98%
921
2 minutes
20
We propose an electro-optic mode-selective switch based on cascaded three-dimensional lithium-niobate waveguide directional couplers fabricated with a single-step annealed proton-exchange process. To compensate for discrepancies due to uncertainties in the fabrication process, we develop a post-tuning technique to improve the performance of the coupler by means of depositing a layer of titanium oxide (TiO) onto one of the waveguides of the coupler. By integrating two cascaded dissimilar directional couplers, we experimentally demonstrate switchable (de)multiplexing of the LP, LP, and LP modes, where the LP mode can be switched at an efficiency over 75% from 1530 nm to 1612 nm with an applied voltage varying between -9 V and +30 V, and the LP mode can be switched at an efficiency higher than 90% from 1534 nm to 1577 nm with an applied voltage varying between -21 V to 0 V. The switching times are 230-300 ns. Our proposed waveguide platform could be employed to develop advanced switches for applications in areas where high-speed switching of spatial modes is required, such as reconfigurable mode-division-multiplexing communication.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1364/OE.406020 | DOI Listing |
Sci Adv
September 2025
Department of Physiology, University of Pennsylvania, Philadelphia, PA, USA.
Chromosome motion at spindle microtubule plus ends relies on dynamic molecular bonds between kinetochores and proximal microtubule walls. Under opposing forces, kinetochores move bidirectionally along these walls while remaining near the ends, yet how continuous wall sliding occurs without end detachment remains unclear. Using ultrafast force-clamp spectroscopy, we show that single Ndc80 complexes, the primary microtubule-binding kinetochore component, exhibit processive, bidirectional sliding.
View Article and Find Full Text PDFNanophotonics
August 2025
Wangzhijiang Innovation Center for Laser, Aerospace Laser Technology and System Department, Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Shanghai, 201800, China.
The high extinction ratio mode (de)multiplexer is a pivotal component in high capacity mode-division multiplexing data communication and nascent on-chip intermodal acousto-optic modulators. Up to now, high performance on-chip mode (de)multiplexers are still lacking for integrated AOMs on the lithium niobate-on-insulator platform. In this paper, we propose and demonstrate an innovative scheme to achieve high extinction ratio signal routing for acousto-optic modulation, by leveraging a two-mode (de)multiplexer in conjunction with a high- racetrack microring resonator.
View Article and Find Full Text PDFSci Rep
August 2025
Department of Solid State Physics, Faculty of Physics and Applied Informatics, University of Łódź, Łódź, Poland.
The growing use of advanced composites in critical applications demands reliable, non-destructive testing. Traditional techniques often detect only large defects, missing subtle local property changes that can precede major failures. Microwave spectroscopy offers a promising alternative, probing both structural and dielectric properties with high sensitivity.
View Article and Find Full Text PDFSensors (Basel)
August 2025
Consiglio Nazionale delle Ricerche, Istituto Nazionale di Ottica (INO), Via Campi Flegrei, 34-Comprensorio A. Olivetti, 80078 Pozzuoli, Italy.
Whispering-gallery-mode (WGM) microresonators are amongst the most promising optical sensors for detecting bio-chemical targets. A number of laser interrogation methods have been proposed and demonstrated over the last decade, based on scattering and absorption losses or resonance splitting and shift, harnessing the high-quality factor and ultra-small volume of WGMs. Actually, regardless of the sensitivity enhancement, their practical sensing operation may be hampered by the complexity of coupling devices as well as the signalprocessing required to extract the WGM response.
View Article and Find Full Text PDFNano Lett
September 2025
School of Physics, Hubei Key Laboratory of Gravitation and Quantum Physics, Institute for Quantum Science and Engineering, Huazhong University of Science and Technology, 430074 Wuhan, China.
Dipolar coupling between closely spaced magnetic waveguides enables magnonic directional couplers serving as signal combiners, power splitters, demultiplexers, and more. The wavelength-dependent coupling, combined with the weak nonlinear variation of spin-wave wavelength at constant frequency, introduces power-dependent characteristics of directional couplers. This property has been utilized in magnonic logic elements and other applications.
View Article and Find Full Text PDF