98%
921
2 minutes
20
The absorption of extreme ultraviolet (EUV) radiation by a photoresist strongly depends on its atomic composition. Consequently, elements with a high EUV absorption cross section can assist in meeting the demand for higher photon absorbance by the photoresist to improve the sensitivity and reduce the photon shot noise induced roughness. In this work, we enhanced the EUV absorption of the methacrylic acid ligands of Zn oxoclusters by introducing fluorine atoms. We evaluated the lithography performance of this fluorine-rich material as a negative tone EUV photoresist along with extensive spectroscopic and microscopic studies, providing deep insights into the underlying mechanism. UV-vis spectroscopy studies demonstrate that the presence of fluorine in the oxocluster enhances its stability in the thin films to the ambient atmosphere. However, the EUV photoresist sensitivity ( ) of the fluorine-rich oxocluster is decreased compared to its previously studied methacrylic acid analogue. Scanning transmission X-ray microscopy and in situ X-ray photoelectron spectroscopy in combination with FTIR and UV-vis spectroscopy were used to gain insights into the chemical changes in the material responsible for the solubility switch. The results support decarboxylation of the ligands and subsequent radical-induced polymerization reactions in the thin film upon EUV irradiation. The rupture of carbon-fluorine bonds via dissociative electron attachment offers a parallel way of generating radicals. The mechanistic insights obtained here will be applicable to other hybrid materials and potentially pave the way for the development of EUV materials with better performance.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9888611 | PMC |
http://dx.doi.org/10.1021/acsmaterialsau.1c00059 | DOI Listing |
ACS Appl Mater Interfaces
September 2025
Imec, Kapeldreef 75, 3001 Leuven, Belgium.
Extreme ultraviolet (EUV) lithography has revolutionized the high-volume manufacturing of nanoscale components. The use of EUV light leads to ionization-driven chemistry in the imaging materials of lithography, the photoresists. The complex interplay of ionization, generation of primary/secondary electrons, and the subsequent chemical mechanisms that lead to image formation in photoresists has been notoriously difficult to study.
View Article and Find Full Text PDFCurr Microbiol
August 2025
Postgraduate Program in Agricultural Microbiology, Department of Microbiology, Federal University of Viçosa, Viçosa, Brazil.
Halophilic and halotolerant microorganisms, as members of the extremophile group, hold significant potential for both industrial applications and astrobiological research. Conventional microorganisms used in wastewater treatment and bioremediation often cannot withstand the high salinity present in industrial effluents and certain contaminated environments. Similarly, planetary environments such as those on Mars, Europa, and Enceladus are often considered inhospitable due to extreme salinity, temperatures, and radiation levels.
View Article and Find Full Text PDFMicromachines (Basel)
July 2025
State Key Laboratory of Digital Manufacturing Equipment and Technology, School of Mechanical Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074, China.
This review examines the design of thermal control systems for state-of-the-art deep ultraviolet (DUV) and extreme ultraviolet (EUV) projection lithography tools. The lithographic system under investigation integrates several critical subsystems along the optical transmission chain, including the light source, reticle stage, projection optics (featuring DUV refractive lenses and EUV multilayer mirrors), immersion liquid, wafer stage, and metrology systems. Under high-power irradiation conditions with concurrent thermal perturbations, the degradation of thermal stability and gradient uniformity within these subsystems significantly compromises exposure precision.
View Article and Find Full Text PDFPharmaceutics
August 2025
Department of Chemistry and Biochemistry, The University of Texas at Dallas, Richardson, TX 75080-3021, USA.
: Previous research has demonstrated that 20 kHz probe or 37 kHz bath sonication of poloxamers comprising polypropylene glycol (PPG) and polyethylene glycol (PEG) blocks can generate degradation byproducts that are toxic to mammalian cells and organisms. Herein, an investigation of a PEGylated phospholipid micelle was undertaken to identify low-molecular-weight sonolytic degradation byproducts that could be cytotoxic. The concern here lies with the fact that sonication is a frequently employed step in drug delivery manufacturing processes, during which PEGylated phospholipids can be subjected to shear forces and other extreme oxidative and thermal conditions.
View Article and Find Full Text PDFMaterials (Basel)
August 2025
School of Engineering, Xizang University, Lhasa 850000, China.
The Qinghai-Tibet Plateau presents a unique challenge for infrastructure development due to its extreme geological and climatic conditions-high elevation, large diurnal temperature fluctuations, frequent freeze-thaw cycles, intense ultraviolet radiation, and seasonal precipitation. These factors greatly accelerate the weathering of rock materials, leading to aggregates with increased porosity, microcracking, and weakened mechanical properties. While the engineering implications of such degradation are evident, the underlying material science of weathered aggregates-particularly their microstructure-property relationships-remains insufficiently explored, necessitating further investigation to inform material selection and design.
View Article and Find Full Text PDF