Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Complete edentulism is one of the most common problems encountered by geriatric individuals. With advanced aging, despite attempts made to retain natural dentition, loss of entire teeth is yet observed. For precise denture fabrication, a digital sensor device was used during the making procedure. The use of sensor device aided in better appreciation and more retentiveness of denture.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10445671PMC
http://dx.doi.org/10.4103/jmss.jmss_10_22DOI Listing

Publication Analysis

Top Keywords

sensor device
12
digital sensor
8
treatment ill-fitting
4
ill-fitting complete
4
complete dental
4
dental prosthesis
4
prosthesis digital
4
device case
4
case report
4
report complete
4

Similar Publications

AlN is a core material widely used as a substrate and heat sink in various electronic and optoelectronic devices. Introducing luminescent properties into intrinsic AIN opens new opportunities for next-generation intelligent sensors, self-powered displays, and wearable electronics. In this study, the first evidence is presented of AlN crystals exhibiting satisfactory mechanoluminescence (ML), photoluminescence (PL), and afterglow performance, demonstrating their potential as novel multifunctional optical sensors.

View Article and Find Full Text PDF

Localized Gradient Conductivity Enabled Ultrasensitive Flexible Tactile Sensors with Ultrawide Linearity Range.

Adv Mater

September 2025

Key Laboratory of Low Dimensional Quantum Structures and Quantum Control of Ministry of Education, School of Physics and Electronics, Hunan Normal University, Changsha, 410081, China.

The high sensitivity and wide linearity are crucial for flexible tactile sensors in adapting to diverse application scenarios with high accuracy and reliability. However, conventional optimization strategies of constructing microstructures suffer from the mutual restriction between the high sensitivity and wide linearity. Herein, a novel design of localized gradient conductivity (LGC) with partly covered low-conductivity (low-σ) carbon/Polydimethylsiloxane layer on high-conductivity (high-σ) silver nanowires film upon the micro-dome structure is proposed.

View Article and Find Full Text PDF

With the continuous development of flexible sensors and flexible energy storage devices, gel materials with good flexibility, toughness, and tunable properties have attracted wide attention. Deep eutectic solvents (DES) have an obvious advantage of thermal and chemical stability over water. Therefore, eutectogels can effectively solve the problem of insufficient stability of traditional hydrogels.

View Article and Find Full Text PDF

Accurately assessing saltiness perception in solid foods is essential for the development of low-sodium foods that maintain saltiness despite possessing a lower sodium content. This study aimed to develop a practical system for evaluating human-perceived saltiness during oral processing, particularly when food was initially placed on the tongue. As a basis for system design, sensory evaluations demonstrated that higher local salt concentrations (inhomogeneous distribution) on the tongue significantly enhanced perceived saltiness intensity compared to a homogeneous distribution, despite equal total salt content.

View Article and Find Full Text PDF

A novel molecularly imprinted polymer (MIP)-based electrochemical sensor has been developed for the selective detection of naringenin (NAR) in various real-world samples, including plant extracts, wine, and herbal supplements. To enhance the active surface area and porosity of the glassy carbon electrode (GCE), a 2D/0D nanocomposite composed of graphene oxide (GO) and cobalt ferrite (CFO) nanoparticles, CFO_GO, was incorporated into the sensor design. 4-aminobenzoic acid (4-ABA) was selected as the functional monomer to prepare the MIPs.

View Article and Find Full Text PDF