98%
921
2 minutes
20
Introduction: This study aimed to assess and compare the effectiveness and safety of methylene blue ink and commercially available surgical marker pens in pre-operative skin marking for joint replacement procedures. The objective was to evaluate the visibility of the surgical instruments during the operation and their influence on the occurrence of infections after the surgery, providing valuable information on the practical use and cost-effectiveness.
Materials And Methods: This retrospective randomized study involved 150 total cases, which included knee replacements, total hip replacements, and hip hemiarthroplasty performed between 2020 and 2023. The same surgeon conducted all procedures, and the patients were randomly assigned to two groups: One marked with methylene blue ink and the other with a commercially available sterile marker pen. Limb preparation followed an identical protocol for both groups. The primary outcomes assessed were the visibility of markings at the end of the procedure and the incidence of post-operative infections.
Results: The visibility of markings was satisfactory in both groups, with the methylene blue group displaying more pronounced visibility. Importantly, there were no cases of post-operative infections or permanent tattooing attributed to either marking method.
Conclusion: This study demonstrates that both methylene blue ink and commercially available surgical marker pens provide effective skin markings for surgical procedures without increasing the risk of post-operative infections or causing permanent tattooing. Methylene blue ink showed more evident marking post-procedure and ink form remains a cheaper alternative.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11546025 | PMC |
http://dx.doi.org/10.13107/jocr.2024.v14.i11.4984 | DOI Listing |
Environ Geochem Health
September 2025
Department of Chemistry, Government Arts College(A), Salem, Tamil Nadu, 636007, India.
A CoO/AgMoO/CeOternary nanocomposites photocatalyst was successfully synthesized through a straightforward ethanol-assisted chemical method. Comprehensive characterization of its structural and optical properties was conducted using X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), Raman spectroscopy, scanning electron microscopy (SEM), transmission electron microscopy (TEM), UV-Vis diffuse reflectance spectroscopy (UV-DRS), and photoluminescence (PL) analysis. XRD analysis confirmed the presence of CoO, AgMoO and CeO in the ternary composite sample.
View Article and Find Full Text PDFAnal Chem
September 2025
School of Agricultural Engineering, Key Laboratory of Modern Agricultural Equipment and Technology (Ministry of Education), Jiangsu University, Zhenjiang, Jiangsu 212013, PR China.
To balance the "detection sensitivity" and "device stability" of the organic photoelectrochemical transistor (OPECT) aptasensors, it has become an urgent challenge for achieving effective signal modulation under low ascorbic acid (AA) conditions. To address this, our work proposed a collaborative optimization strategy by coupling heterojunction engineering with interfacial molecular modulation, to endow a high current gain of OPECT with low-AA -dependence. First, a CdZnS-SnInS heterojunction gate was constructed by in situ growth of CdZnS quantum dots (QDs) on SnInS nanoflowers, which enhanced the light trapping ability and photoelectric conversion efficiency of the photoactive gate.
View Article and Find Full Text PDFBioresour Technol
September 2025
School of Chemical Engineering, Xiangtan University, Xiangtan 411105, China. Electronic address:
Biomass containing inorganic ingredients can be converted into highly porous biochar via in-situ activation and templating process. Here, N-doped biochar is obtained by pyrolysis of spinach organs for efficient dye removal, using methylene blue (MB) as a model dye, and pyrolysis temperature plays a critical role in determining both porosity and N-species within biochar. Significantly, leaf biochar (LC-900) as pyrolyzed at 900 °C shows surface areas of 1263 m/g larger than that of biochar from stem and root, indicating a dependence on the biomass organ source.
View Article and Find Full Text PDFLangmuir
September 2025
Laboratory of Electrochemistry-Corrosion, Metallurgy and Inorganic Chemistry, Faculty of Chemistry, USTHB, BP 32, 16111, Algiers, Algeria.
Azo dyes, prevalent in various industries, including textile dyeing, food, and cosmetics, pose significant environmental and health risks due to their chemical stability and toxicity. This study introduces the synthesis and application of a copper hydrogen-π-bonded benzoate framework (Cu-HBF) and its derived marigold flower-like copper oxide (MFL-CuO) in a synergetic adsorption-photocatalytic process for efficiently removing cationic azo dyes from water, specifically crystal violet (CV), methylene blue (MB), and rhodamine B (RhB). The Cu-HBF, previously available only in single crystal form, is prepared here as a crystalline powder for the first time, using a low-cost and facile procedure, allowing its application as an adsorbent and also serving as a precursor for synthesizing well-structured copper oxide (MFL-CuO).
View Article and Find Full Text PDFAm J Case Rep
September 2025
Department of Gastroenterology, Beijing Friendship Hospital, Capital Medical University; State Key Laboratory for Digestive Health; National Clinical Research Center for Digestive Diseases, Beijing, China.
BACKGROUND Non-traumatic bladder rupture, a rare yet potentially life-threatening condition, can stem from diverse factors such as malignancies, bladder inflammation, or bladder diverticulum rupture. Pelvic radiotherapy, in extremely rare instances, can lead to radiation cystitis and subsequent bladder fistula formation. Patients with such conditions often present with abdominal pain, hematuria, oliguria, and urinary ascites.
View Article and Find Full Text PDF