Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Although biochar and conventional organic materials have been widely studied for lowering cadmium (Cd) uptake by plants but information regarding their comparative effectiveness is lacking. In this study, biochars from different feedstocks viz. rice husk biochar (RHB), cotton sticks biochar (CSB) and wheat straw biochar (WSB) were compared with conventional organic materials viz. farm manure (FM), poultry manure (PM) and press mud (PrMd) for their effectiveness to promote plant growth and to reduce Cd uptake by wheat and rice plants grown rotationally in a Cd-spiked (50 mg kg) soil. Each amendment was applied at the rate of 2% (w/w) in three replicates. Results showed that the application of amendments improved the soil properties and plant growth, by retaining Cd in the soil and restricting its uptake by plants. The amendments decreased the ammonium bicarbonate diethylene penta acetic acid extractable soil Cd, and improved soil organic carbon (SOC) and cation exchange capacity (CEC) as compared to only Cd-contaminated soil. The highest SOC content of 2.68 and 1.68% and CEC of 8.77 and 9.39 cmol kg were found in RHB treated post-wheat and post-rice soil, respectively. Amendments treated soil showed lower concentrations of bioavailable Cd and the maximum reduction was recorded in RHB and PrMd amended soil. Similarly, bioaccumulation of Cd was decreased with the application of all amendments; the maximum decrease was recorded in RHB and PrMd treated soil. Our results suggested that RHB and PrMd could be used for reducing the bioaccumulation of Cd in cereal grains in alkaline soils.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.chemosphere.2019.04.041DOI Listing

Publication Analysis

Top Keywords

conventional organic
12
organic materials
12
rhb prmd
12
soil
10
comparative effectiveness
8
uptake plants
8
plant growth
8
application amendments
8
improved soil
8
treated soil
8

Similar Publications

The construction of strong metal-support interactions (SMSI) is an effective strategy to enhance and control heterogeneous catalysts. However, conventional methods require pre-synthesized metal-loaded catalysts, followed by SMSI formation via high-temperature treatment under oxidative/reductive atmospheres, adsorbate-mediated treatment, and photo-treatment, adding complexity to catalyst synthesis and hindering continuous interfacial tuning. In this work, a "photobreeding" method is employed to treat ZnCdS, leveraging the UV-induced photochromic reaction of ZnS to generate metallic Zn at room temperature, while CdS remains inert.

View Article and Find Full Text PDF

Re-entrant phase behaviour of organic semiconductors.

Nat Mater

September 2025

Department of Physics and Organic and Carbon Electronics Laboratories (ORaCEL), North Carolina State University, Raleigh, NC, USA.

The number of polymeric and small-molecular acceptors for organic photovoltaics has exploded in the past decade. As a result, physical insights and efforts aiming at elucidating the coupling between composition and behaviour are required more than ever. Here we present an encompassing study into the phase behaviour of 55 polymer:small-molecular acceptor blends, pivotal in determining device performance and stability.

View Article and Find Full Text PDF

Microfluidic paper-based analytical devices for food spoilage detection: emerging trends and future directions.

Talanta

September 2025

Faculty of Applied Sciences, Ton Duc Thang University, Ho Chi Minh City, Viet Nam. Electronic address:

Food spoilage poses a global challenge with far-reaching consequences for public health, economic stability, and environmental sustainability. Conventional analytical methods for spoilage detection though accurate are often cost-prohibitive, labor-intensive, and unsuitable for real-time or field-based monitoring. Microfluidic paper-based analytical devices (μPADs) have emerged as a transformative technology offering rapid, portable, and cost-effective solutions for food quality assessment.

View Article and Find Full Text PDF

LiNiMnO (LNMO) is a promising material for the cathode of lithium-ion batteries (LiBs); however, its high operating voltage causes stability issues when used with carbonate battery electrolytes. Ionic liquids are a viable alternative to conventional carbonate solvents due to their thermal stability and electrochemical window. This work reports the performance of LNMO/Li half cells with an ionic liquid electrolyte (ILE) composed of 0.

View Article and Find Full Text PDF

In this study, a one-pot hydrothermal synthesis method was used to synthesize a novel gold-yttrium trimesic acid metal-organic framework (Au-Y-TMA MOF), demonstrating significant improvements over conventional single-metal MOFs, that is, yttrium trimesic acid (Y-TMA), in both supercapacitor applications and electrochemical antibiotic detection. The X-ray diffraction patterns of Au-Y-TMA confirmed the presence and impact of Au in the Y-TMA matrix, while field emission scanning electron microscopy (FE-SEM) images revealed a heterogeneous combination of gold nanoparticles (AuNPs) and Y-TMA, suggesting a nonuniform distribution and possible interaction. The developed half-cell supercapacitor exhibited a remarkable capacitance value of 1836 F/g at a current density of 5 A/g by galvanostatic charging-discharging (GCD) measurement.

View Article and Find Full Text PDF