98%
921
2 minutes
20
Surface-enhanced Raman spectroscopy (SERS) by 2D semiconductors relies on chemical (CM) enhancement driven by charge-transfer (CT) processes in bandgap alignment between molecules and substrates. Unfortunately, the low light absorption and weak conferment in the atomic-layer material limit the enhancement factor of Raman intensity (EFRI). Improving the utilization efficiency of excitation light is therefore essential for promoting SERS performance of 2D semiconductors. Here we develop a heterojunction SERS substrate, composed of few-layer MoS (FL-MoS) flakes capping onto the acceptor-rich β-GaO microstrips grown by optical vapor supersaturated precipitation (OVSP). The acceptor-rich β-GaO microstrips excited by ultraviolet (UV) irradiation boost the CT processes between FL-MoS and analyte molecules, by which the EFRI was increased by two orders of magnitude up to 9.33 × 10⁴ with the limit of detection (LoD) down to 10 M for methylene blue (MB). The in-situ experiment unveils that the SERS improvement is originated from the photoinduced carries trapped by the deep acceptor of Ga vacancies ([Formula: see text]) at 2.53 eV below conduction band minimum to facilitate the CT resonance. The present work provides new insights into the role of defect states in the chemical SERS mechanism, demonstrating the improvement of 2D-material substrate performance for ultrasensitive Raman detection.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC12413391 | PMC |
http://dx.doi.org/10.1186/s11671-025-04339-y | DOI Listing |
Discov Nano
September 2025
School of Physics and Optoelectronic Engineering, Beijing University of Technology, Beijing, 100124, China.
Surface-enhanced Raman spectroscopy (SERS) by 2D semiconductors relies on chemical (CM) enhancement driven by charge-transfer (CT) processes in bandgap alignment between molecules and substrates. Unfortunately, the low light absorption and weak conferment in the atomic-layer material limit the enhancement factor of Raman intensity (EFRI). Improving the utilization efficiency of excitation light is therefore essential for promoting SERS performance of 2D semiconductors.
View Article and Find Full Text PDFAdv Mater
December 2024
Materials Science and Engineering, Stanford University, 496 Lomita Mall, Stanford, CA, 94305, USA.
The performance of all-polymer solar cells is often enhanced by incorporating solvent additives during solution processing. In particular, blends based on the model all-polymer system PBDBT:N2200 have been shown to have increased short-circuit current and fill factor when processed with dilute diiodooctane (DIO). However, the morphological mechanism that drives the increase in performance is often not well understood due to limitations in common characterization techniques.
View Article and Find Full Text PDFDiscov Nano
July 2024
School of Physics and Optoelectronic Engineering, Beijing University of Technology, Beijing, 100124, China.
Optoelectronic synapses with fast response, low power consumption, and memory function hold great potential in the future of artificial intelligence technologies. Herein, a strategy of annealing in oxygen ambient at different temperatures is presented to improve the optoelectronic synaptic behaviors of acceptor-rich ZnO (A-ZnO) microtubes. The basic synaptic functions of as-grown and annealed A-ZnO microtubes including excitatory postsynaptic current (EPSC), short-term memory (STM) to long-term memory (LTM) conversion, and paired-pulse facilitation (PPF), were successfully emulated.
View Article and Find Full Text PDFAdv Mater
February 2024
State Key Laboratory of Silicon and Advanced Semiconductor Materials, Department of Polymer Science and Engineering, Zhejiang University, Hangzhou, 310027, P. R. China.
Achieving precise control over the nanoscale morphology of bulk heterojunction films presents a significant challenge for the conventional post-treatments employed in organic solar cells (OSCs). In this study, a near-infrared photon-assisted annealing (NPA) strategy is developed for fabricating high-performance OSCs under mild processing conditions. It is revealed a top NIR light illumination, together with the bottom heating, enables the selective tuning of the molecular arrangement and assembly of narrow bandgap acceptors in polymer networks to achieve optimal morphologies, as well as the acceptor-rich top surface of active layers.
View Article and Find Full Text PDFJ Phys Chem Lett
July 2022
Complex Materials and Devices, Department of Physics, Chemistry and Biology (IFM), Linköping University, 581 83 Linköping, Sweden.
Despite an impressive increase over the past decade, experimentally determined power conversion efficiencies of organic photovoltaic cells still fall considerably below the theoretical upper bound for near-equilibrium solar cells. Even in otherwise optimized devices, a prominent yet incompletely understood loss channel is the thermalization of photogenerated charge carriers in the density of states that is broadened by energetic disorder. Here, we demonstrate by extensive numerical modeling how this loss channel can be mitigated in carefully designed morphologies.
View Article and Find Full Text PDF