Towards a closed loop retinal prosthesis: measuring electrically evoked retinal responses using large electrodes.

Sensory prostheses use arrays of electrodes to stimulate neural tissue and restore a sense of vision or hearing. At perceptible levels of stimulation, the current from each electrode spreads and causes overlapping regions of neural activation. This lack of specificity results in perceptual deficits. Methods to overcome this reduced specificity, such as a closed loop stimulation approach require measurement of the neural response to stimulation. This investigation tests the possibility of using the large stimulating electrodes such as those required by some subretinal or suprachoroidal retinal implants to measure the neural response to stimulation, an approach similar to Evoked Compound Action Potentials measurements used in cochlear implants.tissue samples from Long Evans rats with healthy retinas and Royal College of Surgeon rats with retinal degeneration were used to investigate both stimulating and recording from electrodes of the same array. A hexagonal array was used with 20 platinum electrodes with 500m diameter and 700m pitch. Post-stimulus voltage decay was reduced with appropriate tuning of a triphasic stimulation pulse and in post-analysis with a high-pass filter. A method using alternating polarities of biphasic pulses was also trialed. A cocktail of synaptic and ion channel blockers was used to block all neural response including action potentials and thus confirm the biological origin of the signal.It was found that a neural signal was observable on electrode that were sufficiently distant from the stimulating electrodes. The signal appeared to be due to direct activation of ganglion cells or possibly mediated via inner retinal neurons.This result confirms that recording usable neural signals from large electrodes is possible, which is an essential step in implementing a closed loop stimulation strategy for a subretinal or suprachoroidal retinal prosthesis.