98%
921
2 minutes
20
Submerged microfiltration has a wide range of applications in water and wastewater treatment. Membrane fouling is a major problem, resulting in a severe decline in flux, high energy consumption and frequent membrane cleaning and replacement. The effect of viscosity was not previously studied under controlled conditions to relate it to the air scour. Hence, this study investigated the effect of viscosity on membrane fouling during the operation of submerged membrane microfiltration by adding predetermined amounts of glycerol to a kaolin clay suspension. The addition of glycerol increased the viscosity (from 0.001 to 0.003 Pa·s), resulting in a 3-fold higher transmembrane pressure (TMP) development. An increased airflow (air scour) rate by 3 fold (from 0.6 m/m/h to 1.8 m/m/h), reduced TMP development by 65%. Membrane fouling quickly developed during the initial stage of microfiltration operation. Therefore, special precautions to control fouling during the early stages of filtration could significantly enhance the operation of the microfilter. Higher airflow caused a reduction in average specific cake resistance, whereas higher viscosity increased this value.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9413319 | PMC |
http://dx.doi.org/10.3390/membranes12080780 | DOI Listing |
ACS Appl Mater Interfaces
September 2025
Department of Chemistry, University of Wisconsin-Madison, 1101 University Ave., Madison, Wisconsin 53706, United States.
Slippery liquid-infused porous surfaces (or "SLIPS") can prevent bacterial surface fouling, but they do not inherently possess the means to kill bacteria or reduce cell loads in surrounding media. Past reports show that the infused liquids in these materials can be leveraged to load and release antimicrobial agents, but these approaches are generally limited to the use of hydrophobic agents that are soluble in the infused oily phases. Here, we report the design of so-called "proto-SLIPS" that address this limitation and permit the release of highly water-soluble (or oil-insoluble) agents.
View Article and Find Full Text PDFEnviron Sci Technol
September 2025
National Research Base of Intelligent Manufacturing Service, Chongqing Technology and Business University, Chongqing 400067, China.
Traditional dynamic membranes (DMs) are plagued by membrane fouling and low performance during long-term operation. In recent years, researchers have developed various functionalized dynamic membranes (FDMs) derived from DMs, employing different functional materials to provide an economically viable and promising solution for wastewater treatment. Nevertheless, there remains a gap in the comprehensive understanding of FDMs and the challenges encountered in their application.
View Article and Find Full Text PDFJ Food Sci Technol
October 2025
Federal Technological University of Paraná, Cristo Rei Street, 19 Toledo, Toledo, Parana Brazil.
Traditional methods for fruit juice preservation use high temperatures, which degrade beneficial compounds like vitamins and antioxidants. Membrane filtration provides a gentler alternative, preserving nutrients through mild operating temperatures. This study assessed the temperature and pressure influence on watermelon juice microfiltration, focusing on permeated flow, lycopene, sugars, phenolic compounds, and flavonoids.
View Article and Find Full Text PDFJ Environ Manage
September 2025
Shandong Provincial Key Laboratory of Water Pollution Control and Resource Reuse, Shandong Key Laboratory of Environmental Processes and Health, School of Environmental Science and Engineering, Shandong University, Qingdao, 266237, China. Electronic address:
Anaerobic self-forming dynamic membrane (AnSFDM) bioreactors have attracted increasing attention owing to their cost-effectiveness and lower carbon footprint. AnSFDM formation is the initial process of their operation and of pivotal importance for determining the basic characteristics of AnSFDMs. Nevertheless, the effect of operational parameters on the AnSFDM formation process has not been studied in a systematical and quantitative manner.
View Article and Find Full Text PDFBiofouling
September 2025
DuPont, DuPont Water Solutions, Freienbach, Switzerland.
Imaging techniques are important for biofilm studies. Biofilm samples should ideally be visualised with minimal sample preparation so as not to alter their original structure. However, this can be challenging and resource-intensive in most cases.
View Article and Find Full Text PDF