98%
921
2 minutes
20
A novel polymer microcapsule-filled dye-doped liquid crystal (DDLC) and phase-change material (PCM) system inspired by biological materials was first proposed, which was further encapsulated into a calcium alginate substrate by wet spinning for making an electrochromic fiber with both bistable electric-optical capability and knitting characteristics. Results show that the optical appearance of the optimized microcapsules and fiber can be reversibly changed between colored and colorless states according to the electric field by switching the DDLCs between isotropic (I) and anisotropic (A) states. Moreover, both I and A states can remain stable for more than 1 week after removing the electric field, due to the synergy of the greatly increased spatial hindrance of the PCM with core loading of 22.58% and the confinement effect from the polymer microcapsule shell material. Aside from the long-term optical stability, the high content of the densely packed DDLCs also endows the electrochromic fiber with a satisfactory driving voltage of 9.7 V, which is below the human safe voltage, showing great potential in a wide range of applications, such as flexible displays, energy-saving smart windows, and wearable advanced textiles.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/acsami.1c08135 | DOI Listing |
ACS Appl Mater Interfaces
May 2025
Xi'an Key Laboratory of Liquid Crystal and Organic Photovoltaic Materials, State Key Laboratory of Fluorine & Nitrogen Chemicals, Optical and Electrical Material Center, Xi'an Modern Chemistry Research Institute, Xi'an, Shaanxi 710065, People's Republic of China.
Two diketopyrrolopyrrole (DPP)-based dichroic dyes were synthesized and investigated for application in dye-doped liquid crystal (LC) smart windows. These dyes exhibited strong absorption in the long-wavelength region, particularly DPP-2, addressing the limited absorption of benzothiadiazole (BT)-based dyes beyond 650 nm. Both DPP dyes demonstrated high dichroic ratios and excellent alignment within the LC host, enabling effective transmittance modulation under an electric field.
View Article and Find Full Text PDFIn this work, we reported an organic dye-doped polymer-coated optical fiber optofluidic laser (FOFL) that supports whispering gallery mode (WGM) laser emission. The dye-doped polymer was coated on the outer surface of single-mode fibers (SMFs) using a simple method to fabricate a uniform and consistent solid gain film. By using coated fibers as optical microcavities for lasers, a low lasing threshold of about 0.
View Article and Find Full Text PDFACS Sens
March 2025
Smith School of Chemical and Biomolecular Engineering, Cornell University, Ithaca, New York 14853, United States.
The surface-induced ordering of liquid crystals (LC) has been harnessed to detect a wide range of chemical and biological stimuli. In most sensor designs, the information-rich response of the LC is transduced from an analyte-triggered change in the out-of-plane orientation of the LC. Quantifying the out-of-plane LC orientation, however, is often complicated by simultaneous changes in the in-plane orientation of the LC when using polarized light for transduction.
View Article and Find Full Text PDFJ Am Chem Soc
March 2025
Department of Applied Chemistry, Graduate School of Engineering, Kyushu University, 744 Moto-oka, Nishi-ku, Fukuoka 819-0395, Japan.
Ionic liquids (ILs) with significant dipole moments exhibit massive electric polarization () under an applied AC electric field () at room temperature. Among the various investigated ILs, the -toluene sulfonate of 1-ethyl-3-methylimidazolium, [Cmim][Tos], which has a large dipole moment in the tosylate anion (∼10.99 D), shows large hysteresis in - curves with a high saturation polarization ( ∼ 92 μC cm) and a remanent polarization ( ∼ 68 μC cm) at a relatively low electric field (1.
View Article and Find Full Text PDFMacromol Rapid Commun
May 2025
Department of Applied Chemistry and Biochemistry, Graduate School of Science and Technology, Kumamoto University, 2-39-1 Kurokami, Chuo-ku, Kumamoto, 860, Japan.
Herein an easy preparation method for anisotropic nanoparticles (NPs) is reported, in which the orientation of the composed molecules aligns at a certain direction in the particle, using a conventional reprecipitation method in combination with a microwave irradiation. The size, shape, and anisotropy of NPs strongly affect several physical properties and thus their regulation is essential for applications. Although some successful examples of size and shape regulation of NPs have been reported recently, the regulation of anisotropy is still challenging.
View Article and Find Full Text PDF