Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

After application in electric vehicles, spent LiFePO (LFP) batteries are typically decommissioned. Traditional recycling methods face economic and environmental constraints. Therefore, direct regeneration has emerged as a promising alternative. However, irreversible phase changes can significantly hinder the efficiency of the regeneration process owing to structural degradation. Moreover, improper storage and treatment practices can lead to metamorphism, further complicating the regeneration process. In this study, a sustainable recovery method is proposed for the electrochemical repair of LFP batteries. A ligand-chain Zn-complex (ZnDEA) is utilized as a structural regulator, with its ─NH─ group alternatingly facilitating the binding of preferential transition metal ions (Fe during charging and Zn during discharging). This dynamic coordination ability helps to modulate volume changes within the recovered LFP framework. Consequently, the recovered LFP framework can store more Li-ions, enhance phase transition reversibility between LFP and FePO (FP), modify the initial Coulombic efficiency, and reduce polarization voltage differences. The recovered LFP cells exhibit excellent capacity retention of 96.30% after 1500 cycles at 2 C. The ligand chain repair mechanism promotes structural evolution to facilitate ion migration, providing valuable insights into the targeted ion compensation for environmentally friendly recycling in practical applications.

Download full-text PDF

Source
http://dx.doi.org/10.1002/adma.202308927DOI Listing

Publication Analysis

Top Keywords

recovered lfp
12
lfp batteries
8
regeneration process
8
lfp framework
8
lfp
6
dynamic capture
4
capture ligand-chain
4
ligand-chain interaction
4
regeneration
4
interaction regeneration
4

Similar Publications

This paper presents a novel real-time signal processing method for removing local field potential (LFP) artifacts during deep-brain stimulation (DBS). Real-time artifact removal is essential for closed-loop DBS systems, as they rely on real-time, artifact-free LFPs to provide stimulation feedback. Building on previous stimulation-sampling synchronization methods, this work introduces a dynamic template subtraction method that achieves precise and efficient real-time removal of stimulation artifacts.

View Article and Find Full Text PDF

The removal of Al impurities and the regeneration of valuable Fe/P/Li resources from spent lithium iron phosphate (LFP) battery are critical steps in advancing the circular economy within the battery industry. In this work, we propose a simple, clean, and cost-effective method based on selective phosphate precipitation for the removal of Al(III) from the acid leachate of spent LFP, followed by the sequential recovery of battery-grade FePO and LiCO. The results demonstrate that 95.

View Article and Find Full Text PDF

To further reduce the cost and energy consumption of recycling spent lithium-ion batteries (LIBs), this paper proposes a novel technique for simultaneously recovering Li, Ni, Co, and Mn from spent LiNiCoMnO (S-NCM) and LiFePO (S-LFP) batteries using ammonium sulfate mixed roasting. Thermogravimetric analysis of the mixture and XRD analysis of the roasting products indicate that (NH)SO begins to decompose at around 275 °C, forming NHHSO, which participates in the reaction above 350 °C. Above 375 °C, sulfates are generated as reaction products.

View Article and Find Full Text PDF

Synergistic thermal treatment of mixed lithium iron phosphate and lithium nickel manganese cobalt oxide black mass for improved recycling operations.

Waste Manag

July 2025

Institute of Geotechnology and Mineral Resources, Department of Resource Processing Technologies, Clausthal University of Technology, 38678 Clausthal-Zellerfeld, Germany. Electronic address:

Various approaches are being investigated to recover valuable materials from end-of-life lithium-ion batteries, particularly for lithium nickel manganese cobalt oxide (NMC) and lithium iron phosphate (LFP) cathode chemistries. Graphite recovery has gained increasing interest due to its classification as a critical raw material, with Flotation being a promising process for its recovery from black mass. A requirement for successfully realizing this process is the removal of binders from the anode and cathode surfaces, which is usually achieved through thermal treatment.

View Article and Find Full Text PDF

Kinetic optimization in green metal recovery: Citric acid vs glycine for sustainable Li-ion battery recycling.

Ecotoxicol Environ Saf

September 2025

School of Municipal and Environmental Engineering, Shandong Jianzhu University, Jinan 250101, China. Electronic address:

Due to the natural depletion and potential toxicity of some metals in lithium ion batteries (LIB), it is getting important to recover valuable metals such as Li and Co from spent LIBs. This study used citric acid or glycine to leach the valuable metals from cathode materials of these spent LIBs such as lithium iron phosphate (LFP) or lithium manganese oxide (LMO) batteries. The effects of concentrations of the citric acid or glycine, solid-liquid ratio, and HO on the leaching rate of valuable metals were investigated by a batch experiment.

View Article and Find Full Text PDF