98%
921
2 minutes
20
The different effects of nitrogen-flow (NF) and air-limitation (AL) pyrolysis on the characteristics and nutrient retention of biochars (BCs) are unclear. Hence, in this study, BCs derived from bamboo, corn straw, and wheat straw were produced in AL and NF atmospheres at various temperatures (300-750 °C), and their different characteristics and nutrient retention rates were compared systematically. Nitrogen-flow pyrolysis facilitates C retention and graphitic C formation, and AL pyrolysis improves the polarity and supports the formation of oxygen-containing groups. With increasing pyrolysis temperature, C retention and graphitic C formation in BCs derived from AL pyrolysis decreases more significantly compared with BCs from NF pyrolysis. At 750 °C, the polarity and oxygen-containing groups of BCs derived from AL pyrolysis increase, whereas those from BCs derived from NF pyrolysis decrease. The observations are attributable to the AL and high-temperature-enhanced oxidization and gasification of C. An AL atmosphere with a higher pyrolysis temperature supports porosity and results in a larger specific surface area. Although pyrolysis temperature and atmosphere have negligible effects on nutrient retention, a low pyrolysis temperature facilitates the formation of water-soluble Ca, Mg, and P, and AL pyrolysis facilitates the formation of water-soluble P because the high pyrolysis temperature improves the pH and mineral stability of BCs, and air limitation facilitates the oxidation of organic P into PO . This study provides a reference for selecting AL or NF pyrolysis based on various pyrolysis temperatures to produce BCs and applying these in C sequestration, contaminant sorption, and soil quantity improvement.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1002/jeq2.20133 | DOI Listing |
RSC Adv
September 2025
Saveetha School of Engineering, Saveetha Institute of Medical and Technical Sciences, Saveetha University Chennai Tamil Nadu 602105 India.
A free radical polymerization approach was applied to synthesize different carboxymethyl cellulose-grafted poly(acrylamide) hydrogels (Hyd) composited with biochar, magnetic biochar, and magnetic biochar decorated with ZIF-67 to decontaminate methylene blue (MB) from water media. Biochar was obtained from walnut shells (WS) by a pyrolysis method, and magnetic biochar (WS/CoFeO) and biochar-decorated ZIF-67 (WS/CoFeO/ZIF-67) were prepared by chemical co-precipitation and hydrothermal methods, respectively. An increase in the amount of these particles by up to 10 wt% enhanced the removal performance.
View Article and Find Full Text PDFBioresour Technol
September 2025
State Key Laboratory of Coal Combustion, School of Energy and Power Engineering, Huazhong University of Science and Technology, 1037 Luoyu Road, Wuhan 430074, China.
The pyrolysis of flue-cured tobacco stalks (TS) faces challenges such as low bio-oil value and utilization efficiency. Existing studies have overlooked the anatomical heterogeneity of tobacco stalks, thereby limiting the directional regulation of high-value components, such as nicotine and phenolic compounds. This study divides TS into the husk (TSH), xylem (TSX), and pith (TSP), and investigates their physicochemical properties, pyrolysis behavior (through TGA and fixed-bed pyrolysis experiments), and interactions.
View Article and Find Full Text PDFAnal Chem
September 2025
Department of Chemistry, The University of Akron, Akron, Ohio 44325, United States.
Tires are complex polymeric materials composed of rubber elastomers (both natural and synthetic), fillers, steel wire, textiles, and a range of antioxidant and curing systems. These constituents are distributed differently among the various tire parts, which are classified based on their function and proximity to the rim. This study presents a rapid and sensitive approach for the characterization of tire components using mild thermal desorption/pyrolysis (TDPy) coupled to direct analysis in real-time mass spectrometry (DART-MS).
View Article and Find Full Text PDFAnal Sci
September 2025
Frontier Laboratories Ltd., 4-16-20, Saikon, Koriyama, Fukushima, 963-8862, Japan.
Biomass-based polymers such as poly(lactic acid) (PLA) have attracted much attention, because they are renewable, biocompatible, and nontoxic to the environment and have been used in various fields such as biomedical, agricultural, and food packaging industries. However, one of the common drawbacks of PLA-based materials is their low glass transition temperature in the amorphous state, while adding phenylphosphonic acid zinc salt (PPA-Zn) as a nucleating agent was found to be a promising method to improve the physical property of PLA. On the other hand, degradation of PLA-based materials in the environment may cause the pollution from the metal of a nucleating agent in PLA and quantification of nucleating agents in polymers is of interest.
View Article and Find Full Text PDFEnviron Res
September 2025
School of Environmental Science and Engineering, Huazhong University of Science and Technology, 1037 Luoyu Road, Wuhan, Hubei, 430074, China; Hubei Provincial Engineering Laboratory of Solid Waste Treatment, Disposal and Recycling, 1037 Luoyu Road, Wuhan, Hubei, 430074, China. Electronic address: ho
The activation of peroxymonosulfate (PMS) by biochar has shown promising potential for the efficient degradation and detoxification of antibiotics in wastewater. However, the underlying mechanisms are not fully understood. In this study, Fenton-conditioned sludge-derived biochar (FSBC) was prepared by microwave pyrolysis to activate PMS for the efficient degradation and detoxification of sulfamethoxazole (SMX).
View Article and Find Full Text PDF