Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Semiconductors are generally considered far superior to metals as thermoelectric materials because of their much larger Seebeck coefficients (). However, a maximum value of in a semiconductor is normally accompanied by a minuscule electrical conductivity (σ), and hence, the thermoelectric power factor ( = σ) remains small. An attempt to increase σ by increasing the Fermi energy (), on the other hand, decreases . This trade-off between and σ is a well-known dilemma in developing high-performance thermoelectric devices based on semiconductors. Here, we show that the use of metallic carbon nanotubes (CNTs) with tunable solves this long-standing problem, demonstrating a higher thermoelectric performance than semiconducting CNTs. We studied the dependence of , σ, and in a series of CNT films with systematically varied metallic CNT contents. In purely metallic CNT films, both and σ monotonically increased with , continuously boosting while increasing . Particularly, in an aligned metallic CNT film, the maximum of was ∼5 times larger than that in the highest-purity (>99%) single-chirality semiconducting CNT film. We attribute these superior thermoelectric properties of metallic CNTs to the simultaneously enhanced and σ of one-dimensional conduction electrons near the first van Hove singularity.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acs.nanolett.9b03022DOI Listing

Publication Analysis

Top Keywords

metallic cnt
12
metallic carbon
8
carbon nanotubes
8
cnt films
8
cnt film
8
metallic
6
thermoelectric
5
cnt
5
solving thermoelectric
4
thermoelectric trade-off
4

Similar Publications

Small regulatory RNAs (sRNAs) are key drivers of bacterial adaptation to environmental fluctuations, including iron and manganese restriction imposed by the host. This study explored the repertoire of sRNAs produced by the human pathogen in response to metal limitation. Two sRNAs, S1077 and ZinS (RsaX20), regulated by zinc (Zn) availability, were identified.

View Article and Find Full Text PDF

Nanoconfinement assists the selective generation of singlet oxygen to efficiently remove emerging organic contaminants in soil with a low consumption of oxidant.

J Hazard Mater

August 2025

Shanghai Key Laboratory of Atmospheric Particle Pollution and Prevention, Department of Environmental Science & Engineering, Fudan University, Shanghai 200433, China; Shanghai Institute of Pollution Control and Ecological Security, Shanghai 200092, China. Electronic address:

The application of advanced oxidation processes (AOPs) to remove emerging organic contaminants (EOCs) in soil is a powerful and rapid soil remediation technology, but the diversity of soil components makes the contact between reactive oxygen species (ROS) and pollutants limited, while the large consumption of oxidant still seriously restricts the decontamination performance in soil. Herein, a nanoconfinement strategy has been applied to encapsulate metal oxide FeO to the channels of carbon nanotube, thereby synthesizing a FeO@CNT catalyst to activate peroxydisulfate (PDS) for the selective removal of carbamazepine (CBZ) in soil. FeO@CNT can efficiently activate PDS to oxidize CBZ in soil through a nonradical pathway dominated by singlet oxygen (O).

View Article and Find Full Text PDF

Addressing the challenges of metal particle corrosion and active site loss induced by excessive use of high-concentration hydrogen peroxide (HO) is essential to expand micro/nanomotor (MNM) applications in biological and environmental fields. Herein, a novel hybrid fuel-driven CuFe-CNT/MnO/GOx (GOx, glucose oxidase) micromotor with abundant oxygen vacancy (OV) was successfully constructed for synchronous high-efficiency colorimetric detection and rapid degradation of captopril (CP). Using glucose and low-concentration HO as hybrid fuels, the OV-CuFe-CNT/MnO/GOx micromotor could move at a speed of 107.

View Article and Find Full Text PDF

Integrating carbon nanotubes (CNTs) into electrospun polyvinylidene fluoride (PVDF) fibers is a promising approach for developing conductive and multifunctional materials. This study systematically compared two CNT deposition techniques, electrophoretic deposition (EPD) and dip coating (DC), in terms of their effectiveness in modifying the surface of aligned electrospun PVDF mats. Morphological characterization revealed that EPD produced more homogeneous and compact CNT coatings.

View Article and Find Full Text PDF

Integrating Lithiophilic Gradient Structure with Nano-Ionic Channel Network to Regulate Li Distribution for Dendrite-Free Lithium Metal Anode.

Small

August 2025

Department of Applied Bioengineering, Graduate School of Convergence Science and Technology, Seoul National University, Suwon-si, Gyeonggi-do, 16229, Republic of Korea.

3D Li hosts with lithiophilic gradient structure are extensively explored to mitigate Li dendrite formation by promoting bottom-up Li plating and reducing local current density. However, the absence of well-defined nano-ionic channels in these designs limits their ability to regulate Li distribution, leading to uncontrolled Li dendrite growth under high current densities and large areal capacities. Herein, this study presents a novel graphene-based 3D Li host that integrates nano-ionic channel network into a lithiophilic gradient structure, denoted as IC-GGLH.

View Article and Find Full Text PDF