Detection of Hydrogen Peroxide Vapors Using Acidified Titanium(IV)-Based Test Strips.

One method for the colorimetric detection of hydrogen peroxide vapor is based on a titanium-hydrogen peroxide complex. A color changing material based on a titania hydroxypropyl cellulose thin film was initially developed. However, as this material dries, the sensitivity of the material is significantly reduced. Thus, an alternative sensing material, based on titanium(IV) oxysulfate, an ionic liquid, and in some cases, triflouromethanesulfonic acid adsorbed onto low-cost silicon thin-layer chromatography (TLC) plates, was developed. TiO was heated with concentrated sulfuric acid in a controlled environment, usually at temperatures ranging from 100 °C to 250 °C. These sensors are disposable and single-use and are simple and inexpensive. When the resulting thin-film sensors are exposed to ppm levels of hydrogen peroxide vapor, they turn from a white reflective material to an intense yellow or orange. Ti(IV) oxysulfate combined with an acid catalyst and an ionic-liquid-based material provides an opportunity to enhance the sensor activity towards the peroxide vapor and decreases the detection limit. Kinetic measurements were made by the quantification of the intensity of the reflected light as a function of the exposure time from the sensor in a special cell using a low-cost web camera and a tungsten lamp. The measured rate of the color change indicates high sensitivity and first-order kinetics over a hydrogen peroxide concentration range of approximately 2 to 31 ppm. These new materials are a starting point for the preparation of more active sensor materials for hydrogen peroxide and organic peroxide vapor detection.