98%
921
2 minutes
20
Azobenzene (Azo) photoswitches have attracted significant attention for developing smart photoresponsive materials owing to their reversible light-induced isomerization between and configurations. However, it is challenging to design an Azo capable of quantitative and efficient → photoisomerization under low-energy photon irradiation, particularly near-infrared (NIR) light above 800 nm. Here, we demonstrate that → photoswitching of Azo can be achieved under 808 nm light irradiation when PbS quantum dots (QDs) are combined with carboxylated Azo (Azo1). The unique spin-orbit coupling of PbS QDs facilitates efficient triplet energy transfer to -Azo1 under NIR light irradiation, thereby facilitating → photoswitching the excited triplet surface. Importantly, the broad absorption spectrum of PbS QDs enables activation of → photoisomerization using any desired wavelength across the visible and NIR spectra up to 900 nm. The photoswitching of Azo1 when combined with PbS QDs exhibits reversible photoisomerization and good fatigue resistance over alternating irradiation cycles of 365 nm and 808 nm light. Our strategy of combining Azo and QDs holds promise for advancing the development of high-performance NIR light-activated optoelectronic materials and devices.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC12337389 | PMC |
http://dx.doi.org/10.1039/d5sc03719k | DOI Listing |
Chem Sci
July 2025
State Key Laboratory of Precision Measurement Technology and Instruments, Key Laboratory of Opto-electronics Information Technology, School of Precision Instrument and Opto-Electronics Engineering, Tianjin University Tianjin 300072 China
Azobenzene (Azo) photoswitches have attracted significant attention for developing smart photoresponsive materials owing to their reversible light-induced isomerization between and configurations. However, it is challenging to design an Azo capable of quantitative and efficient → photoisomerization under low-energy photon irradiation, particularly near-infrared (NIR) light above 800 nm. Here, we demonstrate that → photoswitching of Azo can be achieved under 808 nm light irradiation when PbS quantum dots (QDs) are combined with carboxylated Azo (Azo1).
View Article and Find Full Text PDFWe investigated the laser power-dependent photoluminescence (PL) decay profiles of oleic-acid capped PbS quantum dots (QDs) in toluene, with a mean size of approximately 2.6 nm, under both long duration (LD) and short duration (SD) excitation pulse limits. The absorption cross-section (ACS) of PbS QDs was assessed and compared using two approaches: power-modulated PL kinetics and fitting of PL amplitude saturation curves.
View Article and Find Full Text PDFCopper ions () play critical roles in biological systems but induce toxicity at elevated concentrations. This study, to our knowledge, reports a novel ratio-metric fluorescence sensor based on near-infrared (NIR)-emissive PbS quantum dot (QD)-doped hydrogel fiber sensor for real-time, selective detection of . The sensor employs a biocompatible and mechanically flexible HF with a core-cladding structure to confine light within the core for efficient transmission.
View Article and Find Full Text PDFBiomedicines
July 2025
CIETI-LabRISE, ISEP, Polytechnic of Porto, Rua Dr. António Bernardino de Almeida 431, 4249-015 Porto, Portugal.
Carbohydrate antigen 19-9 (CA19-9) is a clinically established biomarker primarily used for monitoring disease progression and recurrence in pancreatic and gastrointestinal cancers. Accurate and continuous quantification of CA19-9 in patient samples is critical for effective clinical management. This study aimed to develop dual-emitting molecularly imprinted nanopolymers (dual@nanoMIPs) for ratiometric and reliable detection of CA19-9 in serum.
View Article and Find Full Text PDFNanomaterials (Basel)
July 2025
Advanced Mobility System Group, Korea Institute of Industrial Technology (KITECH), Daegu 42994, Republic of Korea.
Recently, with the development of automation technology in various fields, much research has been conducted on infrared photodetectors, which are the core technology of LiDAR sensors. However, most infrared photodetectors are expensive because they use compound semiconductors based on epitaxial processes, and they have low safety because they use the near-infrared (NIR) region that can damage the retina. Therefore, they are difficult to apply to automation technologies such as automobiles and factories where humans can be constantly exposed.
View Article and Find Full Text PDF