98%
921
2 minutes
20
Reduced graphene oxide (RGO) and RGO modified by ozone (RGO-O) and fluorine (RGO-F) were synthesized. Pt nanoparticles were deposited on these materials and also on Vulcan XC-72 using the polyol method. The structural and electrochemical properties of the obtained catalysts were investigated in a model glass three-electrode electrochemical cell and in a laboratory PEM fuel cell. Among the RGO-based catalysts, the highest electrochemically active surface area (EASA) was obtained for the oxidized RGO supported catalyst. The EASA of the fluorine-modified RGO-supported catalyst was half as big. In the PEM fuel cell the performance of RGO-based catalysts did not exceed the activity of Vulcan XC-72-based catalysts. However, the addition of an RGO-O-based catalyst to Vulcan XC-72-based catalyst (in contrast to the RGO-F-based catalyst) allowed us to increase the catalyst layer activity and PEM fuel cell performance. Possible reasons for such an effect are discussed.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6119945 | PMC |
http://dx.doi.org/10.3390/ma11081405 | DOI Listing |
ACS Appl Mater Interfaces
September 2025
Department of Chemical Engineering, India Institute of Technology Guwahati, Guwahati, Assam 781039, India.
This study reports the preparation of MIL-100(Fe)-GO composites by a one-pot synthesis approach at room temperature, assisted by ultrasonication. The synthesized MIL-100(Fe)-GO composites were utilized as a filler for the preparation of a sulfonated polyether ether ketone (SPEEK)-based proton exchange membrane (PEM). The in situ development of MIL-100(Fe) on GO creates a strong interaction between GO and MIL-100(Fe), which enhances the surface roughness (confirmed from the AFM study) of the SPEEK membrane with its incorporation as a filler.
View Article and Find Full Text PDFChem Soc Rev
September 2025
Beijing Key Laboratory of Photoelectronic/Electrophotonic Conversion Materials, Key Laboratory of Cluster Science, Ministry of Education, Advanced Technology Research Institute (Jinan), Frontiers Science Center for High Energy Material, School of Chemistry and Chemical Engineering, Beijing Institute
Proton exchange membrane fuel cells (PEMFCs) represent a promising clean and efficient energy conversion technology. Enhancing the efficiency of the oxygen reduction reaction (ORR) at the cathode is crucial for improving overall cell performance. Beyond the intrinsic activity of the catalyst, mass transport at the oxygen-water-catalyst three-phase boundary (TPB) in the catalyst layers (CLs) significantly influences ORR kinetics.
View Article and Find Full Text PDFAdv Mater
August 2025
Institute of Energy Materials Science, University of Shanghai for Science and Technology, Shanghai, 200093, China.
Proton exchange membrane (PEM) water electrolyzers and fuel cells are pivotal for renewable hydrogen technologies. The membrane electrode assembly (MEA) is a critical component in both technologies, with the PEM's core functionality-proton conduction coupled with gas impermeability-dictating overall cell performance and durability. One of the key challenges faced by the commercial perfluorosulfonic acid (PFSA)-based PEMs is the high rate of hydrogen permeation, reducing efficiency and raising safety concerns due to hydrogen-oxygen mixing risks.
View Article and Find Full Text PDFWaste Manag Res
August 2025
School of Chemical Engineering, University of Birmingham, Birmingham, UK.
Considering the widespread use of proton exchange membrane (PEM) fuel cells, end-of-life management is critical. The main component of PEM fuel cells is the membrane electrode assembly (MEA), comprising a Nafion membrane sandwiched between two electrodes. The electrodes are made of platinum supported on carbon (Pt/C) and held together by the Nafion binder.
View Article and Find Full Text PDFACS Omega
August 2025
Department of Mechanical Engineering, Oakland University, Rochester Hills, Michigan 48309, United States.
A PEM fuel cell is an electrochemical system dependent on multiple variables such as temperature, voltage, current, pressure, volume, and chemical potential. Thermodynamically, parts of this system are seen through simpler mechanical equations of state developed for subsets of the more complex system (a simple compressible substance, for instance), providing a piecewise understanding of the whole. In this research, a method using equations of state with three variables is proposed to arrive at the thermodynamic relationships in a more comprehensive way.
View Article and Find Full Text PDF