Category Ranking
98%
Total Visits
921
Avg Visit Duration
2 minutes
Citations
20
Article Abstract
A high-power and high-efficiency diode-end-pumped Tm:YLF laser at 1.83 μm is demonstrated for the first time, to our best knowledge. To make the laser operate at 1.83 μm, a simple way of controlling the transmittance of the output coupler is used, and the criteria of the transmittance of the output coupler at the emission peaks of Tm:YLF are theoretically analyzed, which are verified by experimental results. Based on the theoretical analysis, laser oscillation at only 1.83 μm is realized. Maximum output power at 1833 nm is 8.5 W with corresponding slope efficiency of 53.4% regarding absorbed pump power. In addition, tunability of this laser from 1827 nm to 1837 nm is obtained. Laser beam quality at 1833 nm is measured to be 1.4 at maximum output power. The achieved laser performance represents considerable improvement compared to any other bulk laser emitting around 1.83 μm.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/OL.44.004403 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Comprehensive Analysis for Low-Cost and Highly Efficient Perovskite Solar Cells Using SCAPS-1D with an Inexpensive Hole Transport Material, Electron Transport Material, and Back Contact Considering the Toxicity.
ACS Omega
September 2025
Dept. of Electrical and Electronic Engineering, Noakhali Science and Technology University, Noakhali 3814, Bangladesh.
Perovskite solar cells (PSCs) are rapidly advancing due to their high power conversion efficiencies (PCEs) and low fabrication costs. However, their commercialization is hindered by lead toxicity and the use of expensive materials, such as Spiro-OMeTAD and gold electrodes. This study presents a comprehensive SCAPS-1D simulation-based analysis of 14 perovskite absorber materials, spanning both Pb-based and lead-free compounds, under a unified device architecture using low-cost, nontoxic components: ZnO as the electron transport material (ETM), PEDOT:PSS + WO as a dual hole transport material, and nickel as the back contact.
View Article and Find Full Text PDFResearch on time-frequency multi-scale characteristics of high-power giant magnetostrictive underwater transducers considering hysteresis nonlinearity.
J Acoust Soc Am
September 2025
State Key Laboratory of High-Efficiency and High-Quality Conversion for Electric Power, Hunan University, Changsha 410082, China.
High-power giant magnetostrictive underwater transducers are integral to underwater active sonar detection systems due to their high energy density, rapid dynamic response, and significant output force. However, these transducers exhibit complex nonlinear dynamic hysteresis behavior, which is influenced by the coupling of electric, magnetic, mechanical, and acoustic fields. This complexity presents considerable challenges in accurately characterizing their output properties.
View Article and Find Full Text PDFPower-efficiency trade-off for the finite-time quantum harmonic Otto heat engine via a phase-space approach.
Phys Rev E
July 2025
Asia Pacific Center for Theoretical Physics, Pohang 37673, Republic of Korea.
Thermodynamic constraints impose a trade-off between power and efficiency in heat engines, preventing the simultaneous achievement of high power and high efficiency. For classical microscopic engines, explicit inequalities have been discovered, demonstrating the inherent inevitability of this power-efficiency trade-off. However, extensions of these results to quantum engines have so far been limited to cases of slow operation.
View Article and Find Full Text PDFElectrochemically Modified Interface Promoting the Oxygen-Electrocatalytic Kinetics in Near-Neutral Zinc-Air Batteries.
Small
August 2025
Department of Chemical Engineering, National Tsing Hua University, Hsinchu, 300044, Taiwan.
The development of near-neutral zinc-air batteries (ZABs) has been hindered by the sluggish oxygen reaction kinetics, severely limiting energy efficiency and power output. While recent advances in catalyst design have improved the intrinsic activity of electrocatalysts, their overall impact on battery performance remains limited. Here, an electrochemical modification strategy is presented that simultaneously enhances the surface properties of both the gas diffusion layer (GDL) and the bifunctional catalyst.
View Article and Find Full Text PDFEfficient 2.8-µm Er-doped all-fiber laser based on a low optical feedback cavity.
Opt Express
February 2025
Mid-infrared (mid-IR) fiber lasers have faced significant challenges in achieving all-fiberized structure with high efficiency and high output power due to the limitations of conventional cavity designs. In this paper, we introduce what we believe to be a novel 2.8 µm all-fiber laser configuration with a low optical feedback linear cavity, effectively eliminating the need for traditional high-reflector components.
View Article and Find Full Text PDF