98%
921
2 minutes
20
As avalanche gallium arsenide photoconductive semiconductor switches (GaAs PCSS) operate under high-voltage and high-current environments, the switches suffer from serious self-triggering problems. This paper proposes a novel sidewall triggering method to mitigate the self-triggering effect of avalanche GaAs PCSS. Compared with the traditional planar triggering method, the self-triggering probability of GaAs PCSS triggered by the sidewall method is reduced from 5.2 × 10-3 to 7.35 × 10-5, which is about two orders of magnitude lower. Meanwhile, an experimental study of sidewall GaAs PCSS triggered high power gas switching. The experimental results show that the GaAs PCSS is able to successfully trigger a high-power gas switch with a turn-on delay time jitter of 1.53 ns at 40 kV and 0.3 MPa. The feasibility of the side-wall GaAs PCSS for triggering the gas switch is verified.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1063/5.0275186 | DOI Listing |
Rev Sci Instrum
August 2025
Shaanxi Provincial Key Laboratory of Electronic Devices and Advanced Chips, Xi'an Key Laboratory of Micro-Nano Electronics and System Integration, and School of Microelectronic, Xi'an Jiaotong University, Xi'an, Shaanxi 710049, China.
As avalanche gallium arsenide photoconductive semiconductor switches (GaAs PCSS) operate under high-voltage and high-current environments, the switches suffer from serious self-triggering problems. This paper proposes a novel sidewall triggering method to mitigate the self-triggering effect of avalanche GaAs PCSS. Compared with the traditional planar triggering method, the self-triggering probability of GaAs PCSS triggered by the sidewall method is reduced from 5.
View Article and Find Full Text PDFRev Sci Instrum
January 2024
College of Advanced Interdisciplinary Studies, National University of Defense Technology, Changsha, Hunan 410073, China.
The stability of synchronous operation is directly related to the time jitter of the gallium arsenide photoconductive semiconductor switch (GaAs PCSS). In this work, a numerical model for the switching jitter of avalanche GaAs PCSS is established, and the impacts of triggering optical energy and bias electric field on the switching jitter are investigated numerically based on an equivalent bulk current channel. The proposed numerical model predicts well the changing characteristics of switching time as well as switching jitter, which has been demonstrated by the experimental results.
View Article and Find Full Text PDFWe report a new, to the best of our knowledge, type of SI-GaAs photoconductive semiconductor switch (PCSS) with nanostructures. Since light can enter from both the top and side surfaces of nanostructures, the effective penetration depth is significantly increased. Lower on-state resistance and a longer lock-on time have been achieved in the nonlinear mode with this design, as well as a lower triggering fluence in the linear mode.
View Article and Find Full Text PDFRev Sci Instrum
May 2020
State Key Laboratory of Intense Pulsed Radiation Simulation and Effect, Northwest Institute of Nuclear Technology, Xi'an 710024, China.
A gas switch triggered by μJ laser pulses was developed. The switch employed a 10 mm-gap GaAs photoconductive semiconductor switch (PCSS) mounted in parallel with one of its two gaps. The dark current-voltage characteristic of the PCSS was obtained, and the gas switch characteristics at different bias voltages were experimentally investigated.
View Article and Find Full Text PDFWe report a new type of photoconductive semiconductor switch (PCSS), consisting of a semi-insulating gallium arsenic (GaAs) substrate and a front-bonded ruby crystal. The 532 nm laser pulses from an Nd-YAG laser incident on the front surface of the ruby crystal. A portion of the laser pulse passes through the crystal and reaches the GaAs substrate, and the remaining portion of the laser pulse is absorbed by the ruby crystal.
View Article and Find Full Text PDF