98%
921
2 minutes
20
Temperature-responsive liquid chromatography (TRLC) allows for extensive retention and selectivity tuning through temperature in HPLC. This is mainly achieved through the use of a stationary phases comprising of a temperature-responsive polymer which undergoes a reversible change from hydrophilic to hydrophobic behaviour upon increasing the temperature. The approach can allow for reversed phase type separations to be achieved with purely aqueous mobile phases, whereby the retention is controlled through temperature instead of mobile phase composition. Despite the promising nature of such form of retention control under isocratic mobile phase conditions, TRLC can suffer from excessive retention of highly apolar solutes even at lower column temperatures whereby the polymer is considered hydrophilic. This is related both to a residual apolarity of the polymer chain and due to the high log 's and low water solubility of higly apolar compounds. While it was known that elution in TRLC doesn't necessarily has to be performed under purely aqueous conditions and that the use of organic co-solvents to the water is possible, the impact thereof on the temperature responsive behaviour itself had not yet been investigated in a systematic way. Therefore in this work the advantages and drawbacks of the use of the organic co-solvents methanol and acetonitrile in TRLC is assessed on two types of temperature reponsive phases: poly--propylacrylamide (PNNPAAm) and poly--isopropylacrylamide (PNIPAAm). The influence of organic co-solvents is investigated with two representative test mixtures (comprising 4 parabens and 5 apolar steroids).
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1039/d1an01684a | DOI Listing |
Membranes (Basel)
August 2025
State Key Laboratory of Fine Chemicals, School of Chemical Engineering, Dalian University of Technology, Dalian 116024, China.
Interfacial polymerization (IP) has been widely utilized to synthesize composite membranes. However, precise control of this reaction remains a challenge due to the complexity of the IP process. Herein, an optical three-dimensional microscope was used to directly observe the IP process.
View Article and Find Full Text PDFChem Asian J
July 2025
Department of Chemistry, UGC Centre of Advance Study-II, Guru Nanak Dev University, Amritsar, Punjab, 143005, India.
Programming the solvent mediated hierarchical organization and chirality transition in organic-inorganic co-assembled hybrid materials is attractive but still a challenge. The work presented in the manuscript reveals the development of solvent responsive R/S-Pyra-CEA building block which exhibited distinct absorption and chiroptical behavior in presence of Lewis base good co-solvents (THF/1,4-dioxane/DMSO) in self-assembled/co-assembled state in mixed aqueous media. The work proposes a simple strategy to employ subtle differences in the solvent characteristics as the control to direct the co-assembly of well-designed organic building block, inorganic component [Au (III) ions)], and chiral inducer (cysteine) through multiple hierarchical growth pathways for generating diverse chiral superstructures in mixed aqueous media which is unprecedented.
View Article and Find Full Text PDFJ Hazard Mater
September 2025
RISE Research Institute of Sweden, Division Safety and Transport, Fire and Safety, Box 857, Borås 501 15, Sweden. Electronic address:
The transition to fluorine-free firefighting foams has revealed that per- and polyfluoroalkyl substances (PFAS) can remain adsorbed on material surfaces and undergo slow desorption over time. This phenomenon results in the unintended contamination of fluorine-free replacement foams, continuing the environmental spreading of PFAS. Through an extensive review of peer-reviewed literature and supplementary data from direct contacts, this study consolidates current knowledge on the issue, representing one of the most comprehensive analyses to date.
View Article and Find Full Text PDFAngew Chem Int Ed Engl
August 2025
Frontiers Science Center for New Organic Matter, Key Laboratory of Advanced Energy Materials Chemistry (Ministry of Education), State Key Laboratory of Advanced Chemical Power Sources, Collaborative Innovation Center of Chemical Science and Engineering (Tianjin), College of Chemistry, Nankai Univers
Sodium metal batteries (SMBs) with gel polymer electrolytes (GPEs) are considered promising candidates for high energy-density batteries due to their high theoretical capacity and cost effectiveness. However, the intrinsic flammability of GPE poses challenges for their widespread application. Inspired by the concept of the capsules, a triethyl phosphate (TEP)-based GPE with co-sustained release effect has been designed.
View Article and Find Full Text PDFAdv Mater
August 2025
School of Materials Science and Chemical Engineering, Ningbo University, Zhejiang, 315211, China.
Aqueous Zn-S batteries (AZSBs), including conventional and decoupled AZSBs, are suitable options for advanced electrochemical energy storage systems. They are cost-effective with safety, high theoretical capacity, and power density. Nevertheless, many inherent hurdles need to be overcome to make AZSBs practically feasible, including irreversible transformation of the sulfur cathode, instability of the Zn anode, and incompatibility of the electrolyte.
View Article and Find Full Text PDF