Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Ionic liquid gated field-effect transistors (FETs) based on semiconducting transition metal dichalcogenides (TMDs) are used to study a rich variety of extremely interesting physical phenomena, but important aspects of how charge carriers are accumulated in these systems are not understood. We address these issues by means of a systematic experimental study of transport in monolayer MoSe and WSe as a function of magnetic field and gate voltage, exploring accumulated densities of carriers ranging from approximately 10 cm holes in the valence band to 4 × 10 cm electrons in the conduction band. We identify the conditions when the chemical potential enters different valleys in the monolayer band structure (the K and Q valley in the conduction band and the two spin-split K-valleys in the valence band) and find that an independent electron picture describes the occupation of states well. Unexpectedly, however, the experiments show very large changes in the device capacitance when multiple valleys are occupied that are not at all compatible with the commonly expected quantum capacitance contribution of these systems, = / (dμ/d). A theoretical analysis of all terms responsible for the total capacitance shows that under general conditions a term is present besides the usual quantum capacitance, which becomes important for very small distances between the capacitor plates. This term, which we call cross quantum capacitance, originates from screening of the electric field generated by charges on one plate from charges sitting on the other plate. The effect is negligible in normal capacitors but large in ionic liquid FETs because of the atomic proximity between the ions in the gate and the accumulated charges on the TMD, and it accounts for all our experimental observations. Our findings therefore reveal an important contribution to the capacitance of physical systems that had been virtually entirely neglected until now.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acs.nanolett.9b03667DOI Listing

Publication Analysis

Top Keywords

quantum capacitance
16
cross quantum
8
semiconducting transition
8
transition metal
8
ionic liquid
8
valence band
8
conduction band
8
capacitance
7
band
6
band filling
4

Similar Publications

We present a method for probing the quantum capacitance associated with the Rydberg transition of surface electrons on liquid helium using radio-frequency (rf) reflectometry. Resonant microwave excitation of the Rydberg transition induces a redistribution of image charges on capacitively coupled electrodes, giving rise to a quantum capacitance originating from adiabatic state transitions and the finite curvature of the energy bands. By applying frequency-modulated resonant microwaves to drive the Rydberg transition, we systematically measured a capacitance sensitivity of 0.

View Article and Find Full Text PDF

A radio frequency emitter design for the low-frequency regime in atomic experiments.

Rev Sci Instrum

September 2025

International Center for Quantum Materials, School of Physics, Peking University, Beijing 100871, China.

Radio frequency (RF) control is a key technique in cold atom experiments. We present a compact and efficient RF circuit based on a capacitive transformer network, where a low-frequency coil operating up to 30 MHz serves as both an intrinsic inductor and a power-sharing element. The design enables high current delivery and flexible impedance matching across a wide frequency range.

View Article and Find Full Text PDF

Ultrathin amorphous materials are promising counterparts to 2D crystalline materials, yet their properties and functionalities remain poorly understood. Amorphous boron nitride (aBN) has attracted attention for its ultralow dielectric constant and superior manufacturability compared with hexagonal boron nitride. Here, we demonstrate wafer-scale growth of ultrathin aBN films with exceptional thickness and composition uniformity using capacitively coupled plasma-chemical vapor deposition (CCP-CVD) at 400 °C.

View Article and Find Full Text PDF

Atomic force microscopy (AFM) imaging of ionic liquid (IL) distribution in electric double-layer (EDL) devices has been actively explored to understand the origin of their excellent performance. However, this has been impeded by insufficient resolution or a poor understanding of the mechanisms of 3D IL imaging. Here, we overcome these difficulties using 3D scanning force microscopy (3D-SFM) with variable tip/sample bias voltages for visualizing 3D ,-diethyl--methyl--(2-methoxyethyl)ammonium bis(trifluoromethanesulfonyl)imide (DEME-TFSI) distributions on a Au electrode in EDL capacitors.

View Article and Find Full Text PDF

Nanoengineered Optoexcitonic Switch.

ACS Nano

August 2025

Electrical and Computer Engineering Department, University of Michigan; Ann Arbor, Michigan 48109-2122, United States.

The efficiency of most electronic devices is limited by scattering and capacitive losses among purely electronic processes. Charge-neutral excitons could reduce both losses and, thus, offer more efficient switching pathways. However, it remains challenging to achieve exciton transport that is fast, guided, and unidirectional enough for gating processes.

View Article and Find Full Text PDF