Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Dental implants are a reliable treatment option for restoring missing teeth, but adequate bone quantity and quality are crucial for success. This case series presents four cases treated by different clinicians, all following very similar concepts for combined periodontal and vertical ridge augmentation using recombinant human platelet-derived growth factor-BB. All cases involved a severe periodontal defect requiring either extraction of the adjacent tooth or periodontal regeneration. Different bone grafts and membrane types were utilised. Although true periodontal regeneration cannot be said categorically to have occurred due to a lack of histological evidence, the clinical and radiographic findings suggest almost complete bone fill in all cases. This case series demonstrates that combined periodontal and vertical ridge augmentation using recombinant human platelet-derived growth factor-BB could be successful, but proper case selection and patient preparation for the possibility of multiple surgical procedures are recommended. Conflict-of-interest statement: At the time of preparing this manuscript, Dr Saleh was a clinical advisor for Lynch Biologics, Franklin, TN, USA. The other authors declare that they have no conflicts of interest relating to this study.

Download full-text PDF

Source

Publication Analysis

Top Keywords

vertical ridge
12
recombinant human
12
human platelet-derived
12
platelet-derived growth
12
growth factor-bb
12
case series
12
severe periodontal
8
combined periodontal
8
periodontal vertical
8
ridge augmentation
8

Similar Publications

Objective: Traditional gingival thickness (GT) assessment methods provide only point measurements or simple classifications, lacking spatial distribution information. This study aimed to develop a CBCT-based 3D visualization system for gingival thickness using deep learning, providing a novel spatial assessment tool for implant surgery planning.

Methods: CBCT and intraoral scanning (IOS) data from 50 patients with tooth loss were collected to establish a standardized dataset.

View Article and Find Full Text PDF

The osteogenic effect of 3D-printed bone grafting guides in PAOO: a retrospective cohort study.

BMC Oral Health

September 2025

Stomatological Center, National Regional Medical Center, Binhai Campus of the First Affiliated Hospital, Fujian Medical University, Fuzhou, 350212, China.

Background: Periodontally accelerated osteogenic orthodontics (PAOO) effectively increases alveolar bone volume and broadens orthodontic treatment options. However, bone grafting during PAOO faces challenges such as graft displacement, membrane collapse, and insufficient coronal bone regeneration. This study aimed to evaluate whether 3D-printed digital bone grafting guides could improve graft stability and alveolar bone regeneration compared with conventional PAOO.

View Article and Find Full Text PDF

Transcrestal sinus floor elevation (tSFE) is a useful method for vertical bone augmentation in the posterior maxilla at the time of implant placement. However, this is a blind surgical technique with a risk of perforating the Schneiderian membrane. In this article, we present a simple technique to perform tSFEs using ridge spreaders.

View Article and Find Full Text PDF

Aim: The aim of this study was to evaluate stress distribution in maxillary premolar onlay fabricated of four different restorations.

Methodology: A three-dimensional (3D) maxillary premolar model of onlay was simulated using SolidWorks software. The fabricated 3D onlay model was then restored using four different restorative materials, namely fiber-reinforced direct composite, indirect composite, pressable ceramic, and zirconia using the parameters of Young's modulus and Poisson's ratio.

View Article and Find Full Text PDF

Background: Vertical bone defects remain a challenge in implant dentistry. Titanium mesh (TM) is widely used in guided bone regeneration due to its ability to stabilize grafts, but it requires intraoperative adaptation, increasing surgical time and the risk of complications like mesh exposure. Customized titanium mesh (CTM), designed using CAD/CAM or 3D printing, offers a precise fit and may reduce surgical risks.

View Article and Find Full Text PDF