Nanomorphogenesis of interlayered polyamide membranes for precise ion sieving in lithium extraction.

Water Res

Research Center for Membrane and Film Technology, Kobe University, 1-1 Rokkodaicho, Nada, Kobe 657-8501, Japan; Department of Chemical Science and Engineering, Kobe University, 1-1 Rokkodaicho, Nada, Kobe 657-8501, Japan. Electronic address:

Published: April 2025


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Nanofiltration (NF) offers a scalable and energy-efficient method for lithium extraction from salt lakes. However, the selective separation of lithium from magnesium, particularly in brines with high magnesium concentrations, remains a significant challenge due to the close similarity in their hydrated ionic radii. The limited Li/Mgselectivity of current NF membranes is primarily attributed to insufficient control over pore size and surface charge. In this study, we report the development of an interlayered thin-film composite (iTFC) membrane incorporating functionalized sulfonated carrageenan to regulate the interfacial polymerization process. This integrated interlayer plays a crucial role in controlling the diffusion and spatial distribution of amine monomers, leading to the formation of dense, nano-striped polyamide networks. These structural improvements including refined pore size and reduced negative charge significantly enhanced Li/Mgselectivity (133.5) and increased permeance by 2.5 times compared to conventional TFC membranes. Additionally, the nano-striped structure optimized the membrane filtration area while minimizing ion transport resistance, effectively overcoming the traditional trade-off between ion selectivity and permeability. This study highlights the potential of iTFC membranes for achieving both high lithium purity and recovery, offering a promising avenue for large-scale lithium extraction from brines.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.watres.2024.123063DOI Listing

Publication Analysis

Top Keywords

lithium extraction
12
pore size
8
lithium
5
nanomorphogenesis interlayered
4
interlayered polyamide
4
membranes
4
polyamide membranes
4
membranes precise
4
precise ion
4
ion sieving
4

Similar Publications

Understanding the electrochemical extraction and deposition of lithium (Li) from cathode is crucial for advancing anode-free solid-state batteries (AFSSBs). Herein, cryo-transmission electron microscopy (cryo-TEM) and electrochemical studies are employed to investigate how current collector surface properties, current densities, and cathode loadings influence the morphology of fresh electrochemically deposited Li and the electrochemical performance in sulfide-based AFSSBs. Cryo-TEM reveals that Cu current collectors induce irregular, dendritic Li deposits due to their lithiophobic nature and reactivity with LiPSCl (LPSC), while Ni and Au facilitate more uniform, planar-like Li growth.

View Article and Find Full Text PDF

High-nickel layered oxide LiNiCoMnO (NCM, ≥ 0.8) materials are considered optimal cathodes for lithium-ion power batteries owing to their high energy density, commendable cycling performance, and cost-effectiveness. However, structural collapse and interface instability during cycling result in diminished cycling stability, significantly hindering their commercial viability.

View Article and Find Full Text PDF

Owing to the crucial role in energy transformation for decarbonization, sustainable lithium (Li) supply has become growingly critical. Low-quality brines hold vast potential due to infinite reserves and diverse distribution but desire green and cost-effective extraction techniques against low Li concentrations and high magnesium-to-lithium ratios. Solar-driven direct lithium extraction (SDLE) systems combining conventional evaporation and DLE techniques can overcome the present challenges of Li extraction, promising to advance the exploitation of low-quality brines while simultaneously producing fresh water.

View Article and Find Full Text PDF

Evaporation-Driven Fabric for Synergistic Water-Electricity-Lithium Co-Production.

Adv Mater

September 2025

State Key Laboratory for Advanced Fiber Materials, College of Materials Science and Engineering, Donghua University, Shanghai, 201620, P. R. China.

Water evaporation constitutes a ubiquitous physical phenomenon. This natural process enables efficient energy and resource harvesting through water interacting with materials with tailored structural, chemical, and thermal properties. Here, this work designs an evaporation-driven fabric (e-fabric) that enables the utilization of water-electricity-lithium from brine through three optimized functional layers.

View Article and Find Full Text PDF

Construction of hierarchical structured dual-shell hollow polyhedra NiCoO based on TiCT for advanced lithium-ion and sodium-ion capacitors.

J Colloid Interface Sci

August 2025

School of Material Science and Engineering, School of Conservation Science & Technology for Cultural Heritage, Shaanxi University of Science and Technology, Xi'an 710021, PR China; Key Laboratory of Materials and Technology for Unearthed Cultural Heritage Conservation, Ministry of Education, Xi'an 7

The development of lithium/sodium ion hybrid capacitors has been constrained by the dynamic disparity between the anode and cathode, in conjunction with the volume expansion of the anode material during the cycling phase. In this study, a dual-shell dodecahedral structure NiCoO composite was fabricated by combining it with hydrofluoric acid-etched TiCT lamellar material. The NiCoO dual-shell dodecahedron structure manifests a substantial specific surface area and more active sites.

View Article and Find Full Text PDF