Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Promoters enhance the performance of catalytic active phases by increasing rates, stability, and/or selectivity. The process of identifying promoters is in most cases empirical and relies on testing a broad range of catalysts prepared with the random deposition of active and promoter phases, typically with no fine control over their localization. This issue is particularly relevant in supported bimetallic systems, where two metals are codeposited onto high-surface area materials. We here report the use of colloidal bimetallic nanocrystals to produce catalysts where the active and promoter phases are colocalized to a fine extent. This strategy enables a systematic approach to study the promotional effects of several transition metals on palladium catalysts for methane oxidation. In order to achieve these goals, we demonstrate a single synthetic protocol to obtain uniform palladium-based bimetallic nanocrystals (PdM, M = V, Mn, Fe, Co, Ni, Zn, Sn, and potentially extendable to other metal combinations) with a wide variety of compositions and sizes based on high-temperature thermal decomposition of readily available precursors. Once the nanocrystals are supported onto oxide materials, thermal treatments in air cause segregation of the base metal oxide phase in close proximity to the Pd phase. We demonstrate that some metals (Fe, Co, and Sn) inhibit the sintering of the active Pd metal phase, while others (Ni and Zn) increase its intrinsic activity compared to a monometallic Pd catalyst. This procedure can be generalized to systematically investigate the promotional effects of metal and metal oxide phases for a variety of active metal-promoter combinations and catalytic reactions.

Download full-text PDF

Source
http://dx.doi.org/10.1021/jacs.7b06260DOI Listing

Publication Analysis

Top Keywords

bimetallic nanocrystals
12
methane oxidation
8
active promoter
8
promoter phases
8
promotional effects
8
metal oxide
8
active
5
metal
5
systematic identification
4
identification promoters
4

Similar Publications

Preparation of TiCTMXene-based copper/cobalt composites for electrocatalytic ammonia synthesis.

J Colloid Interface Sci

September 2025

School of Physics and Materials Science, Nanchang University, 999 Xuefu Road, Honggutan District, Nanchang, Jiangxi 330031, China; College of Chemical Engineering, Zhejiang University of Technology, Hangzhou 310014, PR China. Electronic address:

MXenes represent exceptionally promising electrocatalytic materials for ammonia synthesis, owing to their outstanding electrical conductivity, modifiable surface functional groups, exceptional hydrophilicity, high specific surface area, and electronegative surface characteristics. In this investigation, we systematically demonstrate that the persistent challenge of Cu and Co nanoparticle agglomeration can be effectively addressed through the in-situ growth of bimetallic CuCo nanoparticles on TiCTMXene nanosheets. This innovative approach significantly enlarges the electrochemically active surface area, maximizes the exposure of catalytically active sites, and optimizes mass transport properties, consequently leading to substantially enhanced electrocatalytic performance for ammonia synthesis.

View Article and Find Full Text PDF

The utilization of plant extracts in combination with various nanomaterials for treating polymicrobial wound infections represents a novel approach in overcoming the problem of antimicrobial resistance through its multi-targeted mechanism of action. The present study investigates the potential of plant extract for the green synthesis of AgZnO bimetallic nanoparticles (BMNPs). The nanoparticles obtained were characterized and the UV-Vis studies demonstrated peaks at 361 and 371 nm which were characteristic of silver and zinc oxide nanoparticles while a size range of 5-15 nm was revealed in the HR TEM studies, and the presence of crystalline ZnO and surface decorated Ag nanoparticles was observed in the diffraction patterns.

View Article and Find Full Text PDF

Polymer dielectrics have attracted substantial attention for their extensive applications in advanced electronic power systems. However, their practical implementation is substantially hindered by the drastic deterioration in breakdown strength and energy storage capabilities at elevated temperatures. Herein, corrugated alumina (AlO) nanosheets anchored with uniformly dispersed silver nanoparticles (AgNPs) are fabricated via a sequential bimetallic ion exchange method using polyimide (PI) film as the sacrificing template.

View Article and Find Full Text PDF

Benign prostatic hyperplasia (BPH) presents a significant clinical challenge, with conventional therapies carrying substantial risks, including urinary retention, sexual dysfunction, and prolonged recovery. To address the urgent need for safer, ultra-minimally invasive alternatives, we developed a sonosensitizing nanoplatform using copper-manganese-doped mesoporous silica nanoparticles (Cu-Mn@SiO) for ultrasound-induced sonodynamic therapy (SDT). Here, we demonstrate that this innovative strategy provides highly effective and precisely targeted therapy for BPH.

View Article and Find Full Text PDF

A dual-mode aptasensor was engineered for aflatoxin B (AFB) detection by functional integration of peroxidase-mimetic Au@CeO core-shell nanostructures with emissive carbon dots (CDs). The Au@CeO nanocomposite, synthesized via spontaneous redox reaction, exhibited enhanced peroxidase-like activity due to abundant Ce/oxygen vacancies facilitating hydroxyl radical generation. The aptasensor utilizes a competitive binding mechanism, where AFB competed with immobilized Au@CeO-CDs-Apt1 probes for binding sites, resulting in inversely proportional colorimetric and fluorescent signals.

View Article and Find Full Text PDF