98%
921
2 minutes
20
Background: There are uncertainties whether the impairment of lung diffusing capacity in COVID-19 is due to an alteration in the diffusive conductance of the alveolar membrane (Dm), or an alteration of the alveolar capillary volume (Vc), or a combination of both. The combined measurement DLNO and DLCO diffusion, owing to NO higher affinity and faster reaction rate with haemoglobin compared to CO, enables the simultaneous and rapid determination of both Vc and Dm. The aim of the present study was to better identify the precise cause of post-COVID-19 diffusion impairment.
Methods: Using the combined NO and CO gas transfer techniques (DLNO and DLCO), it is possible to better understand whether gas exchange abnormalities are due to membrane or alveolar capillary volume components. The present study was aimed at evaluating pulmonary gas exchange one year after severe COVID-19. Results: The cohort included 33 survivors to severe COVID-19 (median age 67 years, 70% male) with no pre-existing lung disease, who underwent clinical, lung function and imaging assessments at 12 months due to persistence of respiratory symptoms or radiological impairment. The gas exchange abnormalities were mainly determined by the compromise of the vascular component as demonstrated by vascular pattern of gas exchange impairment (i.e., DLNO/DLCO≥110%, 76% of the sample), and by a reduction of the Vc (73%), while the Dm was reduced only in 9% of the entire sample. We did not find a correlation between the gas exchange impairment and the extent of the chest CT alterations (DLCO p = 0.059 and DLNO p = 0.054), which on average were found to be mild (11% of the parenchyma).
Conclusion: In COVID-19 survivors who are still symptomatic or have minimal CT findings at one year, gas exchange abnormalities are determined by impairment of the vascular component, rather than the diffusive component of the alveolar membrane.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10968839 | PMC |
http://dx.doi.org/10.5826/mrm.2024.938 | DOI Listing |
Vet Anaesth Analg
July 2025
Department of Clinical Sciences, College of Veterinary Medicine, Cornell University, Ithaca, NY, USA.
Objective: To determine the use of Air-Test in ventilated, anaesthetized dogs for evaluating oxygen uptake and to determine its potential utility in guiding the decision to perform an alveolar recruitment manoeuvre (ARM).
Study Design: Retrospective cohort study.
Animals: A total of 25 client-owned dogs undergoing general anaesthesia.
Proc Biol Sci
September 2025
Division of Integrative Anatomical Sciences, University of Southern California Keck School of Medicine, Los Angeles, CA, USA.
Red blood cell (RBC) size constrains the rate of diffusion of gases between (i) the environment and the capillary beds of the gas exchanger and (ii) the blood and organs. In birds, small RBCs with a high surface area to volume ratio permit a high O diffusion capacity and facilitate sustained, vigorous exercise. Unfortunately, our knowledge of archosaur cardiovascular evolution is incomplete without fossilized RBCs and blood vessels.
View Article and Find Full Text PDFJ Colloid Interface Sci
September 2025
State Key Laboratory of Heavy Oil Processing, College of Chemistry and Chemical Engineering, China University of Petroleum (East China), Qingdao 266580, China.
Reaction intermediates (RI) are key factors that directly determine the efficiency of the oxygen evolution reaction (OER) and hydrogen evolution reaction (HER). In this study, a local electric field microenvironment was built in a FeNi and MoNi heterostructure (H-FeNiMo/NMF) to induce the redistribution of hydroxyls and protons on the metal sites during the OER and HER. H-FeNiMo/NMF requires only 270 and 155 mV to reach 100 mA cm in alkaline media for OER and HER, respectively.
View Article and Find Full Text PDFACS Appl Mater Interfaces
September 2025
The Steve Sanghi College of Engineering, Mechanical Engineering, Northern Arizona University, Flagstaff, Arizona 86011, United States.
This study investigates the HO and CO sorption behavior of two chemically distinct polystyrene-divinylbenzene-based ion exchange sorbents: a primary amine and a permanently charged strong base quaternary ammonium (QA) group with (bi)carbonate counter anions. We compare their distinct interactions with HO and CO through simultaneous thermal gravimetric, calorimetric, gas analysis, and molecular modeling approaches to evaluate their performance for dilute CO separations like direct air capture. Thermal and hybrid (heat + low-temperature hydration) desorption experiments demonstrate that the QA-based sorbent binds both water and CO more strongly than the amine counterparts but undergoes degradation at moderate temperatures, limiting its compatibility with thermal swing regeneration.
View Article and Find Full Text PDFNanomicro Lett
September 2025
Department of Mechanical, Aerospace & Biomedical Engineering, University of Tennessee, Knoxville, Knoxville, TN, 37996, USA.
3D printing, as a versatile additive manufacturing technique, offers high design flexibility, rapid prototyping, minimal material waste, and the capability to fabricate complex, customized geometries. These attributes make it particularly well-suited for low-temperature hydrogen electrochemical conversion devices-specifically, proton exchange membrane fuel cells, proton exchange membrane electrolyzer cells, anion exchange membrane electrolyzer cells, and alkaline electrolyzers-which demand finely structured components such as catalyst layers, gas diffusion layers, electrodes, porous transport layers, and bipolar plates. This review provides a focused and critical summary of the current progress in applying 3D printing technologies to these key components.
View Article and Find Full Text PDF