Turning trash into treasure: Torrefaction of mixed waste for improved fuel properties. A case study of metropolitan city.

Heliyon

Centre for Technology in Water and Wastewater, School of Civil and Environmental Engineering, Faculty of Engineering and Information Technology, University of Technology Sydney, NSW, 2007, Australia.

Published: April 2024


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Solid waste management is one of the biggest challenges of the current era. The combustible fractions in the waste stream turn out to be a good energy source if converted into refuse-derived fuel. Researchers worldwide are successfully converting it into fuel. However, certain challenges are associated with its application in gasifiers, boilers, etc. to co-fire it with coal. These include high moisture content, low calorific value, and difficulty to transport and store. The present study proposed torrefaction as a pretreatment of the waste by heating it in the range of 200 °C-300 °C in the absence of oxygen at atmospheric pressure. The combustible fraction from the waste stream consisting of wood, textile, paper, carton, and plastics termed as mixed waste was collected and torrefied at 225 °C, 250 °C, 275 °C, and 300 °C for 15 and 30 min each. It was observed that the mass yield and energy yield decreased to 45% and 62.96% respectively, but the energy yield tended to increase by the ratio of 1.39. Proximate analysis showed that the moisture content and volatile matter decreased for torrefied samples, whereas the ash content and fixed carbon content increased. Similarly, the elemental analysis revealed that the carbon content increased around 23% compared to raw samples with torrefaction contrary to hydrogen and oxygen, which decreased. Moreover, the higher heating value (HHV) of the torrefied samples increased around 1.3 times as compared to the raw sample. This pretreatment can serve as an effective solution to the current challenges and enhance refuse-derived fuel's fuel properties.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11021893PMC
http://dx.doi.org/10.1016/j.heliyon.2024.e28980DOI Listing

Publication Analysis

Top Keywords

mixed waste
8
fuel properties
8
waste stream
8
moisture content
8
energy yield
8
torrefied samples
8
carbon content
8
content increased
8
compared raw
8
waste
6

Similar Publications

This study examines the flue gas emissions originated from various fuel types used in the textile industries of Faisalabad, Pakistan, and their compliance with the Punjab Environmental Quality Standards (PEQS), Pakistan. Data from 109 textile factories revealed significant emission variations based on fuel types. Natural gas was identified as an eco-friendly fuel, with emissions far below the PEQS limits (CO: 334.

View Article and Find Full Text PDF

In this study, a silicon carbide (SiC) mixed-matrix membrane for oil-water separation was successfully fabricated within the nanofiltration range. Silicon carbide was synthesized using rice husk ash (RHA), an agricultural waste material, combined with polydimethylsiloxane (PDMS) and subsequently incorporated into a mixed matrix membrane for oil-water separation. Polysulfone (PSF) and polyvinylpyrrolidone (PVP) were employed as polymer supports for fabricating the SiC-based mixed matrix membrane, which was tested in a dead-end filtration setup.

View Article and Find Full Text PDF

Background: The US healthcare system is currently facing significant challenges in quality, affordability, and labor shortages. Artificial intelligence (AI) promises to transform healthcare delivery by making it safer, more effective, less wasteful, and more patient-centered. With more than $30 billion invested in healthcare AI companies in the past three years, the proliferation of AI solutions is expected to bring much-needed relief to the strained healthcare industry.

View Article and Find Full Text PDF

Stabilization of clay soils exposed to freeze-thaw conditions with waste Kevlar.

PLoS One

September 2025

Technical Vocational School of Higher Education, Ataturk University, Erzurum, Türkiye.

In recent years, the use of waste materials for soil stabilization has gained attention due to their environmental and economic advantages. Kevlar, a synthetic, high-strength fiber commonly used in telecommunications, becomes a significant source of industrial waste at the end of its service life. In this study, the potential utilization of waste Kevlar material for improving clay soils against freeze-thaw effects was investigated using computed tomography (CT) and scanning electron microscopy (SEM) imaging techniques.

View Article and Find Full Text PDF

Phosphogypsum is an acidic solid waste mainly composed of CaSO₄-2H₂O by-products of the wet process phosphoric acid industry, which has the characteristics of high impurity content, poor stability of stockpiling, but can be utilized in a resourceful way. Phosphogypsum waste utilization can reduce environmental pollution, save resources and create economic value. In order to investigate the fatigue characteristics and the mechanism of dynamic strength change of cement-phosphogypsum-red clay under wet and dry cycles, the cumulative deformation characteristics and the rule of change of critical dynamic stress of the mixed materials were investigated by dynamic triaxial fatigue test, SEM and XRD test, and the mechanism of dynamic strength change was analyzed according to the microstructure and the chemical mineral composition of the mixed materials.

View Article and Find Full Text PDF