98%
921
2 minutes
20
Both surfactants and natural organic matters (NOMs) are substances commonly found in aqueous environments, and their effects on the transport of nanoplastics that is gradually gaining widespread attention in porous media are currently in their infancy, while their combined effects are absent. We investigated innovatively the combined effect of surfactants and NOMs on the transport of polystyrene nanoplastics (PS-NPs) in saturated porous media. Adsorption tests of surfactants and NOMs onto PS-NPs, adsorption tests of PS-NPs onto quartz sand, and transport tests of PS-NPs in saturated quartz sand were conducted. Hydrophobicity and Derjaguin-Landau-Verwey-Overbeek (DLVO) interaction energy were measured and calculated. A mathematical model was employed to fit the transport of PS-NPs in porous media. It was found that the effects and action mechanisms of cationic cetyl trimethylammonium bromide (CTAB) and anionic sodium dodecylbenzene sulfonate (SDBS) on the transport of PS-NPs in porous media were distinct. In the presence of CTAB, 1 mg/L humic acid (HA) and 10 mg/L sodium alginate (SA) could promote aggregation of PS-NPs by decreasing the absolute zeta potential of PS-NPs, and reducing the energy barrier between PS-NPs and porous media and increasing the blocking and straining, thus inhibiting the transport of PS-NPs. In the presence of SDBS, SA and HA could improve the adsorption of SDBS onto PS-NPs by bridging and increasing adsorption sites, thus increasing the hydrophilicity of PS-NPs and improving the transport of PS-NPs. Whether or not NOMs were present, the transport of PS-NPs in porous media was mainly governed by the DLVO interaction energy in the presence of cationic surfactants and by hydrophobicity in the presence of anionic surfactants. This innovative observation has led to an understanding on the environmental behaviour of nanoplastics in porous media under complex environments.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.scitotenv.2023.165275 | DOI Listing |
ACS Appl Mater Interfaces
September 2025
Department of Chemistry, University of Wisconsin-Madison, 1101 University Ave., Madison, Wisconsin 53706, United States.
Slippery liquid-infused porous surfaces (or "SLIPS") can prevent bacterial surface fouling, but they do not inherently possess the means to kill bacteria or reduce cell loads in surrounding media. Past reports show that the infused liquids in these materials can be leveraged to load and release antimicrobial agents, but these approaches are generally limited to the use of hydrophobic agents that are soluble in the infused oily phases. Here, we report the design of so-called "proto-SLIPS" that address this limitation and permit the release of highly water-soluble (or oil-insoluble) agents.
View Article and Find Full Text PDFACS Appl Mater Interfaces
September 2025
Instituto de Cerámica y Vidrio (ICV-CSIC), C/Kelsen 5, 28049 Madrid, Spain.
The oxygen reduction reaction (ORR) is critical to energy conversion technologies and requires efficient catalysts for superior performance. Herein, nitrogen-doped carbide-derived carbon (N-CDC) catalysts are prepared using novel engineered molecular architectures based on polymer-derived ceramic technology. The obtained catalyst materials show a surface N concentration of >5 wt % and a hierarchically porous structure, resulting in a specific surface area of over 2000 m g.
View Article and Find Full Text PDFSnS (tin disulfide) is a promising anode active material for lithium-ion batteries (LIBs) due to its high theoretical capacity and low material cost. Conventional synthesis methods, such as solvothermal, hydrothermal, and solid-state, require long synthesis times, the use of solvents and surfactants, and several separation steps. However, the preparation of coated SnS composites using liquid media is even more complex, requiring suitable precursors, compatible solvents, and potentially several steps.
View Article and Find Full Text PDFLangmuir
September 2025
Key Laboratory of Green Chemical Media and Reactions (Ministry of Education), Collaborative Innovation Center of Henan Province for Green Manufacturing of Fine Chemicals, School of Chemistry and Chemical Engineering, Henan Normal University, Xinxiang, Henan 453007, P. R. China.
Recent years have witnessed growing research interest in proton-conducting metal-organic frameworks (MOFs) owing to the characteristics of highly ordered pores, oriented packing of crystals, and particularly designable structures. However, how to construct a suitable microenvironment in MOF pores to form optimal proton transport pathways remains challenging. In this study, four MOFs with similar porous diameters but different microenvironments have been screened to study how porous environments influence proton conduction for the first time.
View Article and Find Full Text PDFVertical cutoff wall is widely used as one of the in-situ remediation technologies for contaminated sites. In this paper, considering the unsaturated characteristics of porous media, a three-dimensional pollutant transport model of inner aquifer-vertical cutoff wall-outer aquifer is established. The main conclusions are as follows.
View Article and Find Full Text PDF