One-Component Catalytic Electrodes from Metal-Organic Frameworks Covalently Linked to an Anion Exchange Ionomer.

Anion-conducting organic-inorganic polymers (OIPs), constructed using metal-organic framework (MOF)-like structures with non-toxic, non-rare catalytic metals (Fe, Zr), have been developed. The incorporation of MOF-like structures imparts porosity to the polymers, classifying them as porous organic polymers (POPs). The combination between catalytic activity, ion conduction, and porosity allows the material to act as one-component catalytic electrodes.

Anaerobic treatment of groundwater co-contaminated by toluene and copper in a single chamber bioelectrochemical system.

Addressing the simultaneous removal of multiple coexisting groundwater contaminants poses a significant challenge, primarily because of their different physicochemical properties. Indeed, different chemical compounds may necessitate establishing distinct, and sometimes conflicting, (bio)degradation and/or removal pathways. In this work, we investigated the concomitant anaerobic treatment of toluene and copper in a single-chamber bioelectrochemical cell with a potential difference of 1 V applied between the anode and the cathode.

Direct Laser Writing of Chitosan-Borax Composites: Toward Sustainable Electrochemical Sensors.

In this study, the laser-induced graphitization process of sustainable chitosan-based formulations was investigated. In particular, optimal lasing conditions were investigated alongside the effect of borax concentration in the chitosan matrix. In all cases, it was found that the obtained formulations were graphitizable with a CO laser.

Multi-Technique Approach for Work Function Exploration of ScO Thin Films.

Thin films based on scandium oxide (ScO) were deposited on silicon substrates to investigate the thickness effect on the reduction of work function. X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), energy dispersive X-ray reflectivity (EDXR), atomic force microscopy (AFM), and ultraviolet photoelectron spectroscopy (UPS) measurements were performed on the films deposited by electron-beam evaporation with different nominal thicknesses (in the range of 2-50 nm) and in multi-layered mixed structures with barium fluoride (BaF) films. The obtained results indicate that non-continuous films are required to minimize the work function (down to 2.

Ag/AgPO Nanoparticle-Decorated Hydroxyapatite Functionalized Calcium Carbonate: Ultrasound-Assisted Sustainable Synthesis, Characterization, and Antimicrobial Activity.

Silver nanoparticles are usually prepared by the reduction of silver cations through chemical and non-sustainable procedures that involve the use of reducing chemical agents. Therefore, many efforts have been made in the search for sustainable alternative methods. Among them, an ultrasound-assisted procedure could be a suitable and sustainable method to afford well-dispersed and nanometric silver particles.

Thin-Film Heterostructures Based on Co/Ni Synthetic Antiferromagnets on Polymer Tapes: Toward Sustainable Flexible Spintronics.

Synthetic antiferromagnets with perpendicular magnetic anisotropy (PMA-SAFs) have gained growing attention for both conventional and next-generation spin-based technologies. While the progress of PMA-SAF spintronic devices on rigid substrates has been remarkable, only few examples of flexible thin-film heterostructures are reported in the literature, all containing platinum group metals (PGMs). Systems based on Co/Ni may offer additional advantages with respect to devices containing PGMs, i.

Hybrid Graphenene Oxide/Cellulose Nanofillers to Enhance Mechanical and Barrier Properties of Chitosan-Based Composites.

Chitosan-based hybrid nanocomposites, containing cellulose nanocrystals (CNCs), graphene oxide (GO), and borate as crosslinking agents, were successfully prepared by solution-casting technique. The synergistic effect of the two fillers, and the role of the cross-linker, in enhancing the structural and functional properties of the chitosan polymer, was investigated. XPS results confirm the chemical interaction between borate ions and hydroxyl groups of chitosan, GO, and CNCs.

Extra-Low Dosage Graphene Oxide Cementitious Nanocomposites: A Nano- to Macroscale Approach.

The impact of extra-low dosage (0.01% by weight of cement) Graphene Oxide (GO) on the properties of fresh and hardened nanocomposites was assessed. The use of a minimum amount of 2-D nanofiller would minimize costs and sustainability issues, therefore encouraging the market uptake of nanoengineered cement-based materials.

Hydroxyapatite Functionalized Calcium Carbonate Composites with Ag Nanoparticles: An Integrated Characterization Study.

In the present work, composite materials very promising for biomedical and pharma-ceutical applications were investigated. They are composed of silver nanoparticles (Ag NPs) in a matrix constituted of calcium carbonate functionalized with hydroxyapatite (HA-FCC). The composites were obtained by different synthesis methods, starting from a mixture of the silver acetate with HA-FCC (using adsorption or mixing in wet conditions methods) and then treating them by exposure to visible light or calcination to promote the silver reduction; a synthetic procedure based on ultrasound-assisted reduction with NaBH or citrate was also carried out.

Three-Dimensional X-ray Imaging of β-Galactosidase Reporter Activity by Micro-CT: Implication for Quantitative Analysis of Gene Expression.

Acquisition of detailed anatomical and molecular knowledge from intact biological samples while preserving their native three-dimensional structure is still a challenging issue for imaging studies aiming to unravel a system's functions. Three-dimensional micro-CT X-ray imaging with a high spatial resolution in minimally perturbed naive non-transparent samples has recently gained increased popularity and broad application in biomedical research. Here, we describe a novel X-ray-based methodology for analysis of () reporter-driven gene expression in an intact murine brain ex vivo by micro-CT.

Lead-Bismuth Eutectic: Atomic and Micro-Scale Melt Evolution.

Element clustering and structural features of liquid lead-bismuth eutectic (LBE) alloy have been investigated up to 720 °C by means of high temperature X-ray diffraction (HT-XRD), X-ray Photoemission Spectroscopy (XPS) and Scanning Photoemission Microscopy (SPEM) at the Elettra synchrotron in Trieste. The short-range order in liquid metal after melting corresponds to the cuboctahedral atomic arrangement and progressively evolves towards the icosahedral one as temperature increases. Such process, that involve a negative expansion of the alloy, is mainly connected to the reduction of atom distance in Pb-Pb pairs which takes place from 350 °C to 520 °C.

Room temperature Co-doped manganite/graphene sensor operating at high pulsed magnetic fields.

The demand to increase the sensitivity to magnetic field in a broad magnetic field ranges has led to the research of novel materials for sensor applications. Therefore, the hybrid system consisting of two different magnetoresistive materials - nanostructured Co-doped manganite LaSr(MnCo)O and single- and few-layer graphene - were combined and investigated as potential system for magnetic field sensing. The negative colossal magnetoresistance (CMR) of manganite-cobaltite and positive one of graphene gives the possibility to increase the sensitivity to magnetic field of the hybrid sensor.

Correction: High piezo-resistive performances of anisotropic composites realized by embedding rGO-based chitosan aerogels into open cell polyurethane foams.

Correction for 'High piezo-resistive performances of anisotropic composites realized by embedding rGO-based chitosan aerogels into open cell polyurethane foams' by Tianliang Zhai et al., Nanoscale, 2019, 11, 8835-8844.

Resin-Based Materials with Chlorhexidine-Loaded MCM-41: Surface Characteristics, Drug Release, and Antibiofilm Activity.

Poly(methyl methacrylate) resins containing chlorhexidine diacetate (CHX)-loaded mesoporous silicate MCM-41 have the ability to prevent biofilm adhesion and growth over time. With the aim of increasing knowledge of the drug release and surface properties of these materials and their relationship with antibiofilm activity, in this paper an acrylic-based resin containing CHX-loaded spherical and narrow size silanized MCM-41 was prepared. Resins containing CHX but no filler were prepared as well and compared.

Discriminating between Different Heavy Metal Ions with Fullerene-Derived Nanoparticles.

A novel type of graphene-like nanoparticle, synthesized by oxidation and unfolding of C buckminsterfullerene fullerene, showed multiple and reproducible sensitivity to Cu, Pb, Cd, and As(III) through different degrees of fluorescence quenching or, in the case of Cd, through a remarkable fluorescence enhancement. Most importantly, only for Cu and Pb, the fluorescence intensity variations came with distinct modifications of the optical absorption spectrum. Time-resolved fluorescence study confirmed that the common origin of these diverse behaviors lies in complexation of the metal ions by fullerene-derived carbon layers, even though further studies are required for a complete explanation of the involved processes.

Nanocluster superstructures or nanoparticles? The self-consuming scaffold decides.

We show that using the same reaction procedure, by hindering or allowing the formation of a reaction intermediate, the Ag+dodecanethiolate polymeric complex, it is possible to selectively obtain Ag dodecanethiolate nanoparticles or Ag dodecanethiolate nanoclusters in the size range 4-2 nm. Moreover, the Ag dodecanethiolate nanoclusters display a lamellar superstructure templated from the precursor Ag+dodecanethiolate polymeric complex. A plausible formation mechanism is illustrated where, starting from the precursor and scaffold lamellar Ag+ thiolate polymeric complex, first the nanocluster Agn0 core is formed by reduction of isoplanar Ag+ ions, followed by Ag+ thiolate units that build protection, the nanocluster shell, around the core.

Corrigendum: Inorganic Photocatalytic Enhancement: Activated RhB Photodegradation by Surface Modification of SnO Nanocrystals with VO-like species.

This corrects the article DOI: 10.1038/srep44763.

Bottom-Up Electrochemical Deposition of Poly(styrene sulfonate) on Nanoarchitectured Electrodes.

The cathodic deposition of poly(styrene sulfonate) on nanoarchitectured TiO electrodes is explored by cyclic voltammetry and potentiostatic and galvanostatic experiments, showing a diffusion-controlled deposition described by Cottrell's law. The structure and composition of the polymer is evidenced by various spectroscopic techniques, including nuclear magnetic resonance, Fourier transform infrared, and X-ray photoelectron spectroscopy, and its morphology is studied by scanning electron microscopy. The average chain length can be estimated from the NMR spectra.

Inorganic Photocatalytic Enhancement: Activated RhB Photodegradation by Surface Modification of SnO Nanocrystals with VO-like species.

SnO nanocrystals were prepared by precipitation in dodecylamine at 100 °C, then they were reacted with vanadium chloromethoxide in oleic acid at 250 °C. The resulting materials were heat-treated at various temperatures up to 650 °C for thermal stabilization, chemical purification and for studying the overall structural transformations. From the crossed use of various characterization techniques, it emerged that the as-prepared materials were constituted by cassiterite SnO nanocrystals with a surface modified by isolated V(IV) oxide species.

The "Oil-Spill Snorkel": an innovative bioelectrochemical approach to accelerate hydrocarbons biodegradation in marine sediments.

This study presents the proof-of-concept of the "Oil-Spill Snorkel": a novel bioelectrochemical approach to stimulate the oxidative biodegradation of petroleum hydrocarbons in sediments. The "Oil-Spill Snorkel" consists of a single conductive material (the snorkel) positioned suitably to create an electrochemical connection between the anoxic zone (the contaminated sediment) and the oxic zone (the overlying O2-containing water). The segment of the electrode buried within the sediment plays a role of anode, accepting electrons deriving from the oxidation of contaminants.

Chitosan films containing mesoporous SBA-15 supported silver nanoparticles for wound dressing.

Chitosan films containing mesoporous SBA-15 supported silver nanoparticles (AgNPs) were prepared to be applied as a potential wound dressing material. First SBA-15-silver nanoparticle (SBA-15-Ag) composite materials were prepared by a controlled annealing process without the use of organic solvents and reagents. The SBA-15-AgNPs were characterized in detail by X-ray powder diffraction, field emission scanning electron microscopy and transmission electron microscopy which evidenced the presence of uniformly distributed silver nanostructures inside the silicate pores.

High yield synthesis of pure alkanethiolate-capped silver nanoparticles.

One-phase, one-pot synthesis of Ag(0) nanoparticles capped with alkanethiolate molecules has been optimized to easily achieve a pure product in quantitative yield. We report the synthesis of dodecanethiolate-capped silver particles and the chemophysical, structural, and morphologic characterization performed by way of UV-vis, (1)H NMR, and X-ray photoelectron (XPS) spectroscopies, X-ray powder diffraction (XRD) and X-ray absorption fine structure analysis (XFAS), electron diffraction and high-resolution transmission electron microscopy (HR-TEM), and scanning and transmission electron microscopy (SEM and TEM). Depending on the molar ratio of the reagents (dodecylthiosulphate/Ag(+)), the mean Ag(0) particle size D(XRD) is tuned from 4 to 3 nm with a narrow size distribution.