Magnetic restricted-access carbon nanotubes for SPME to determine cannabinoids in plasma samples by UHPLC-MS/MS.

Anal Chim Acta

Departamento de Química - Faculdade de Filosofia, Ciências e Letras de Ribeirão Preto, Universidade de São Paulo, Ribeirão Preto, São Paulo, 14040-901, Brazil. Electronic address:

Published: September 2022


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

This manuscript describes the development of magnetic restricted-access carbon nanotubes (M-RACNTs) for use as SPME sorbent to determine cannabidiol (CBD) and delta-9-tetrahydrocannabinol (THC) in human plasma samples by UHPLC-MS/MS. The adsorptive phase was immobilized on an SPME device by electromagnetic interactions between the M-RACNTs and a cylindrical neodymium magnet (3-mm diameter x 8-mm height) attached to a stainless-steel rod (3-mm diameter x 40-mm height). The M-RACNTs were synthesized by incorporating FeO magnetic nanoparticles (MNPs) into commercial carbon nanotubes (CNTs); then the surface of the resulting sorbent was further coated with a layer of bovine serum albumin (BSA). Characterization techniques (SEM, FTIR, and Zeta potential) confirmed the presence of both MNPs and BSA layer dispersed through the structure of the CNTs. The M-RACNTs presented adequate sorption capacity, stable physical/chemical characteristics, and appropriate magnetic properties. Protein exclusion capacity (about 98.5%) was attributed to the chemical diffusion barrier created by the BSA network at the outer surface of the sorbent. The SPME parameters (sample pH, equilibrium time, and desorption conditions) were optimized by design of experiments (fraction factorial planning). The method (validated according to the FDA guidelines) presented adequate selectivity and linearity (coefficient of determination higher than 0.99) at concentrations ranging from the lower limit of quantification (LLOQ) (10 ng mL) to the upper limit of quantification (ULOQ) (300 ng mL) for both CBD and THC. Precision and accuracy varied from 4.47 to 19.84% (LLOQ) and -6.90 to 17.78% (LLOQ), respectively. Carry-over and matrix effect were not significant. The method was successfully applied to determine plasmatic CBD levels in healthy volunteers attending a single session of oral drug administration and THC levels in frequent cannabis smokers.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.aca.2022.340160DOI Listing

Publication Analysis

Top Keywords

carbon nanotubes
12
magnetic restricted-access
8
restricted-access carbon
8
plasma samples
8
samples uhplc-ms/ms
8
3-mm diameter
8
surface sorbent
8
presented adequate
8
limit quantification
8
magnetic
4

Similar Publications

The effect of electron irradiation ( = 1.8 MeV) on the optical properties of polyethylene glycol 400-multiwalled carbon nanotube (PEG-400/MWCNT) nanocomposite films was studied within an absorbed dose range of 0 to 0.4 MGy.

View Article and Find Full Text PDF

Molecular recognition and determination of vascular cell adhesion molecule-1 (VCAM-1), interleukin-6 (IL-6), and natriuretic peptide C-type (NPPC) are essential for the early prognosis and diagnosis of cardiovascular diseases, especially in young obese populations. Highly sensitive and selective devices characterized by low Limits of quantification are required for their determination in whole blood. Therefore, a 3D stochastic sensor was developed by immobilizing a chitosan hydrogel onto a carbon paste electrode (used as the support matrix for the hydrogel), which was subsequently modified with gold nanoparticles, multi-walled carbon nanotubes, and β-cyclodextrin (β-CD/AuNPs@MWCNT/CS/CPE).

View Article and Find Full Text PDF

Aerogels are widely used in environmental remediation, but their application is hindered by brittleness, limited oil absorption and poor separation of viscous crude oil. In this study, a multifunctional superhydrophobic aerogel with electrothermal and photothermal effects was prepared from bacterial cellulose (BC), methyltrimethoxysilane (MTMS), and hydroxylated carbon nanotubes (HCNT) by soft-hard synergistic and directed freezing. The prepared aerogel exhibited an oriented layered porous structure with excellent compressibility and oil retention capacity.

View Article and Find Full Text PDF

The increasing global demand for food and the adverse environmental impacts of excessive agrochemical use highlights the urgent need for sustainable and scalable seed treatment technologies. This paper reports a novel photothermal seed coating (QC@SCCNTs) with high biocompatibility, exceptional photothermal efficiency, and notable reusability, serving as an effective alternative to conventional chemical treatments. The coating consists of sericin-functionalized carboxylated carbon nanotubes (SCCNTs) electrostatically complexed with quaternary ammonium chitosan (QC), forming a composite film (QS film).

View Article and Find Full Text PDF

Developing efficient, sustainable, earth-abundant, cost-effective electrocatalysts is extremely challenging. Cobalt-iron-layered double hydroxide nanosheets (Co-Fe-LDH NSs) hybridized with carbon nanotubes (CNTs) lead to anchors Co-Fe-LDH-CNTs (CFC) self-assembly with a mesoporous morphology, expanded surface area, fast charge transfer kinetics, and high electrical conductivity. The resultant anchored CFC nanohybrid is highly active for electrocatalytic oxygen evolution reaction (OER), showing a lower overpotential of 221 and 313 mV at a current density of 10 and 25 mA cm, respectively, compared to pristine Co-Fe-LDH (339 and 391 mV), showcasing the significant role of CNTs in improving the electrocatalytic performance of pristine Co-Fe-LDH.

View Article and Find Full Text PDF