Ab initio study of hydrogen-bond formation between aliphatic and phenolic hydroxy groups and selected amino acid side chains.

J Phys Chem A

Center for Drug Design and Development, College of Pharmacy, The University of Toledo, Toledo, Ohio 43606-3390, USA.

Published: May 2008


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Hydrogen bonding was studied in 24 pairs of isopropyl alcohol and phenol as one partner, and water and amino-acid mimics (methanol, acetamide, neutral and protonated imidazole, protonated methylalamine, methyl-guanidium cation, and acetate anion) as the other partner. MP2/6-31+G* and MP2/aug-cc-pvtz calculations were conducted in the gas phase and in a model continuum dielectric environment with dielectric constant of 15.0. Structures were optimized in the gas phase with both basis sets, and zero-point energies were calculated at the MP2/6-31+G* level. At the MP2/aug-cc-pvtz level, the BSSE values from the Boys-Bernardi counterpoise calculations amount to 10-20 and 5-10% of the uncorrected binding energies of the neutral and ionic complexes, respectively. The geometry distortion energy upon hydrogen-bond formation is up to 2 kcal/mol, with the exception of the most strongly bound complexes. The BSSE-corrected MP2/aug-cc-pvtz binding energy of -27.56 kcal/mol for the gas-phase acetate...phenol system has been classified as a short and strong hydrogen bond (SSHB). The CH3NH3+...isopropyl alcohol complex with binding energy of -22.54 kcal/mol approaches this classification. The complete basis set limit (CBS) for the binding energy was calculated for twelve and six complexes on the basis of standard and counterpoise-corrected geometry optimizations, respectively. The X...Y distances of the X-H...Y bridges differ by up to 0.03 A as calculated by the two methods, whereas the corresponding CBS energy values differ by up to 0.03 kcal/mol. Uncorrected MP2/aug-cc-pvtz hydrogen-bonding energies are more negative by up to 0.35 kcal/mol than the MP2/CBS values, and overestimate the CCSD(T)/CBS binding energies generally by up to 5% for the eight studied complexes in the gas phase. The uncorrected MP2/aug-cc-pvtz binding energies decreased (in absolute value) by 11-18 kcal/mol for the ionic species and by up to 5 kcal/mol for the neutral complexes when the electrostatic effect of a polarizable model environment was considered. The DeltaECCSD(T) - DeltaEMP2 corrections still remained close to their gas-phase values for four complexes with 0, +/-1 net charges. Good correlations (R2 = 0.918-0.958) for the in-environment MP2/aug-cc-pvtz and MP2/6-31+G* hydrogen-bonding energies facilitate the high-level prediction of these energies on the basis of relatively simple MP2/6-31+G* calculations.

Download full-text PDF

Source
http://dx.doi.org/10.1021/jp7108847DOI Listing

Publication Analysis

Top Keywords

gas phase
12
binding energies
12
binding energy
12
hydrogen-bond formation
8
mp2/aug-cc-pvtz binding
8
differ 003
8
uncorrected mp2/aug-cc-pvtz
8
hydrogen-bonding energies
8
energies
7
kcal/mol
7

Similar Publications

Antiferroelectric SnO Network with Amorphous Surface for Electrochemical N Fixation.

Angew Chem Int Ed Engl

September 2025

State Key Laboratory of Bioinspired Interfacial Materials Science, Bioinspired Science Innovation Center, Hangzhou International Innovation Institute, Beihang University, Hangzhou, 311115, China.

Electrochemical nitrogen fixation-a sustainable pathway for converting abundant N into NH using renewable energy-holds transformative potential for revolutionizing artificial nitrogen cycles. Nevertheless, even the state-of-the-art catalytic systems also suffer from inadequate N adsorption capacity, which critically limits ammonia production rates and Faradaic efficiency (FE). To overcome this bottleneck, we strategically leveraged the antiferroelectric properties of SnO to establish dipole-dipole interactions with N molecules, synergistically enhancing both N adsorption and activation kinetics.

View Article and Find Full Text PDF

Boosting biocompatibility and minimizing inflammation in electrospun polyvinylidene fluoride (PVDF) cardiac patches through optimized low-pressure plasma treatment.

Biomater Adv

September 2025

Department of Applied Science and Technology (DISAT), Politecnico di Torino, Corso Duca Degli Abruzzi 24, 10129 Torino, Italy.

Tailoring surface characteristics is key to guiding scaffold interaction with the biological environment, promoting successful biointegration while minimizing immune responses and inflammation. In cardiac tissue engineering, polyvinylidene fluoride (PVDF) is a material of choice for its intrinsic piezoelectric properties, which can be enhanced through electrospinning, also enabling the fabrication of nanofibrous structures mimicking native tissue. However, the inherent hydrophobicity of PVDF can hinder its integration with biological tissues.

View Article and Find Full Text PDF

Research Progress of Surfactant-Free Microemulsions: A Review.

Crit Rev Anal Chem

September 2025

Department of Civil Engineering, Architecture and Engineering, Northeast Petroleum University, Daqing, China.

Surfactant is usually considered the key component to form microemulsion. surfactant-based microemulsion (SBME) can also be called traditional microemulsion. It has a wide range of applications.

View Article and Find Full Text PDF

Surfactant-enhanced aquifer remediation (SEAR) is an effective strategy for removing dense non-aqueous phase liquids (DNAPLs) from contaminated groundwater. While Gemini surfactants possess unique dimeric structures and excellent physicochemical properties, the role of hydrophobic chain length in governing their solubilization performance has not been systematically clarified. Here, five sugar-based anionic-nonionic Gemini surfactants (SANG 06, 08, 09, 10, and 13) with different hydrophobic chain lengths were synthesized and evaluated.

View Article and Find Full Text PDF

BiOCl@Polypyrrole metal catalysts with a core-shell structure to construct high-safety and stable lithium‑sulfur batteries.

J Colloid Interface Sci

August 2025

Beijing Key Laboratory of Advanced Functional Polymer Composites, Beijing University of Chemical Technology, Beijing 100029, China. Electronic address:

Lithium‑sulfur batteries (LSBs) are promising alternatives to lithium-ion batteries due to their high energy density and low cost. However, issues like the lithium polysulfide (LiPSs) shuttle effect, lithium dendrite growth, and flammable electrolytes hinder commercialization. In this study, we have developed a metal-based catalyst, bismuth oxychloride (BiOCl) nanoflowers coated with conductive polypyrrole (Bi@Ppy), via hydrothermal synthesis.

View Article and Find Full Text PDF