Defect-selective-etched porous GaN as a buffer layer for high efficiency InGaN/GaN light-emitting diodes.

Substrate-induced biaxial compressive stress and threading dislocations (TDs) have been recognized to severely impair the performance, stability, and reliability of InGaN/GaN light-emitting diodes (LEDs) for quite some time. In this study, a defect-selective-etched (DSE) porous GaN layer is fabricated employing electro-chemical etching and applied as a buffer layer for the development of InGaN/GaN LEDs with high quantum efficiency. Based on the analysis of photoluminescence and micro-Raman spectra, it has been revealed that the overgrown GaN epilayer on the DSE porous GaN has a relatively low TDs and relaxation of compressive stress in comparison to the conventional GaN epilayer.

Two-Dimensional Stacked Composites of Self-Assembled Alkane Layers and Graphene for Transparent Gas Barrier Films with Low Permeability.

Self-assembled alkane layers are introduced between graphene layers to physically block nanometer size defects in graphene and lateral gas pathways between graphene layers. A well-defined hexatriacontane (HTC) monolayer on graphene could cover nanometer-size defects because of the flexible nature and strong intermolecular van der Waals interactions of alkane, despite the roughness of graphene. In addition, HTC multilayers between graphene layers greatly improve their adhesion.

Electric field controlled near-infrared high-speed electro-optic switching modulator integrated with 2D MgO.

The electro-optic effect in two-dimensional (2D) MgO nanoflakes synthesized by a microwave-assisted process is demonstrated using a designed optical fiber modulator. The guiding properties of intense core modes excited by the material cavity are modulated by the external electric field. The feasibility of 2D MgO nanoflakes as an effective electro-optic modulator and switching are experimentally verified for the first time, to the best of our knowledge.

Boron Nitride as a Passivation Capping Layer for AlGaN/GaN High Electron Mobility Transistors.

We report on the electrical characteristics of AlGaN/GaN high-electron mobility transistors (HEMTs) with hexagonal boron nitride (h-BN) as a passivation capping layer. The HEMTs with h-BN layers showed an increase in current drainage and 103-times reduction in the gate-leakage current compared with those of conventional unpassivated HEMTs. Moreover, the extrinsic transconductance and the pulse responses were improved due to the reduced charge-trapping effect at the surface of HEMTs.

Boron nitride nanotubes as a heat sinking and stress-relaxation layer for high performance light-emitting diodes.

High-density threading dislocations, the presence of biaxial compressive strain, and heat generation are the major limitations obstructing the performance and reliability of light emitting diodes (LEDs). Herein, we demonstrate a facile epitaxial lateral overgrowth (ELOG) method by incorporating boron nitride nanotubes (BNNTs) on a sapphire substrate by spray coating to resolve the above issues. Atomic force microscopy, X-ray diffraction, micro-Raman, and photoluminescence measurements confirmed the growth of a high quality GaN epilayer on the BNNT-coated sapphire substrate with reduced threading dislocations and compressive strain owing to the ELOG process.

The role of graphene formed on silver nanowire transparent conductive electrode in ultra-violet light emitting diodes.

This paper reports a highly reliable transparent conductive electrode (TCE) that integrates silver nanowires (AgNWs) and high-quality graphene as a protecting layer. Graphene with minimized defects and large graphene domains has been successfully obtained through a facile two-step growth approach. Ultraviolet light emitting diodes (UV-LEDs) were fabricated with AgNWs or hybrid electrodes where AgNWs were combined with two-step grown graphene (A-2GE) or conventional one-step grown graphene (A-1GE).

Carbon-nanotube-assisted nanoepitaxy of Si-doped GaN for improved performance of InGaN/GaN light-emitting diodes.

Using single-walled carbon nanotubes (SWCNTs) as nanomasks on an undoped GaN template, a significant biaxial stress relaxation was achieved in the subsequently-grown Si-doped n-GaN layer. Enhanced near band edge (NBE) emission intensity, similar free carrier concentrations, and the reduced peak width of the asymmetric (102) crystallographic plane all confirmed the suppression of threading dislocations due to the nanoepitaxial growth process. Temperature-dependent photoluminescence (PL) revealed improved internal quantum efficiency (IQE) of InGaN/GaN multi-quantum wells (MQWs) grown on this n-GaN layer.

Tailored CVD graphene coating as a transparent and flexible gas barrier.

The chemical vapor deposition (CVD) method to obtain tailored graphene as a transparent and flexible gas barrier has been developed. By separating nucleation step from growth, we could reduce early graphene nucleation density and thus induce better stitching between domain boundaries in the second growth step. Furthermore, two step growth in conjunction with electrochemical polishing of Cu foils achieved large graphene domains and improved graphene quality with minimized defects.

Dual-Wavelength Light Emission from CdSe/ZnS Quantum Dots on Blue Light-Emitting Diodes.

We fabricated light-emitting device by using CdSe/ZnS quantum dots (QDs) on InGaN/GaN blue light-emitting diodes (LEDs) for converting blue emission into green emission. By adding Au nanoparticles (ANPs) to generate localized surface plasmon mode, the integrated intensity of green emission of LEDs with CdSe/ZnS QDs on ANPs is enhanced by about 55%, without any drawback in electrical characteristics of LEDs. This result is attributed to an increased conversion efficiency by resonance coupling between localized surface plasmons in ANPs and excitons in CdSe/ZnS QDs.

Efficient stress-relaxation in InGaN/GaN light-emitting diodes using carbon nanotubes.

A facile method to facilitate epitaxial lateral overgrowth (ELO) of gallium nitride (GaN) was developed by using single-walled carbon nanotubes (SWCNTs). High-quality GaN was achieved on sapphire by simply coating the SWCNTs as an intermediate layer for stress and defect mitigation. SWCNTs maintained their integrity at high reaction temperature and led to suppression of edge dislocations and biaxial stress relaxation by up to 0.

Effect of strain relaxation in InGaN/GaN multi-quantum wells with self-assembled Pt nanoclusters.

We report effect of the strain relaxation in InGaN/GaN multi-quantum well (MQW) structures grown on platinum nanocluster-coated sapphire substrate (PNSS) by metal organic chemical vapor deposition. The photoluminescence (PL) intensity of InGaN/GaN MQWs on PNSS was significantly enhanced compared to that of the InGaN/GaN MQWs on flat sapphire substrate due to the reduction of defect density and residual strain by self-assembled Pt nanoclusters. We confirmed the reduction of strain-induced piezoelectric field by the power dependence of the PL in InGaN/GaN MQWs on PNSS.

Carrier localization in In-rich InGaN/GaN multiple quantum wells for green light-emitting diodes.

Carrier localization phenomena in indium-rich InGaN/GaN multiple quantum wells (MQWs) grown on sapphire and GaN substrates were investigated. Temperature-dependent photoluminescence (PL) spectroscopy, ultraviolet near-field scanning optical microscopy (NSOM), and confocal time-resolved PL (TRPL) spectroscopy were employed to verify the correlation between carrier localization and crystal quality. From the spatially resolved PL measurements, we observed that the distribution and shape of luminescent clusters, which were known as an outcome of the carrier localization, are strongly affected by the crystalline quality.

Size dependence of silica nanospheres embedded in 385 nm ultraviolet light-emitting diodes on a far-field emission pattern.

We demonstrate that the use of silica nanospheres (SNs) with sizes close to the emission wavelength of light-emitting diodes (LEDs) can enhance the light output power and manipulate the far-field emission pattern. Near-ultraviolet (NUV)-LEDs grown on a patterned sapphire substrate embedded with 300 nm SNs show a three times higher light output power than that without SNs, when measured through the top side. For far-field emission measurements, the LEDs embedded with 300 nm SNs show the significant increase of front emission due to the improved crystal quality of epitaxial films as well as the increase of Mie scattering effect of SNs.

Direct growth of GaN layer on carbon nanotube-graphene hybrid structure and its application for light emitting diodes.

We report the growth of high-quality GaN layer on single-walled carbon nanotubes (SWCNTs) and graphene hybrid structure (CGH) as intermediate layer between GaN and sapphire substrate by metal-organic chemical vapor deposition (MOCVD) and fabrication of light emitting diodes (LEDs) using them. The SWCNTs on graphene act as nucleation seeds, resulting in the formation of kink bonds along SWCNTs with the basal plane of the substrate. In the x-ray diffraction, Raman and photoluminescence spectra, high crystalline quality of GaN layer grown on CGH/sapphire was observed due to the reduced threading dislocation and efficient relaxation of residual compressive strain caused by lateral overgrowth process.

Suppressing spontaneous polarization of p-GaN by graphene oxide passivation: augmented light output of GaN UV-LED.

GaN-based ultraviolet (UV) LEDs are widely used in numerous applications, including white light pump sources and high-density optical data storage. However, one notorious issue is low hole injection rate in p-type transport layer due to poorly activated holes and spontaneous polarization, giving rise to insufficient light emission efficiency. Therefore, improving hole injection rate is a key step towards high performance UV-LEDs.

Enhanced optical output power by the silver localized surface plasmon coupling through side facets of micro-hole patterned InGaN/GaN light-emitting diodes.

Light extraction efficiency of GaN-based light emitting diodes were significantly enhanced using silver nanostructures incorporated in periodic micro-hole patterned multi quantum wells (MQWs). Our results show an enhancement of 60% in the wall-plug efficiency at an injection current of 100 mA when Ag nano-particles were deposited on side facet of MQWs passivated with SiO2. This improvement can be attributed to an increase in the spontaneous emission rate through resonance coupling between localized surface plasmons in Ag nano-particles and the excitons in MQWs.

Light-extraction enhancement of a GaN-based LED covered with ZnO nanorod arrays.

We investigate the mechanism of light extraction enhancement of a GaN-based light-emitting diode (LED) grown on patterned sapphire substrate (PSS), that has ZnO nanorod arrays (NRAs) fabricated on top of the device using the hydrothermal method. We found that the light output power of the LED with ZnO NRAs increases by approximately 30% compared to the conventional LED without damaging the electrical properties of the device. We argue that the gradual decrease of the effective refractive index, which is caused by the fabrication of ZnO NRAs, is the mechanism of the observed improvement.

Defying DNA double-strand break-induced death during prophase I meiosis by temporal TAp63α phosphorylation regulation in developing mouse oocytes.

The dichotomy in DNA damage sensitivity of developing mouse oocytes during female germ line development is striking. Embryonic oocytes withstand hundreds of programmed DNA double-strand breaks (DSBs) required for meiotic recombination. Postnatal immature oocytes fail to tolerate even a few DSBs induced by gamma radiation treatment.

Time-resolved ultraviolet near-field scanning optical microscope for characterizing photoluminescence lifetime of light-emitting devices.

We developed a instrument consisting of an ultraviolet (UV) near-field scanning optical microscope (NSOM) combined with time-correlated single photon counting, which allows efficient observation of temporal dynamics of near-field photoluminescence (PL) down to the sub-wavelength scale. The developed time-resolved UV NSOM system showed a spatial resolution of 110 nm and a temporal resolution of 130 ps in the optical signal. The proposed microscope system was successfully demonstrated by characterizing the near-field PL lifetime of InGaN/GaN multiple quantum wells.

Efficiency improvement in InGaN-based solar cells by indium tin oxide nano dots covered with ITO films.

InGaN based MQW solar cells have been fabricated with 4 different transparent top electrode structures: (1)- ITO 200 nm, (2)-ITO nano dots only, (3)-ITO nano dots on ITO 50 nm and (4)-ITO nano dots on ITO 100 nm. The solar cell with the ITO 50 nm on ITO nano dots under AM 1.5 conditions showed the best results: 2.

Impact of interlayer processing conditions on the performance of GaN light-emitting diode with specific NiOx/graphene electrode.

This paper reports on the evaluation of the impact of introducing interlayers and postmetallization annealing on the graphene/p-GaN ohmic contact formation and performance of associated devices. Current-voltage characteristics of the graphene/p-GaN contacts with ultrathin Au, Ni, and NiO(x) interlayers were studied using transmission line model with circular contact geometry. Direct graphene/p-GaN interface was identified to be highly rectifying and postmetallization annealing improved the contact characteristics as a result of improved adhesion between the graphene and the p-GaN.

Efficiency improvement in InGaN-based solar cells by indium tin oxide nano dots covered with ITO films.

InGaN based MQW solar cells have been fabricated with 4 different transparent top electrode structures: (1)- ITO 200 nm, (2)-ITO nano dots only, (3)-ITO nano dots on ITO 50 nm and (4)-ITO nano dots on ITO 100 nm. The solar cell with the ITO 50 nm on ITO nano dots under AM 1.5 conditions showed the best results: 2.

Enhancement of light output power in GaN-based light-emitting diodes using hydrothermally grown ZnO micro-walls.

We report on the efficiency enhancement in GaN-based light-emitting diodes (LEDs) using ZnO micro-walls grown by a hydrothermal method. The formation of ZnO micro-walls at the indium tin oxide (ITO) border on the LED structure is explained by the heterogeneous nucleation effect. The light output power of LEDs with ZnO micro-walls operated at 20 mA was found to increase by approximately 30% compared to conventional LEDs.

Light outcoupling effect in GaN light-emitting diodes via convex microstructures monolithically fabricated on sapphire substrate.

GaN-based light-emitting diode (LED) was fabricated on the sapphire substrate with monolithic convex microstructures (CMs) array. Using confocal scanning electroluminescence (EL), we have directly observed the strong outcoupling phenomenon of the light confined in a LED via the CMs array. This outcoupled light could be efficiently converged on the convex center through consecutive reflections at the flat area and the curved slant area of the CMs array.