Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Spent coffee grounds (SCGs) are lignocellulosic residues generated from producing espresso or soluble coffee and have no commercial value. This study aimed to develop a new single-step process for extracting bioactive compounds from SCGs based on ultrasonication in an aqueous medium and simultaneously recovering the residual solid fraction, resulting in the integral utilization of the residue. This process resulted in a liquid aqueous extract (LAE) rich in bioactive compounds (caffeine: 400.1 mg/100 g; polyphenols: 800.4 mg GAE/100 g; melanoidins: 2100.2 mg/100 g) and, simultaneously, a solid multifunctional ingredient from modified spent coffee grounds (MSCGs) rich in bioactive compounds and dietary fibers (73.0 g/100 g). The liquid extract can be used as a natural ingredient for drinks or to isolate caffeine, while the solid matrix can be used to produce functional foods. This technique proved to be a promising eco-friendly alternative for the simultaneous production of two different materials from SCGs, maximizing resource efficiency, with some advantages, including short time, simplicity, and cost-effectiveness; using water as a solvent; and requiring no further purification processing.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC12348768PMC
http://dx.doi.org/10.3390/molecules30153117DOI Listing

Publication Analysis

Top Keywords

spent coffee
12
coffee grounds
12
bioactive compounds
12
simultaneous production
8
rich bioactive
8
ultrasonication-assisted green
4
green process
4
process simultaneous
4
bioactive
4
production bioactive
4

Similar Publications

The impact of extraction methods on the structural and physicochemical properties of polysaccharides from spent coffee grounds and their potential as food packaging co-ingredients.

Int J Biol Macromol

August 2025

School of Food Science and Biotechnology, Zhejiang Gongshang University, Hangzhou 310018, China; Center for Future Food, Muyuan Laboratory, Zhengzhou 450000, China. Electronic address:

Global coffee consumption generates significant environmental concerns, particularly from spent coffee grounds (SCG). As a rich source of carbohydrates, SCG holds promise for isolating polysaccharides suitable for food applications. This study investigated how different extraction methods, including acid (A), hot water (W), and alkaline (AL) extractions, affect the structural characteristics and functional properties of SCG-derived polysaccharides (CPs).

View Article and Find Full Text PDF

In this study, a process optimization strategy was established to enhance the efficiency of manno-oligosaccharides (MOS) production from spent coffee grounds (SCG), using a sequential approach of aqueous ammonia pretreatment and surfactant-assisted enzymatic hydrolysis. Aqueous ammonia pretreatment (25 % NH₃·H₂O, 70 °C, 48 h) significantly disrupted the lignocellulosic matrix, achieving 67.1 % lignin removal and resulting in more than a threefold increase in MOS yield.

View Article and Find Full Text PDF

Recovery of cellulose from biomass waste for 3D printing of slow-release hydrogel scaffolds.

Environ Res

August 2025

State Key Laboratory of Green Papermaking and Resource Recycling, School of Environmental Science & Engineering, Shanghai Jiao Tong University, 800 Dongchuan Road, Shanghai, 200240, China. Electronic address:

Here, following the waste-to-value principle, cellulose extracted from spent coffee grounds was modified to fabricate cargo-loaded hydrogel scaffolds via 3D printing, thereby enhancing resource utilization efficiency. Initially, FTIR spectroscopy confirmed the removal of non-cellulosic fractions, yielding cellulose over 10 %, which was subsequently converted into carboxymethyl cellulose through the etherification process. Furthermore, the concrete inks prepared from two hydrogel microparticles that were made from recovered carboxymethyl cellulose and their photo-crosslinked hydrogels exhibited distinct property characteristics, establishing a foundation for selecting an appropriate formulation for hydrogel scaffold printing.

View Article and Find Full Text PDF

This study aimed to develop novel oleogels using whey protein (WP) and bacterial cellulose nanowhiskers (BCNW) to expand the potential applications of spent coffee grounds oil (SCGO). An emulsion-templated approach was employed to structure SCGO with varying WP:SCGO ratios, while the incorporation of BCNW was evaluated as a potential stabilizing and reinforcing agent. All oleogels behaved as "true" gels (tan δ < 0.

View Article and Find Full Text PDF