Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Top-gate self-aligned structured oxide thin-film transistors (TFTs) are suitable for the backplanes of high-end displays because of their low parasitic capacitances. The gate insulator (GI) deposition process should be carefully designed to manufacture a highly stable, high-mobility oxide TFT, particularly for a top-gate structure. In this study, a nanometer-thick AlO layer via plasma-enhanced atomic layer deposition (PE-ALD) is deposited on the top-gate bottom-contact structured oxide TFT as the interface tailoring layer, which can also act as the hydrogen barrier to modulate carrier generation from hydrogen incorporation into the active layer of the TFT during the following process such as postannealing. Al-doped InSnZnO (Al/ITZO) with an Al/In/Sn/Zn atomic ratio composition of 1.7:24.3:40:34 was used for high mobility oxide semiconductors, and an AlO/SiN bilayer was used for the GI. The degradation issue due to the excellent barrier characteristics of AlO and SiN can be minimized. An oxide TFT fabricated without the interface tailoring layer exhibits conductor-like characteristics owing to the excessive carrier generation by hydrogen incorporation. However, TFTs with additional interface layers exhibit reasonable characteristics and distinct trends in electrical characteristics depending on the thicknesses of the interface layers. The optimized devices exhibit an average turn-on voltage () of -0.31 V with 33.63 cm/(V s) of high mobility and 0.09 V/dec of subthreshold swing value. The interfaces between the active layer and hydrogen barriers were investigated using a high-resolution transmission electron microscope, contact angle measurement, and secondary ion mass spectroscopy to reveal the origin of the trends in properties between the devices. The top-gate device with a hydrogen barrier using the four-cycle deposition exhibits optimum electrical characteristics of both high mobility and good stability with only a 0.04 V shift of under positive-bias temperature stress (PBTS). We realize a high-end, self-aligned TFT with high mobility [34.7 cm/(V s)] and negligible shift of -0.06 V under PBTS by applying a subnanometer hydrogen barrier.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acsami.3c10185DOI Listing

Publication Analysis

Top Keywords

high mobility
16
interface tailoring
12
tailoring layer
12
hydrogen incorporation
12
oxide tft
12
hydrogen barrier
12
oxide thin-film
8
thin-film transistors
8
structured oxide
8
layer hydrogen
8

Similar Publications

Introduction: No head-to-head studies comparing the efficacy of avalglucosidase alfa (AVA) with cipaglucosidase alfa + miglustat (Cipa+mig) have been conducted in patients with late-onset Pompe disease (LOPD). Two indirect treatment comparisons (ITCs) were conducted to estimate the effects of AVA versus Cipa+mig.

Methods: ITCs were conducted using simulated treatment comparisons (STCs), adjusting for differences in prognostic factors and treatment effect modifiers.

View Article and Find Full Text PDF

The global decline in fertility rates highlights the critical need to enhance individuals' fertility intentions. Using the socio-ecological perspective, we reveal a largely overlooked yet crucial socio-ecological factor that influences individuals' fertility intentions. Specifically, we propose that relational mobility serves as a precursor to fertility intention.

View Article and Find Full Text PDF

Growth of highly uniform 2-inch MoS wafers using liquid precursor spraying.

Nanoscale

September 2025

College of Materials Science and Engineering, Sichuan University, Chengdu 610065, China.

With the progress of study, MoS has been proven to show excellent properties in electronics and optoelectronics, which promotes the fabrication of future novel integrated circuits and photodetectors. However, highly uniform wafer-scale growth is still in its early stage, especially regarding how to control the precursor and its distribution. Herein, we propose a new method, spraying the Mo precursor, which is proven to fabricate highly uniform 2-inch monolayer MoS wafers.

View Article and Find Full Text PDF

Unlabelled: Human adenoviruses (HAdVs) induce significant reorganization of the nuclear environment, leading to the formation of virus-induced subnuclear structures known as replication compartments (RCs). Within these RCs, viral genome replication, gene expression, and modulation of cellular antiviral responses are tightly coordinated, making them valuable models for studying virus-host interactions. In a recent study, we analyzed the protein composition of HAdV type 5 (HAdV-C5) RCs isolated from infected primary cells at different time points during infection using quantitative proteomics.

View Article and Find Full Text PDF

Janus MXene Fiber Constructed via Flake Orientation Engineering.

Adv Mater

September 2025

Center for Renewable Energy and Storage Technologies (CREST), King Abdullah University of Science and Technology (KAUST), Thuwal, 23955-6900, Saudi Arabia.

The orientation of MXene flakes has received increasing research attention as it plays a critical role in determining the performance of MXene-based assemblies. Engineering MXene flakes into horizontal or vertical orientations can offer distinct advantages such as higher electrical conductivity, higher mechanical strength, and more efficient ion/molecule transport across the flakes. However, the benefits of horizontal and vertical orientations are mutually exclusive, and both of them possess structural symmetry that restricts their ability for stimuli-responsive deformation.

View Article and Find Full Text PDF