Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Purpose: This study aimed to characterize the thermal and cardiovascular strain of professional cyclists during the 2019 Tour Down Under and determine the associations between thermal indices and power output, and physiological strain.

Methods: Gastrointestinal temperature ( Tgi ), heart rate (HR), and power output were recorded during the six stages (129-151.5 km) of the Tour Down Under in ≤22 male participants. Thermal indices included dry-bulb, black-globe, wet-bulb, and wet-bulb-globe (WBGT) temperature; relative humidity (RH), Heat Index; Humidex; and universal thermal climate index. The heat stress index (HSI), which reflects human heat strain, was also calculated.

Results: Dry-bulb temperature was 23°C-37°C, and RH was 18%-72% (WBGT: 21°C-29°C). Mean Tgi was 38.2°C-38.5°C, and mean peak Tgi was 38.9°C-39.4°C, both highest values recorded during stage 3 (WBGT: 27°C). Peak individual Tgi was ≥40.0°C in three stages and ≥39.5°C in 14%-33% of cyclists in five stages. Mean HR was 131-147 bpm (68%-77% of peak), with the highest mean recorded in stage 3 ( P ≤ 0.005). Mean power output was 180-249 W, with the highest mean recorded during stage 4 ( P < 0.001; 21°C WBGT). The thermal indices most strongly correlated with power output were black-globe temperature ( r = -0.778), RH ( r = 0.768), universal thermal climate index ( r = -0.762), and WBGT ( r = -0.745; all P < 0.001). Mean Tgi was correlated with wet-bulb temperature ( r = 0.495), HSI ( r = 0.464), and Humidex ( r = 0.314; all P < 0.05), whereas mean HR was most strongly correlated with HSI ( r = 0.720), along with Tgi ( r = 0.599) and power output ( r = 0.539; all P < 0.05).

Conclusions: Peak Tgi reached 40.0°C in some cyclists, although most remained <39.5°C with an HR of ~73% of peak. Power output was correlated with several thermal indices, primarily influenced by temperature, whereas Tgi and HR were associated with the HSI, which has potential for sport-specific heat policy development.

Download full-text PDF

Source
http://dx.doi.org/10.1249/MSS.0000000000003028DOI Listing

Publication Analysis

Top Keywords

power output
20
thermal indices
12
recorded stage
12
universal thermal
8
thermal climate
8
peak tgi
8
highest recorded
8
tgi
7
thermal
6
power
5

Similar Publications

Efficient Carrier Separation via Ru@TS@C Zeolite: Enabling Photo-Cathodes for High-Efficiency Photo-Assisted Metal-Air Batteries.

Angew Chem Int Ed Engl

September 2025

State Key Laboratory of Inorganic Synthesis and Preparative Chemistry, College of Chemistry, Jilin University, Changchun, 130012, P.R. China.

Neutral aqueous Zn-air batteries (ZABs), while promising for extended lifespans and recyclability compared to alkaline systems, are hindered by sluggish kinetics that limit energy efficiency and power output. Here, we report an effective approach to construct a photo-assisted near-neutral ZAB based on a photo-responsive titanium silicalite-1 zeolite (TS-1). The incorporation of Ru active centers into the 3D porous architecture of TS@C (Ru@TS@C), which exhibits remarkably enhanced electronic conduction, creates interconnected conductive pathways.

View Article and Find Full Text PDF

This article demonstrates maximum power point tracking (MPPT) using a DC-DC boost converter. It introduces an intelligent control technique with fuzzy-based pattern search (PS) optimization for the MPPT controller, enhancing energy conversion efficiency. The fuzzy-PS approach is further refined with PA optimization.

View Article and Find Full Text PDF

This study presents a novel photovoltaic triboelectric nanogenerator (PTENG) that operates on sliding contacts between n-type (gallium arsenide) GaAs and metal electrodes in the presence of periodic light illumination, which offers harvesting energy synergistically by integrating both photovoltaic and triboelectric effects to enhance the energy output. Using an in-house built test setup with provision of laser illumination, the open-circuit voltage () and short-circuit current () were measured for the n-GaAs semiconductors with different metal contacts (Al and Cu). Under both laser light (630 nm) and without laser light conditions, n-GaAs with aluminum contacts exhibited the highest and values, reaching up to 11.

View Article and Find Full Text PDF

Droplet electricity generators (DEGs) that generate electricity through the interplay between water and the dielectric materials have attracted growing research interest due to their remarkable output voltage. However, conventional DEG design faces a critical trade-off: regulating the properties of dielectric materials, such as thickness or permittivity, can enhance output voltage yet weaken transferred charge. Here, a fluorinated ethylene propylene (FEP)/multi-walled carbon nanotubes (MWCNTs)/polydimethylsiloxane (PDMS) composite-based droplet electricity generator (FMP-DEG) is presented to overcome the voltage-charge trade-off and thus achieve an enhanced energy conversion efficiency of 4.

View Article and Find Full Text PDF

Homo-layer flexible BiTe-based films with high thermoelectric performance.

Sci Adv

September 2025

Department of Physics, State Key Laboratory of Quantum Functional Materials, and Guangdong Basic Research Center of Excellence for Quantum Science, Southern University of Science and Technology, Shenzhen 518055, China.

Here, we demonstrate unconventional scalable and sustainable manufacturing of flexible n-type BiTe films via physical vapor deposition and homo-layer fusion engineering. The achieved ultrahigh power factor of up to 30.0 microwatts per centimeter per square kelvin and ultralow lattice thermal conductivity of 0.

View Article and Find Full Text PDF