Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

In this study, the tensile creep (TC) of high-strength concrete (HSC) containing 30 wt% fly ash was measured at early ages to investigate the applicability of creep prediction models for concrete containing FA, and to provide ideas to study the prediction model of concrete creep containing other SCMs in the future. The TC values obtained from the experiment were compared with the predicted values of six TC models. Then the accuracy of different models was evaluated by the ratio of predicted values to experimental values. Finally, the applicability of these models to the TC of HSC with fly ash was discussed at an early age. By comparison, it was found that when the loading age was 1d, 2d, and 3d, the ZC model (ZC are the initials for the word "Self-developed" in Chinese), which is a rheology-based model for TC, proposed by Yang.Y et al. agreed with the experimental values. The predicted values of the other five models deviated significantly from the tested ones. When the loading age was 5d and 7d, the calculated results of the ACI 2009R model were more accurate. Compared with the other five models, the time dependency of the paste with fly ash was considered in the ZC model, and parameter of the ZC model was introduced in order to characterize the influence of fly ash on the paste at early ages. Therefore, this paper demonstrated both theoretically and experimentally that the ZC model can better predict the early-age TC of HSC with fly ash.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9960628PMC
http://dx.doi.org/10.3390/ma16041337DOI Listing

Publication Analysis

Top Keywords

fly ash
24
early ages
12
predicted values
12
influence fly
8
tensile creep
8
creep prediction
8
high-strength concrete
8
values models
8
experimental values
8
hsc fly
8

Similar Publications

The pyrolysis of flue-cured tobacco stalks (TS) faces challenges such as low bio-oil value and utilization efficiency. Existing studies have overlooked the anatomical heterogeneity of tobacco stalks, thereby limiting the directional regulation of high-value components, such as nicotine and phenolic compounds. This study divides TS into the husk (TSH), xylem (TSX), and pith (TSP), and investigates their physicochemical properties, pyrolysis behavior (through TGA and fixed-bed pyrolysis experiments), and interactions.

View Article and Find Full Text PDF

Zeolite synthesis from fly ash offers recycling and environmental benefits for carbon dioxide capture, but varying fly ash composition from different sources has different compositions, leading to inconsistent adsorption results. To achieve high CO adsorption performance and stability in zeolite synthesis from fly ash systems, this study established an element-controlled simulated fly ash system with Ca/Fe gradient differences. Hydrothermal synthesis yielded zeolites with optimized oxide ratios for CO adsorption.

View Article and Find Full Text PDF

Pollution from past industrial activities can remain unnoticed for years or even decades because the pollutant has only recently gained attention or been identified by measurements. Modeling the emission history of pollution is essential for estimating population exposure and apportioning potential liability among stakeholders. This paper proposes a novel approach for reconstructing the history of polychlorinated dibenzo-p-dioxin (PCDD) and polychlorinated dibenzofuran (PCDF) pollution from municipal solid waste incinerators (MSWIs) with unknown past emissions.

View Article and Find Full Text PDF

Performance assessment of reclaimed fly ash-slag geopolymers incorporating waste spent garnet and waste foundry sand under different curing regimes.

Environ Res

September 2025

Materials Science, Engineering, and Commercialization (MSEC) Program, Texas State University, San Marcos, TX-78666, USA; Department of Engineering Technology, Texas State University, San Marcos, TX-78666, USA.

Fly ash (FA) landfills are overflowing with materials, and unexplored waste streams like waste spent garnet (WSG) and waste foundry sand (WFS) are often dumped in onsite storage spaces, limiting land availability for future use and exacerbating environmental concerns related to waste disposal. Therefore, this research proposes recycling FA to produce reclaimed FA (RFA) as a binder, replacing 40-60% of ground granulated blast furnace slag (GGBFS) and 30-50% of river sand (RS) with WSG and WFS to produce geopolymers. The performance of geopolymers was assessed under different curing regimes, including ambient-temperature curing (ATC), ambient-temperature water curing (AWC), high-temperature curing (HTC), and high-temperature water curing (HWC).

View Article and Find Full Text PDF

The disposal of municipal solid waste incineration fly ashes (MSWI-FA) is complicated by soluble chlorides, which increase the risk of heavy metals (HMs) leaching toxicity and hinder the further use of remediated MSWI-FA. In this study, the self-assembly potentiality of magnesium oxychloride cement (MOC) in geopolymerization was explored and utilized to enhance the solidification/stabilization (S/S) of the MSWI-FA. The MOC-self-assembled geopolymerization kinetics can be suitably described by the JMAK model.

View Article and Find Full Text PDF