98%
921
2 minutes
20
Microplastics (MPs) and the development of associated antibiotic-resistant bacteria are of serious concern. Conventional water treatment methodologies do not sufficiently address the issue of MPs and MPs-attached bacteria. The photocatalytic process is a promising technique that utilizes solar light to generate HO radicals for the degradation of MPs and inactivation of microorganisms. In this work, the iron-vanadate (FeVO, IVAN) nanoparticles prepared by the coprecipitation and a subsequent freeze-drying technique were tested for their cytotoxicity and photocatalytic activity in the degradation of MPs and inactivation of bacteria. Cytotoxicity of the prepared IVAN catalyst showed moderate toxicity levels at a concentration of 12.5 μg/mL. Photocatalytic degradation of catalysts evaluated using attenuated total reflection infrared (ATR-IR) spectroscopy revealed the overall highest increase in the carbonyl index (CI) and peroxyl index (PI) for the IVAN nanoparticles compared with commercial catalysts. The scavenging experiments confirmed that HO and O were the potential main reactive oxygen species produced during the photocatalytic process using IVAN. Furthermore, nuclear magnetic resonance (NMR) spectra proved an oxidative degradation of polystyrene (PS) MPs. Apparently, leaching of Fe and V ions closer to the acceptable toxicity levels was detected by using inductively coupled plasma optical emission spectrometry (ICP-OES). Interestingly, IVAN exhibited inhibition of the USA300 biofilm in both dark and light conditions. Therefore, our investigation of IVAN and commercial photocatalysts could give insights into the preparation of efficient catalysts for treating MPs and bacteria in water.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC12392196 | PMC |
http://dx.doi.org/10.1021/acsomega.5c02744 | DOI Listing |
Adv Colloid Interface Sci
August 2025
NanoBioTech Laboratory, Department of Chemistry, Florida Polytechnic University, Lakeland, FL-33805, USA. Electronic address:
Considering the complexities of electronics waste management to meet the requirements of digital-age technologies, this article underscores the pressing need for eco-friendly, economical, and sustainable engineering solutions. Here, it uniquely focuses on bacteriogenic metallic and semiconducting nano-systems as a promising yet underexplored solution for sustainable materials innovation. Unlike conventional green nanofabrication methods involving plants or eukaryotic microbes, bacteria possess numerous merits for fabrication, including ease of cultivation, a wide spectrum of genera, abundance, prompt cell division efficacy, genetic elasticity, and high bio-reduction/oxidation efficacy that make them highly adaptable platforms for engineered nanostructures.
View Article and Find Full Text PDFEnviron Monit Assess
September 2025
Centre for Applied Research, Saveetha School of Engineering, Saveetha Institute of Medical and Technical Sciences (SIMATS), Chennai, Tamil Nadu, 602105, India.
Dye pollution from industrial effluents poses a major environmental threat due to the toxicity, mutagenicity, and carcinogenicity of synthetic dyes. Conventional treatment methods-physical, chemical, and biological-often suffer from limited efficiency, high operational costs, and secondary pollution. Carbon-based nanomaterials have emerged as promising alternatives, with carbon nanodots (CNDs) gaining attention for their unique physicochemical properties.
View Article and Find Full Text PDFACS Omega
August 2025
Department of Microbiology, Faculty of Medicine, Wroclaw Medical University, Wroclaw 50-368, Poland.
Microplastics (MPs) and the development of associated antibiotic-resistant bacteria are of serious concern. Conventional water treatment methodologies do not sufficiently address the issue of MPs and MPs-attached bacteria. The photocatalytic process is a promising technique that utilizes solar light to generate HO radicals for the degradation of MPs and inactivation of microorganisms.
View Article and Find Full Text PDFSci Rep
August 2025
Botany and Microbiology Department, Faculty of Science, Zagazig University, Zagazig, 44519, Egypt.
The aim of this research was to prepare a different particle sizes of zinc oxide nanostructures by two different methods. The zinc oxide nanoparticle (ZnO NP) was successfully prepared by a green synthesis technique but the zinc oxide quantum dot (ZnO QD) was successfully prepared by a chemical method. The structure, composition and morphology of the prepared different shapes of ZnO nanostructures have been characterized by the means of X-ray diffractograms (XRD), high resolution transmission electron microscope (HRTEM), Energy Dispersive x-ray (EDX), UV-Vis spectroscopy and Fourier transform infrared spectroscopy (FTIR).
View Article and Find Full Text PDFJ Fluoresc
August 2025
Manonamaniam Sundaranar University, Abishekapatti, Tirunelveli, Tamil Nadu, India.
Tri-metallic MnO-ZnO-CeO nanocomposites were successfully synthesized via a co-precipitation method. Structural characterization confirmed the formation of orthorhombic MnO, hexagonal ZnO, and cubic CeO phases, with an average crystallite size of approximately 18 nm. The nanocomposites exhibited a narrow band gap of 2.
View Article and Find Full Text PDF