CFD simulation of gas and non-Newtonian fluid two-phase flow in anaerobic digesters.

Water Res

Philadelphia Mixing Solutions Ltd., Palmyra, PA 17078, USA.

Published: July 2010


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

This paper presents an Eulerian multiphase flow model that characterizes gas mixing in anaerobic digesters. In the model development, liquid manure is assumed to be water or a non-Newtonian fluid that is dependent on total solids (TS) concentration. To establish the appropriate models for different TS levels, twelve turbulence models are evaluated by comparing the frictional pressure drops of gas and non-Newtonian fluid two-phase flow in a horizontal pipe obtained from computational fluid dynamics (CFD) with those from a correlation analysis. The commercial CFD software, Fluent12.0, is employed to simulate the multiphase flow in the digesters. The simulation results in a small-sized digester are validated against the experimental data from literature. Comparison of two gas mixing designs in a medium-sized digester demonstrates that mixing intensity is insensitive to the TS in confined gas mixing, whereas there are significant decreases with increases of TS in unconfined gas mixing. Moreover, comparison of three mixing methods indicates that gas mixing is more efficient than mixing by pumped circulation while it is less efficient than mechanical mixing.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.watres.2010.04.043DOI Listing

Publication Analysis

Top Keywords

gas mixing
20
non-newtonian fluid
12
mixing
9
gas non-newtonian
8
fluid two-phase
8
two-phase flow
8
anaerobic digesters
8
multiphase flow
8
gas
7
cfd simulation
4

Similar Publications

Objective: While associations of ultra-processed food (UPF) consumption with adverse health outcomes are accruing, its environmental and food biodiversity impacts remain underexplored. This study examines associations between UPF consumption and dietary greenhouse gas emissions (GHGe), land use, and food biodiversity.

Design: Prospective cohort study.

View Article and Find Full Text PDF

Impact of sustainable diets on micronutrient intakes and status: outcomes of the MyPlanetDiet randomized controlled trial.

Am J Clin Nutr

September 2025

Cork Centre for Vitamin D and Nutrition Research, School of Food and Nutritional Sciences, University College Cork, Cork, Ireland. Electronic address:

Background: Data from dietary intervention studies to test the ability of sustainable diets to meet micronutrient (MN) requirements is required.

Objective: To compare MN intakes and status among adults who received dietary counselling to follow a sustainable diet or a standard healthy diet.

Methods: We conducted a single-blind, randomized controlled trial among 355 healthy adults aged 18-64 years in three centers over 12-weeks.

View Article and Find Full Text PDF

ZnO dual-functional template-assisted construction of hierarchical porous hard carbon anode for high-rate sodium storage.

J Colloid Interface Sci

September 2025

College of New Energy and Materials, State Key Laboratory of Heavy Oil Processing, China University of Petroleum, Beijing, Changping, 102249, China.. Electronic address:

Hard carbon has emerged as the most widely studied and commercialized anode material for sodium-ion batteries (SIBs). However, improving the charge transfer kinetics within the plateau potential range of the hard carbon anode is crucial for the development of fast-charging SIBs. In this study, we prepared a novel composite material, ZAPA-1300, by uniformly mixing starch, asphalt, and zinc oxide (ZnO), followed by a two-step treatment process.

View Article and Find Full Text PDF

This study investigated the pyrolysis of mixed medical waste (MMW) in an indirectly heated rotary kiln, focusing on the effects of operating parameters (filling ratio, heat source temperature, and rotation speed) on the heat transfer performance and product distribution. The pyrolysis behaviors of individual components (cotton swabs, paper, bandages, and plastics) and their composite mixtures were characterized using thermogravimetric-differential thermal analysis (TG-DTA). The heat transfer characteristics, chemical reaction properties, kiln operating parameters, and interactions between the processes were also investigated.

View Article and Find Full Text PDF

In vitro simulation of rumen fermentation is critical for improving feed efficiency, assessing dietary interventions, and supporting methane mitigation strategies in ruminant production systems. However, existing fermentation platforms are often expensive, technically complex, or poorly suited for long-term microbial viability under near-rumen conditions-especially in resource-limited settings. This study presents the development and validation of a modular, low-cost engineered to replicate key physiological parameters of the rumen, including temperature control (39-40 °C), continuous buffering via artificial saliva infusion, anaerobic regulation, and simulated motility through mixing pumps.

View Article and Find Full Text PDF