China; School of Spatial Informatics and Geomatics Engineering, Anhui University of Science and Technology, Huainan 232001, China. Electronic address: c

Conventional methods for soil sampling and soil water content (SWC) measurement are often labor-intensive and time-consuming. The Pedo-transfer function (PTF) integrating soil spectroscopy with soil physicochemical properties provides a more efficient approach for SWC estimation. However, existing studies highlight regional limitations in the accuracy of PTFs across diverse geographical regions.

View Article and Find Full Text PDF