Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

The methods for quantification of highly potent analgesic agent (2R,4aR,7R,8aR)-4,7-dimethyl-2-(thiophen-2-yl)octahydro-2H-chromen-4-ol in rat whole blood and plasma were developed and validated using dried matrix spots (DMS) or fabric phase sorptive extraction (FPSE) techniques in combination with LC-MS/MS. 2-Adamantylamine hydrochloride was used as an internal standard (IS). Chromatographic separation was carried out on a reversed-phase column (2.0×75 mm, 5 μm) using water containing 0.1% formic acid and methanol containing 0.1% formic acid as mobile phases in gradient mode at a flow rate of 200 μL/min. The mass spectrometric detection was performed using electrospray ionization (ESI) in positive ion mode. MRM transitions were m/z 284.5 → 137.2/157.4 for the analgesic agent and m/z 152.3 → 93.1/107.2 for IS. Calibration curves were linear within 20-5000 ng/mL in dried plasma spots (DPS) or dried blood spots (DBS) experiments. The linearity was obtained in the range of 20-5000 ng/mL and 50-5000 ng/mL for plasma-FPSE and blood-FPSE experiments, respectively. The intra- and inter-day accuracy and precision did not exceed acceptable limits. The mean extraction recovery (%) was 26 for DPS, 25 for DBS, 38 for plasma-FPSE, 31 for blood-FPSE.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jchromb.2019.121813DOI Listing

Publication Analysis

Top Keywords

dried matrix
8
matrix spots
8
fabric phase
8
phase sorptive
8
sorptive extraction
8
methods quantification
8
quantification highly
8
highly potent
8
potent analgesic
8
agent 2r4ar7r8ar-47-dimethyl-2-thiophen-2-yloctahydro-2h-chromen-4-ol
8

Similar Publications

We report the performance of solid-state ceramic supercapacitors (SSCs) based on a novel composite electrolyte comprising aluminum-doped lithium lanthanum titanate perovskite, LiLaTiAlO (Al-doped LLTO), and the ionic liquid 1-ethyl-3-methylimidazolium tetrafluoroborate (EMIM BF). Rietveld refinement of X-ray diffraction data confirms the preservation of the tetragonal perovskite phase after Al substitution, indicating structural stability of the host lattice. X-ray photoelectron spectroscopy (XPS) and Raman spectroscopy further corroborate the successful incorporation of Al without forming secondary phases.

View Article and Find Full Text PDF

Bacterial cellulose (BC) was produced in dried apricot extract medium (DAEM) by . The BC yield obtained from DAEM containing 0.5 g of glucose after 10 days of incubation at 30 °C was determined as 9.

View Article and Find Full Text PDF

Conductive hydrogels have revolutionized wearable electronics due to their biocompatibility and tunable properties. However, it remains a great challenge for hydrogel-based sensors to maintain both conductivity and mechanical integrity in harsh environments. Synergistic dynamic interactions provide a promising strategy to address this issue.

View Article and Find Full Text PDF

In the present study, the influence of drying temperature, mercerization, and epoxy coating on the physicochemical and mechanical properties of Colombian CFs and their interfacial adhesion with a PLA matrix were studied. CFs were extracted from the mesocarp of Cocos nucifera husks by retting. The fibers were oven-dried at two drying temperatures, 40 °C and 90 °C.

View Article and Find Full Text PDF

Background: Screening and pre-symptomatic diagnosis in newborns allows early treatment of thalassemia and abnormal hemoglobin (Hb) disorders in childhood. However, there remains a lack of efficient methods to screen for hemoglobinopathies in newborns. This study aimed to establish a bottom-up mass spectrometry (MS)-based method for efficient screening of hemoglobinopathies in newborns using dried blood spot (DBS) samples.

View Article and Find Full Text PDF