Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

To reduce the incidence of occupational musculoskeletal disorders, back-support exoskeletons are being introduced to assist manual material handling activities. Using a device of this type, this study investigates the effects of a new control strategy that uses the angular acceleration of the user's trunk to assist during lifting tasks. To validate this new strategy, its effectiveness was experimentally evaluated relative to the condition without the exoskeleton as well as against existing strategies for comparison. Using the exoskeleton during lifting tasks reduced the peak compression force on the L5S1 disc by up to 16%, with all the control strategies. Substantial differences between the control strategies in the reductions of compression force, lumbar moment and back muscle activation were not observed. However, the new control strategy reduced the movement speed less with respect to the existing strategies. Thanks to improved timing in the assistance in relation to the typical dynamics of the target task, the hindrance to typical movements appeared reduced, thereby promoting intuitiveness and comfort.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11265403PMC
http://dx.doi.org/10.1017/wtc.2020.8DOI Listing

Publication Analysis

Top Keywords

manual material
8
material handling
8
control strategy
8
lifting tasks
8
existing strategies
8
compression force
8
control strategies
8
control
5
evaluation acceleration-based
4
acceleration-based assistive
4

Similar Publications

Deep feature engineering for accurate sperm morphology classification using CBAM-enhanced ResNet50.

PLoS One

September 2025

School of Computer Science, CHART Laboratory, University of Nottingham, Nottingham, United Kingdom.

Background And Objective: Male fertility assessment through sperm morphology analysis remains a critical component of reproductive health evaluation, as abnormal sperm morphology is strongly correlated with reduced fertility rates and poor assisted reproductive technology outcomes. Traditional manual analysis performed by embryologists is time-intensive, subjective, and prone to significant inter-observer variability, with studies reporting up to 40% disagreement between expert evaluators. This research presents a novel deep learning framework combining Convolutional Block Attention Module (CBAM) with ResNet50 architecture and advanced deep feature engineering (DFE) techniques for automated, objective sperm morphology classification.

View Article and Find Full Text PDF

Psychometric properties of Brachial Plexus outcome measure: COSMIN-based systematic review.

Disabil Rehabil

September 2025

Rehabilitation Sciences Institute, Temerty Faculty of Medicine, University of Toronto, Toronto, Ontario, Canada.

Purpose: Children with incomplete recovery from Brachial Plexus Birth Injury (BPBI) experience varying degrees of upper limb impairment, and 20-30% require interventions to optimize function. A psychometrically validated measure of upper limb activity capacity is essential to guide shared clinical decisions for surgical and rehabilitation interventions.

Materials And Methods: Following the Joanna Briggs Institute Manual for Evidence Synthesis, this systematic review included studies on the measurement properties of the Brachial Plexus Outcome Measure (BPOM) - Activity Scale, a performance-based outcome measure of upper limb activity capacity in children with BPBI.

View Article and Find Full Text PDF

Purpose: To summarize the evidence on the effectiveness of manual therapy (MT) and exercise targeted to the neck or jaw and neck (combined) in the management of orofacial pain (OFP).

Material And Methods: The protocol was registered in PROSPERO (CRD42021227490). Electronic searches were conducted in MEDLINE, EMBASE, Cochrane Library, Web of Science, SCOPUS, and CINAHL.

View Article and Find Full Text PDF

Purpose: To evaluate the impact of an optimized online adaptive radiation therapy workflow on physician involvement.

Methods And Materials: Data from a prospective phase 2 trial involving 34 prostate cancer patients treated with cone beam computed tomography (CBCT)-based online adaptive radiation therapy (62 Gy in 20 fractions) were analyzed. Manual interventions were required for 2 steps in the workflow: radiation therapy technologist review and adjustment of automatically segmented organs, guiding target segmentation, so-called "influencer," while physicians reviewed and refined the targets.

View Article and Find Full Text PDF

Carbon fiber nanotip electrodes (CFNEs) are crucial for electrochemical recordings of neurotransmission release in confined spaces, such as synapses and intracellular measurements. However, fabricating CFNEs with small surface area to minimize noise remains challenging due to inconsistent tip size control, low reproducibility, and low fabrication success rate. Here, we present a reliable, user-friendly method with high reproducibility and success rate for precise CFNE fabrication using microscopy-guided electrochemical etching of cylindrical carbon fiber microelectrodes in a potassium hydroxide droplet.

View Article and Find Full Text PDF