98%
921
2 minutes
20
Objective: To compare the ease of visibility of lactated Ringer solutions with and without added dyes during leak testing of porcine cadaveric intestinal segments that underwent simple enterotomy.
Methods: 30 unpreserved jejunal segments were randomized into 1 of the 3 treatment groups as follows: lactated Ringer solution, fluorescein, and methylene blue. The preparation of tissues and experimentation was performed on September 17 and 18, 2024. Two-cm enterotomy incisions were made on the antimesenteric border and closed with a simple continuous suture pattern, leaving a 3-mm gap at the end of each closure. The randomly assigned solution was infused into each segment until leakage from the enterotomy gap was detected. Likert scores rating the ease of visibility of leakage detected by 1 of 2 observers, time to observed leakage, and volume infused were recorded.
Results: No statistical difference in Likert scores, time, or volume was detected among treatment groups. Observer results were independent of each other, and a high correlation between time and volume was demonstrated. A trend illustrating higher confidence and faster recognition in leak detection was noted for the fluorescein and methylene blue solutions compared to the nondyed lactated Ringer solution for both observers.
Conclusions: Ease of leakage identification and time to leak observation resulted in higher confidence and faster recognition with the use of a dyed solution compared to a nondyed solution.
Clinical Relevance: The use of dyed solutions may facilitate the detection of intestinal leakage after enterotomy closure, and fluorescein is a comparable alternative to methylene blue for this purpose.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.2460/ajvr.25.03.0108 | DOI Listing |
Environ Geochem Health
September 2025
Department of Chemistry, Government Arts College(A), Salem, Tamil Nadu, 636007, India.
A CoO/AgMoO/CeOternary nanocomposites photocatalyst was successfully synthesized through a straightforward ethanol-assisted chemical method. Comprehensive characterization of its structural and optical properties was conducted using X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), Raman spectroscopy, scanning electron microscopy (SEM), transmission electron microscopy (TEM), UV-Vis diffuse reflectance spectroscopy (UV-DRS), and photoluminescence (PL) analysis. XRD analysis confirmed the presence of CoO, AgMoO and CeO in the ternary composite sample.
View Article and Find Full Text PDFAnal Chem
September 2025
School of Agricultural Engineering, Key Laboratory of Modern Agricultural Equipment and Technology (Ministry of Education), Jiangsu University, Zhenjiang, Jiangsu 212013, PR China.
To balance the "detection sensitivity" and "device stability" of the organic photoelectrochemical transistor (OPECT) aptasensors, it has become an urgent challenge for achieving effective signal modulation under low ascorbic acid (AA) conditions. To address this, our work proposed a collaborative optimization strategy by coupling heterojunction engineering with interfacial molecular modulation, to endow a high current gain of OPECT with low-AA -dependence. First, a CdZnS-SnInS heterojunction gate was constructed by in situ growth of CdZnS quantum dots (QDs) on SnInS nanoflowers, which enhanced the light trapping ability and photoelectric conversion efficiency of the photoactive gate.
View Article and Find Full Text PDFBioresour Technol
September 2025
School of Chemical Engineering, Xiangtan University, Xiangtan 411105, China. Electronic address:
Biomass containing inorganic ingredients can be converted into highly porous biochar via in-situ activation and templating process. Here, N-doped biochar is obtained by pyrolysis of spinach organs for efficient dye removal, using methylene blue (MB) as a model dye, and pyrolysis temperature plays a critical role in determining both porosity and N-species within biochar. Significantly, leaf biochar (LC-900) as pyrolyzed at 900 °C shows surface areas of 1263 m/g larger than that of biochar from stem and root, indicating a dependence on the biomass organ source.
View Article and Find Full Text PDFLangmuir
September 2025
Laboratory of Electrochemistry-Corrosion, Metallurgy and Inorganic Chemistry, Faculty of Chemistry, USTHB, BP 32, 16111, Algiers, Algeria.
Azo dyes, prevalent in various industries, including textile dyeing, food, and cosmetics, pose significant environmental and health risks due to their chemical stability and toxicity. This study introduces the synthesis and application of a copper hydrogen-π-bonded benzoate framework (Cu-HBF) and its derived marigold flower-like copper oxide (MFL-CuO) in a synergetic adsorption-photocatalytic process for efficiently removing cationic azo dyes from water, specifically crystal violet (CV), methylene blue (MB), and rhodamine B (RhB). The Cu-HBF, previously available only in single crystal form, is prepared here as a crystalline powder for the first time, using a low-cost and facile procedure, allowing its application as an adsorbent and also serving as a precursor for synthesizing well-structured copper oxide (MFL-CuO).
View Article and Find Full Text PDFAm J Case Rep
September 2025
Department of Gastroenterology, Beijing Friendship Hospital, Capital Medical University; State Key Laboratory for Digestive Health; National Clinical Research Center for Digestive Diseases, Beijing, China.
BACKGROUND Non-traumatic bladder rupture, a rare yet potentially life-threatening condition, can stem from diverse factors such as malignancies, bladder inflammation, or bladder diverticulum rupture. Pelvic radiotherapy, in extremely rare instances, can lead to radiation cystitis and subsequent bladder fistula formation. Patients with such conditions often present with abdominal pain, hematuria, oliguria, and urinary ascites.
View Article and Find Full Text PDF