Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Optical resonators with high Q-factor are of interest in infrared thermal sensors for their high-temperature sensitivity. Thin-film lithium niobate (LN), with low propagation loss in near-infrared, is a competitive material for a comparative advantage in thermal-optic coefficient and wider absorption range from longwave infrared (LWIR) to terahertz frequencies if compared with SiN and SiO. Here, we present an LWIR sensor on the LN-photonic platform, where a high-Q microring resonator is monolithically integrated with a broadband LWIR radiation absorber, compatible with the multilayer-stacked LN photonic circuits. It is demonstrated that the radiation can induce a significant mode-frequency shift of near-infrared probe light on the thermal-optic effect, even if the device suffers from relatively high frequency noise. The noise equivalent temperature difference of the sensor is evaluated as 1.33 mK through a short-term frequency instability measurement. Under the radiation at a wavelength of = 9.1 µm, the device achieves a responsivity of 155.25 kHz/nW and a response time of 128 µs. The integrated device scheme on the LN-photonic platform holds great promise in developing a high-sensitivity infrared sensor, even to enable infrared imaging with a high signal-to-noise ratio.

Download full-text PDF

Source
http://dx.doi.org/10.1364/OE.546510DOI Listing

Publication Analysis

Top Keywords

lithium niobate
8
longwave infrared
8
ln-photonic platform
8
infrared
5
integrated high-q
4
high-q lithium
4
niobate resonator
4
resonator broadband
4
broadband absorber
4
absorber uncooled
4

Similar Publications

We report the results of an experimental study of the movement and trapping of Gram-negative Escherichia coli (E. coli) bacteria in broth suspensions, under photovoltaic fields generated by an optical Bessel beam illumination of the surface of a lithium niobate crystal (photovoltaic tweezers). The study was performed using a phase-sensitive transmission microscope.

View Article and Find Full Text PDF

High performance mode (de)multiplexer assisted with a microring resonator on the lithium niobate-on-insulator platform.

Nanophotonics

August 2025

Wangzhijiang Innovation Center for Laser, Aerospace Laser Technology and System Department, Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Shanghai, 201800, China.

The high extinction ratio mode (de)multiplexer is a pivotal component in high capacity mode-division multiplexing data communication and nascent on-chip intermodal acousto-optic modulators. Up to now, high performance on-chip mode (de)multiplexers are still lacking for integrated AOMs on the lithium niobate-on-insulator platform. In this paper, we propose and demonstrate an innovative scheme to achieve high extinction ratio signal routing for acousto-optic modulation, by leveraging a two-mode (de)multiplexer in conjunction with a high- racetrack microring resonator.

View Article and Find Full Text PDF

The surge in artificial intelligence applications calls for scalable, high-speed, and low-energy computation methods. Computing with photons is promising due to the intrinsic parallelism, high bandwidth, and low latency of photons. However, current photonic computing architectures are limited by the speed and energy consumption associated with electronic-to-optical data transfer, i.

View Article and Find Full Text PDF

Ultrabroadband on-chip photonics for full-spectrum wireless communications.

Nature

September 2025

State Key Laboratory of Photonics and Communications, School of Electronics, Peking University, Beijing, China.

The forthcoming sixth-generation and beyond wireless networks are poised to operate across an expansive frequency range-from microwave, millimetre wave to terahertz bands-to support ubiquitous connectivity in diverse application scenarios. This necessitates a one-size-fits-all hardware solution that can be adaptively reconfigured within this wide spectrum to support full-band coverage and dynamic spectrum management. However, existing electrical or photonic-assisted solutions face a lot of challenges in meeting this demand because of the limited bandwidths of the devices and the intrinsically rigid nature of system architectures.

View Article and Find Full Text PDF

Electro-optic modulators have become an essential component of communication and information infrastructure. However, challenges to stable DC operation result in a requirement for thermal biasing of modulators, which can require high powers and be prohibitive to the deployment of modulators for low-temperature applications. Here, we present stable DC operation of a thin-film lithium niobate modulator at liquid nitrogen accessible temperatures, providing a low-cost alternative to thermal tuning demands and demonstrating accessibility for low-temperature applications.

View Article and Find Full Text PDF