Acid-resistant iron sludge-based fly ash geopolymer foam for efficient arsenic removal with pH self-regulation.

Environ Res

Key Laboratory of Water Quality Science and Water Environment Recovery Engineering, Beijing University of Technology, Beijing, 100124, China. Electronic address:

Published: July 2025


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Acidic arsenic-containing wastewater requires efficient treatment technologies due to its high toxicity and environmental risks. This study developed a novel adsorbent (Iron Sludge-Based Fly Ash Geopolymer Foam) by combining fly ash-based geopolymer foam as a carrier with iron-containing sludge, aiming to synergistically enhance arsenic adsorption performance and pH self-regulation under acidic conditions. By adjusting the iron sludge content to optimize the porous structure and mechanical properties, the optimal fly ash/iron sludge ratio was determined to be 4:1. Characterization analysis revealed that iron oxides were uniformly dispersed as nanoparticles within the silica-alumina matrix, forming abundant three-coordinate iron hydroxyl groups (≡Fe-OH) as active sites along with a gradient pore structure. The adsorption isotherm conformed to the Sips model with a fitted adsorption capacity of 77 ± 9 mg/g and achieved 98.34 % arsenic removal at an initial concentration of As(V) of C = 1 g/L, the initial pH of 2.5, and a dosing rate of 0.6 g/L. The adsorption process followed a pseudo-second-order kinetic model, dominated by coordination interactions, where the chemical bonding between iron hydroxyl groups and arsenic effectively overcame the surface protonation inhibition under acidic conditions. Adsorption-desorption cycle experiments confirmed the material's excellent regeneration ability (removal efficiency >95 % after five cycles). Dynamic column experiments demonstrated that the material could continuously treat 2340 bed volumes of wastewater while maintaining an effluent arsenic concentration below 10 μg/L. A dual-column series process optimization was proposed to enhance the system's pH regulation performance. This study provides theoretical support and a technical pathway for the resource utilization of industrial solid waste and the "waste-to-treat-waste" approach for acidic wastewater treatment.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.envres.2025.122432DOI Listing

Publication Analysis

Top Keywords

geopolymer foam
12
iron sludge-based
8
sludge-based fly
8
fly ash
8
ash geopolymer
8
arsenic removal
8
self-regulation acidic
8
acidic conditions
8
iron hydroxyl
8
hydroxyl groups
8

Similar Publications

This study develops a novel geopolymer foamed concrete using coal gangue and slag as precursors, along with a composite alkali activator comprising sodium silicate and sodium hydroxide, based on the physical foaming method. The Box-Behnken Design within Response Surface Methodology was applied to optimize the mix proportions of coal gangue-slag-based geopolymer foamed concrete. The effects of alkali activator dosage, sodium silicate modulus, water-to-binder ratio, and foam content on 28-day compressive strength and thermal conductivity were systematically investigated to determine the optimal mix for achieving a balance between mechanical and thermal performance.

View Article and Find Full Text PDF

This study presents a sustainable approach to producing geopolymer foam concrete by incorporating sewage sludge ash (SSA), a porous, aluminosilicate-rich byproduct of sewage sludge incineration. The effects of SSA dosage, alkaline activator modulus, and foam stabilizer content on the physical properties, microstructure, phase composition, carbon footprint, and thermal insulation performance of SSA-enhanced geopolymer foam concrete (SGFC) were systematically investigated. The results indicated that the SGFC exhibited optimal performance with a 30 % SSA dosage, an alkali activator modulus of 1.

View Article and Find Full Text PDF

Acid-resistant iron sludge-based fly ash geopolymer foam for efficient arsenic removal with pH self-regulation.

Environ Res

July 2025

Key Laboratory of Water Quality Science and Water Environment Recovery Engineering, Beijing University of Technology, Beijing, 100124, China. Electronic address:

Acidic arsenic-containing wastewater requires efficient treatment technologies due to its high toxicity and environmental risks. This study developed a novel adsorbent (Iron Sludge-Based Fly Ash Geopolymer Foam) by combining fly ash-based geopolymer foam as a carrier with iron-containing sludge, aiming to synergistically enhance arsenic adsorption performance and pH self-regulation under acidic conditions. By adjusting the iron sludge content to optimize the porous structure and mechanical properties, the optimal fly ash/iron sludge ratio was determined to be 4:1.

View Article and Find Full Text PDF

This study aims to investigate the mechanical, physical, durability and microstructure of slag-based and environmentally friendly foam geopolymer concrete with glass and polypropylene fiber hybridization using sustainable materials such as waste marble dust, silica fume (SF) and sodium metasilicate. One of the most critical advantages of geopolymer concrete compared to traditional Portland cement is its low carbon emissions. In the study, foam geopolymer concrete was produced using glass fiber (GF) and polypropylene fiber (PPF) additives and three different silica fume ratios (0%, 7.

View Article and Find Full Text PDF

To address the demands of the low-carbon era, this study proposed a solution by using eggshell powder (ESP), fly ash, and ground granulated blast furnace slag together with alkaline solution in the preparation of lightweight geopolymer foam concrete (LWGFC). The aim of this study is to investigate the influence of replacing precursor materials with 5-20% ESP on the expansion behavior, physical, mechanical characteristics, and thermal conductivity of LWGFC. Additionally, the study examines the effect of varying the silicate modulus (SiO/NaO ratios of 1.

View Article and Find Full Text PDF