Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Purpose: This study aimed to assess the influence of graded air temperatures during repeated-sprint training in hypoxia (RSH) on performance and physiological responses.

Methods: Ten well-trained athletes completed one familiarization and 4 experimental sessions at a simulated altitude of 3000 m (0.144 FIO2) above sea level. Air temperatures utilized across the 4 experimental sessions were 20°C, 25°C, 30°C, and 35°C (all 50% relative humidity). The participants performed 3 sets of 5 × 10 seconds "all-out" cycle sprints, with 20 seconds of active recovery between sprints and 5 minutes of active recovery between sets (recovery intensity = 120 W). Core temperature, skin temperature, pulse oxygen saturation, heart rate, rating of perceived exertion, and thermal sensation were collected.

Results: There were no differences between conditions for peak power, mean power, and total work in each set (P > .05). There were no condition × time interaction effects for any variables tested. The peak core temperature was highest at 30°C (38.06°C [0.31°C]). Overall, the pulse oxygen saturation was higher at 35°C than at 20°C (P < .001; d < 0.8), 25°C (P < .001; d = 1.12 ± 0.54, large), and 30°C (P < .001; d = 0.84 ± 0.53, large).

Conclusion: Manipulating air temperature between 20°C and 35°C had no effect on performance or core temperature during a typical RSH session. However, the pulse oxygen saturation was preserved at 35°C, which may not be a desirable outcome for RSH interventions. The application of increased levels of ambient heat may require a different approach if augmenting the RSH stimulus is the desired outcome.

Download full-text PDF

Source
http://dx.doi.org/10.1123/ijspp.2020-0676DOI Listing

Publication Analysis

Top Keywords

core temperature
12
pulse oxygen
12
oxygen saturation
12
repeated-sprint training
8
training hypoxia
8
air temperatures
8
experimental sessions
8
active recovery
8
temperature
5
heat repeated-sprint
4

Similar Publications

Immunoelectron microscopy: a comprehensive guide from sample preparation to high-resolution imaging.

Discov Nano

September 2025

Department of Rehabilitation Medicine, Rehabilitation Medical Center, Key Laboratory of Rehabilitation Medicine in Sichuan Province, West China Hospital, Sichuan University, Chengdu, 610041, People's Republic of China.

Immunoelectron Microscopy (IEM) is a technique that combines specific immunolabeling with high-resolution electron microscopic imaging to achieve precise spatial localization of biomolecules at the subcellular scale (< 10 nm) by using high-electron-density markers such as colloidal gold and quantum dots. As a core tool for analyzing the distribution of proteins, organelle interactions, and localization of disease pathology markers, it has irreplaceable value, especially in synapse research, pathogen-host interaction mechanism, and tumor microenvironment analysis. According to the differences in labeling sequence and sample processing, the IEM technology system can be divided into two categories: the first is pre-embedding labeling, which optimizes the labeling efficiency through the pre-exposure of antigenic epitopes and is especially suitable for the detection of low-abundance and sensitive antigens; the second is post-embedding labeling, which relies on the low-temperature resin embedding (e.

View Article and Find Full Text PDF

The calibration of the JET x-ray spectrometer is presented. The absolute throughput, diffractor focusing, and instrument function of the spectrometer are presented, and the quality of the ion temperature measurement is re-assessed, particularly at the lower end. The addition of a second diffractor enables the simultaneous measurements of the spectra from H- and He-like nickel, which widens the spatial coverage of the core-ion temperature measurements for high-performance plasmas at a fixed Bragg angle range.

View Article and Find Full Text PDF

AlN is a core material widely used as a substrate and heat sink in various electronic and optoelectronic devices. Introducing luminescent properties into intrinsic AIN opens new opportunities for next-generation intelligent sensors, self-powered displays, and wearable electronics. In this study, the first evidence is presented of AlN crystals exhibiting satisfactory mechanoluminescence (ML), photoluminescence (PL), and afterglow performance, demonstrating their potential as novel multifunctional optical sensors.

View Article and Find Full Text PDF

Background: Understanding starch behavior under various processing conditions is important for the development of novel food products with tailored nutritional profiles. This study investigated changes to the structure and properties of native corn starch (NCS) and biomimetic starch-entrapped microspheres following thermal and enzymatic treatments.

Results: Heat-treated microspheres showed more birefringence and structural order than native starch, indicating incomplete gelatinization due to the alginate matrix.

View Article and Find Full Text PDF

Dissecting the microbial, physicochemical, and flavor dynamics of core and peel layers in Houhuo Daqu: Insights into quality regulation.

Food Res Int

November 2025

Brewing Technology Industrial College, Hubei University of Arts and Science, Xiangyang, Hubei Province 441053, PR China; Hubei Provincial Engineering and Technology Research Center for Food Ingredients, Hubei University of Arts and Science, Xiangyang, Hubei Province 441053, PR China; Xiangyang Lacti

Houhuo Daqu (HHD) exhibits significant heterogeneity between its core and peel layers, yet their differences remain underexplored. This study integrates metagenomic sequencing and electronic sensory technologies to compare the physicochemical properties, microbial communities, and flavor profiles of HHD's core and peel. Results reveal distinct microbial communities and diversity between the layers.

View Article and Find Full Text PDF