Investigations on the influence of energy source on time-dependent hormesis: A case study of sulfadoxine to Aliivibrio fischeri in different cultivation systems.

Sci Total Environ

State Key Laboratory of Pollution Control and Resource Reuse, College of Environmental Science and Engineering, Tongji University, Shanghai 200092, China; Shanghai Key Lab of Chemical Assessment and Sustainability, Shanghai, China; Post-doctoral Research Station, College of Civil Engineering, Tongji

Published: June 2021


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Hormesis is a biphasic dose-response relationship featured by low-dose stimulation and high-dose inhibition. Although the hormetic phenomenon has been extensively studied over the past decades, there is little information regarding the influence of energy source on the occurrence of hormesis, especially the time-dependent one. In this study, to explore the role of cultivation system's energy source in time-dependent hormesis, the toxic dose-responses of Aliivibrio fischeri (A. fischeri) bioluminescence to Sulfadoxine (SDX) during 24 h were determined in four cultivation systems with different energy source conditions. The results indicated that the time-dependent hormetic effects were induced by SDX in all cultivation systems: SDX triggered hormetic phenomenon on the bioluminescence at each growth stage over 24 h in the cultivation systems with sufficient and insufficient energy source; due to the diauxic growth of A. fischeri under multiple energy source conditions, the hormetic effects of SDX gradually disappeared after the preferred energy source was used up. It was speculated that the inhibitory action of SDX was derived from its interaction with DHPS to impede the synthesis of proteins, and SDX bound with AC to upregulate the quorum sensing (QS) system to exhibit the stimulatory action. Comparing the time-dependent hormesis in each cultivation system, it was obtained that the energy source could impact the hourly maximum stimulatory rate, the EC of SDX, and the time point that hormesis occurred, which might result from the influence of energy source on the stimulatory and inhibitory actions of SDX through regulating the metabolic system (individual level) and QS system (group level) of bacteria. This study clarifies the importance of energy source for hormesis occurrence, which may further promote the development of hormesis.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.scitotenv.2021.145877DOI Listing

Publication Analysis

Top Keywords

energy source
40
cultivation systems
16
influence energy
12
time-dependent hormesis
12
energy
10
source
10
source time-dependent
8
hormesis
8
aliivibrio fischeri
8
hormetic phenomenon
8

Similar Publications

Observing differential spin currents by resonant inelastic X-ray scattering.

Nature

September 2025

National Synchrotron Light Source II, Brookhaven National Laboratory, Upton, NY, USA.

Controlling spin currents, that is, the flow of spin angular momentum, in small magnetic devices, is the principal objective of spin electronics, a main contender for future energy-efficient information technologies. A pure spin current has never been measured directly because the associated electric stray fields and/or shifts in the non-equilibrium spin-dependent distribution functions are too small for conventional experimental detection methods optimized for charge transport. Here we report that resonant inelastic X-ray scattering (RIXS) can bridge this gap by measuring the spin current carried by magnons-the quanta of the spin wave excitations of the magnetic order-in the presence of temperature gradients across a magnetic insulator.

View Article and Find Full Text PDF

Temporal lobe epilepsy (TLE) patients experience shifts between non-seizing and seizing brain states, but the structural networks underlying these transitions remain undefined and poorly characterized. We detected dynamic brain states in resting-state fMRI and constructed linked structural networks utilizing multi-shell diffusion-weighted MR data. Leveraging network control theory, we interrogated the structural data for all possible brain state transitions, identifying those requiring abnormal levels of transition energy (low or high) in TLE compared to matched healthy participants (n's = 25).

View Article and Find Full Text PDF

A series of Ni-MOF materials were synthesized by a one-step solvothermal method under different reaction conditions, including metal source, organic ligand, reaction time and reaction temperature. The results demonstrated that the Ni-MOFs synthesized with Ni(NO3)2•6H2O as the metal source had higher crystallinity and a more uniform crystalline structure than those with NiCl2•6H2O. Different organic ligands led to the formation of Ni-MOFs in various morphologies.

View Article and Find Full Text PDF

Carbon-negative wastewater treatment via CO-to-acetate microbial electrosynthesis coupled with biological nitrogen removal.

Water Res

September 2025

College of Chemical and Biological Engineering, Key Laboratory of Biomass Chemical Engineering of Ministry of Education, Zhejiang University, Hangzhou 310027, China; Institute of Zhejiang University - Quzhou, Quzhou 324000, China. Electronic address:

This study presents a renewable electricity-driven microbial electrosynthesis (MES) system integrated with biological nitrogen removal (BNR) to achieve carbon-negative wastewater treatment. The MES system converts CO₂ into acetate, which is directly utilized as an internal carbon source for denitrification. Incorporation of biochar-derived conductive materials enhanced electron transfer, increasing acetate productivity to 1.

View Article and Find Full Text PDF

This study investigated the pyrolysis of mixed medical waste (MMW) in an indirectly heated rotary kiln, focusing on the effects of operating parameters (filling ratio, heat source temperature, and rotation speed) on the heat transfer performance and product distribution. The pyrolysis behaviors of individual components (cotton swabs, paper, bandages, and plastics) and their composite mixtures were characterized using thermogravimetric-differential thermal analysis (TG-DTA). The heat transfer characteristics, chemical reaction properties, kiln operating parameters, and interactions between the processes were also investigated.

View Article and Find Full Text PDF