Impact of vehicles at the roadside of expressway in urban area: Simultaneous measurement of particle size distribution and positive matrix factorization.

Sci Total Environ

Center for Sustainable Environment Research, Korea Institute of Science and Technology, Hwarangro 14-gil 5, Seongbuk-gu, Seoul 02792, Republic of Korea; Graduate School of Energy and Environment(KU-KIST GREEN SCHOOL), Korea University, 145 Anam-ro, Seongbuk-gu, Seoul 02841, Republic of Korea. Electr

Published: November 2024


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

This study conducted real-time monitoring of size-resolved particle concentrations ranging from 9 nm to 10 μm simultaneously at four sites on the park ground and the roof of a five-story apartment buildings in the upwind and downwind areas of the Olympic Expressway next to apartment complex areas of Seoul, Korea. Using a positive matrix factorization model for source apportionment, eight factors were resolved at each monitoring site: four exhaust emissions of vehicles, one non-exhaust emission of vehicle, two regional sources, and one unknown source. After categorizing monitoring data into three cases by wind conditions, impact and contribution of each vehicle-related source on the local road to the roadside pollution was quantified and characterized by subtracting the urban background concentrations. Throughout the measurement period, the contribution of vehicle-related sources to the particle number concentration at each monitoring site ranged from 61 % to 69 %, while that to the particle mass concentration ranged from 39 % to 87 %. During periods of steady traffic flow and wind blowing from the road to three downwind sites at speeds exceeding >0.5 m/s during working hours, the particle number concentrations at the downwind sites were 2.2-2.5 times higher than the average levels. Among vehicle-related sources, gasoline vehicles with multiple injections or high-emitting diesel vehicles showed the highest contribution to particle number concentrations at all sites. As wind speed increased, the number concentrations of particles from vehicle exhaust and non-exhaust emissions decreased and increased, respectively, probably due to enhanced dilution and transport, respectively. In addition, particle number concentrations showed a parabolic curve-like trend with traffic volumes increasing to approximately 10,000 vehicles/h, and then decreasing for both vehicle exhaust and non-exhaust emissions. These results can be utilized in numerical modeling studies and in establishing traffic-related environmental policies to reduce seasonal and temporal particle exposure near the roadsides.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.scitotenv.2024.175051DOI Listing

Publication Analysis

Top Keywords

particle number
16
number concentrations
16
particle
8
positive matrix
8
matrix factorization
8
monitoring site
8
contribution vehicle-related
8
vehicle-related sources
8
downwind sites
8
vehicle exhaust
8

Similar Publications

Hydrodynamic focusing to synthesize lipid-based nanoparticles: Computational and experimental analysis of chip design and formulation parameters.

J Control Release

September 2025

Institute of Biomedical Engineering, University of Toronto, Toronto, Ontario M5S 3G9, Canada; The Keenan Research Centre for Biomedical Science of St. Michael's Hospital, Unity Health Toronto, Toronto, Ontario M5B 1T8, Canada; Leslie Dan Faculty of Pharmacy, University of Toronto, Toronto, Ontario M

Microfluidic hydrodynamic focusing (HF) has emerged as a powerful platform for the controlled synthesis of lipid nanoparticles (LNPs) and liposomes, offering superior precision, reproducibility, and scalability compared to traditional batch methods. However, the impact of HF inlet configuration and channel geometry on nanoparticle formation remains poorly understood. In this study, we present a comprehensive experimental and computational analysis comparing 2-inlet (2-way) and 4-inlet (4-way) HF designs across various sheath inlet angles (45°, 90°, 135°) and cross-sectional geometries (square vs.

View Article and Find Full Text PDF

Particle stabilised high internal phase emulsion scaffolds with interconnected porosity facilitate cell migration.

Biomed Mater

September 2025

School of Chemical, Materials and Biological Engineering, The University of Sheffield, Pam Liversidge Building, Mappin Street, Sheffield, S1 3JD, UNITED KINGDOM OF GREAT BRITAIN AND NORTHERN IRELAND.

A key challenge in bone tissue engineering (BTE) is designing structurally supportive scaffolds, mimicking the native bone matrix, yet also highly porous to allow nutrient diffusion, cell infiltration, and proliferation. This study investigated the effect of scaffold interconnectivity on human bone marrow stromal cell (BMSC) behaviour. Highly interconnected, porous scaffolds (polyHIPEs) were fabricated using the emulsion templating method from 2-ethylhexyl acrylate/isobornyl acrylate (IBOA) and stabilised with ~200 nm IBOA particles.

View Article and Find Full Text PDF

Submicron metal-bearing aerosols from an industrial hub of the North China Plain.

J Hazard Mater

September 2025

Faculty of Environmental and Symbiotic Sciences, Prefectural University of Kumamoto, Kumamoto 862-8502, Japan. Electronic address:

Particulate matter emitted from heavy industries is a major source of atmospheric metals in the North China Plain (NCP). In this study, submicron particles (0.1-1.

View Article and Find Full Text PDF

Positive Neutrino Masses with DESI DR2 via Matter Conversion to Dark Energy.

Phys Rev Lett

August 2025

National Astronomical Observatories, Chinese Academy of Sciences, A20 Datun Road, Chaoyang District, Beijing, 100101, Peoples Republic of China.

The Dark Energy Spectroscopic Instrument (DESI) is a massively parallel spectroscopic survey on the Mayall telescope at Kitt Peak, which has released measurements of baryon acoustic oscillations determined from over 14 million extragalactic targets. We combine DESI Data Release 2 with CMB datasets to search for evidence of matter conversion to dark energy (DE), focusing on a scenario mediated by stellar collapse to cosmologically coupled black holes (CCBHs). In this physical model, which has the same number of free parameters as ΛCDM, DE production is determined by the cosmic star formation rate density (SFRD), allowing for distinct early- and late-time cosmologies.

View Article and Find Full Text PDF

Interlocked and polycatenated material systems, consisting of discrete, nonconvex particles linked to their nearest neighbors, such as chainmail fabrics, have been shown to undergo a jamming transition that increases their rigidity under boundary compression. This rigidity transition is associated with an increase in contact number between particles. In architected materials, rigidity is described by theories such as the Maxwell criterion.

View Article and Find Full Text PDF