Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Our aim was to understand how moderately increased light intensities influenced the response of chickpea to high temperature. Three chickpea genotypes (Acc#3, Acc#7 and Acc#8) were treated at control (26 °C and 300 μmol m s photosynthetic photon flux density/PPFD), high temperature (38 °C and 300 μmol m s PPFD), increased light intensity (26 °C and 600 μmol m s PPFD) and combination of increased light and temperature (38 °C and 600 μmol m s PPFD). The net photosynthetic rate (P) of Acc#3 and Acc#8 significantly decreased at high temperature regardless of light intensity. The P of all three genotypes at increased light intensity was significantly higher than that at high temperature. The intracellular CO concentration (C), stomatal conductance (g) and transpiration rate (E) of Acc#3 and Acc#8 at increased light intensity with or without high temperature significantly decreased in comparison with control and individually high temperature treatment. The relative water content of Acc#3 at high temperature and the combination treatment decreased as compared with control. The relative water content of Acc#7 at control was higher than the other three treatments. The F/F (Maximum quantum efficiency of photosystem II) of leaves from the three genotypes at 38 °C were lower than at 26 °C regardless of light intensity. The high temperature decreased chlorophyll content in the lower bottom leaf of Acc#7 and Acc#8 than control. In conclusion, chickpeas showed a higher net photosynthetic rate at increased light intensity to withstand heat stress, which was genotype-dependent. Physiological responses of different chickpea genotypes to increased temperature and light intensity indicated that distinct responsive mechanism of photosynthesis. This study provides information on how chickpea respond to high temperature and increased light intensity, which will help us to improve chickpea to deal with future climate changes.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.plaphy.2020.06.030DOI Listing

Publication Analysis

Top Keywords

high temperature
40
increased light
32
light intensity
32
temperature
12
light
11
high
10
increased
9
responses chickpea
8
chickpea high
8
moderately increased
8

Similar Publications

The development of anode materials for lithium-ion batteries must meet the demands for high safety, high energy density, and fast-charging performance. TiNbO is notable for its high theoretical specific capacity, low structural strain, and exceptional fast-charging capability, attributed to its Wadsley-Roth crystal structure. However, its inherently poor conductivity has hindered its practical application.

View Article and Find Full Text PDF

In this study, employing a 2D electrodeposition in situ assembly method, a high-performance HS sensor based on a p-n type CuO-CuFeO heterostructure ordered nanowire arrays was successfully fabricated on silicon substrates. Compared to CuO, CuO-CuFeO nanowire arrays exhibits an ideal interfacial barrier structure and higher initial resistance, with a response to 10 ppm of HS at room temperature (20 ± 3 °C) increased by 225 times and a response time reduced by over 2400 s. The sensor demonstrates exceptional sensitivity (LOD = 10 ppb; response = 234.

View Article and Find Full Text PDF

Background: On September 27, 2024, Rwanda reported an outbreak of Marburg virus disease (MVD), after a cluster of cases of viral hemorrhagic fever was detected at two urban hospitals.

Methods: We report key aspects of the epidemiology, clinical manifestations, and treatment of MVD during this outbreak, as well as the overall response to the outbreak. We performed a retrospective epidemiologic and clinical analysis of data compiled across all pillars of the outbreak response and a case-series analysis to characterize clinical features, disease progression, and outcomes among patients who received supportive care and investigational therapeutic agents.

View Article and Find Full Text PDF

Lead-free electroceramics have attracted significant research interest as alternatives to lead-containing systems due to concerns related to lead's toxicity to human health and the environment. Solid solutions based on bismuth sodium titanate (BNT) and barium titanate (BT), particularly those with compositions near the morphotropic phase boundary (MPB), such as 0.94 BiNaTiO-0.

View Article and Find Full Text PDF

Targeted temperature management (TTM) is currently the only potentially neuroprotective intervention recommended for post-cardiac arrest care. However, there are concerns among the scientific community regarding conflicting evidence supporting this recommendation. Moreover, the bulk of trials included in systematic reviews that inform guidelines and recommendations have been conducted in developed countries, with case mix and patient characteristics that significantly differ from the reality of developing countries such as Brazil.

View Article and Find Full Text PDF