Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

In this work, a novel magnetic biochar of camphor leaf with large micropore area was prepared for ciprofloxacin removal. Biochar show the advantage of resource utilization, as an adsorbent in pollutant removal, but limited by its relatively low specific surface area and poor adsorption capacity. An efficient method was formulated to prepare ZnO nanoparticle modified magnetic biochar to adsorb ciprofloxacin. The biochar with ZnCl/biochar mass ratio of 2 at the calcination temperature of 650 °C was a typical microporous material with huge surface area (915 m g). The maximum ciprofloxacin adsorption capacity of the biochar reached 449.40 mg L. The adsorption mechanism was discussed in terms of physical adsorption and chemisorption involving intense π-π stacking interaction, electrostatic interaction, cation exchange interaction etc. The adsorption capacity of biochar did not decline adsorption capacity significantly after 3 times regeneration. It provides a recycle and reuse way for camphor leaves resource disposal.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.biortech.2019.121511DOI Listing

Publication Analysis

Top Keywords

adsorption capacity
16
camphor leaves
8
ciprofloxacin adsorption
8
magnetic biochar
8
surface area
8
capacity biochar
8
biochar
7
adsorption
7
efficient adsorbent
4
adsorbent simultaneous
4

Similar Publications

Green synthesis of silver nanoparticles using Ocimum sanctum for efficient Congo red dye removal: a response surface methodology approach.

Environ Monit Assess

September 2025

Department of Civil Engineering, Faculty of Engineering, Karpagam Academy of Higher Education, Pollachi Main Road, Eachanari Post, Coimbatore, Tamil Nadu, 641021, India.

Synthetic dyes, such as Congo red (CR), pose serious threats to human health and aquatic ecosystems because of their carcinogenicity and resistance to degradation, necessitating the development of efficient and eco-friendly remediation strategies. In this study, silver nanoparticles (AgNPs) were synthesized via a green method using Ocimum sanctum (holy basil) leaf extract and applied for CR dye removal from aqueous solutions. The adsorption process was optimized using response surface methodology (RSM) based on Box-Behnken design (BBD), evaluating the influence of key parameters including pH, AgNP dosage, initial dye concentration, contact time, and temperature.

View Article and Find Full Text PDF

A key challenge in capturing CO from postcombustion gases is humidity due to competitive adsorption between CO and HO. Multivariate (MTV) metal-organic frameworks (MOFs) have been considered a promising option to address this problem, e.g.

View Article and Find Full Text PDF

Lutetium (Lu(III)), a heavy rare earth element, plays a critical role in advanced industrial processes and nuclear medicine applications. Given its high economic value and potential environmental risks, the recovery of Lu(III) from medical wastewater is both necessary and urgent. However, previous studies on the adsorption behavior of Lu(III) have been limited by low adsorption capacity, competition from coexisting metal ions, and the influence of environmental temperature.

View Article and Find Full Text PDF

Galvanizing waste-derived Zn-induced defective Fe-based metal-organic frameworks as superior adsorbent for enhanced antibiotic removal.

Environ Res

September 2025

College of Chemistry, Chemical Engineering and Environment, Minnan Normal University, Zhangzhou 363000, China; Fujian Province Key Laboratory of Morden Analytical Science and Separation Technology, Minnan Normal University, Zhangzhou 363000, China; Fujian Provincial University Key Laboratory of Poll

The derivation of defect-engineered metal-organic frameworks (MOFs) from industrial waste simultaneously mitigates environmental pollution, reduces MOF synthesis costs, and enhances adsorption performance. Herein, this study demonstrates a sustainable strategy for the resourceful synthesis of iron-based MOF s-MIL-100(Fe) using galvanizing pickling waste liquor (80.5 wt.

View Article and Find Full Text PDF

A novel molecularly imprinted 3D COF-based magnetic solid-phase extraction combined with UHPLC-MS/MS to detect trace residues of acyclovir, penciclovir and ganciclovir in animal-derived food.

Food Chem

September 2025

Shanghai Frontiers Science Center of Drug Target Identification and Delivery, National Key Laboratory of Innovative Immunotherapy, Engineering Research Center of Cell & Therapeutic Antibody, School of Pharmaceutical Sciences, Shanghai Jiao Tong University, Shanghai 200240, China. Electronic address:

The residues of antiviral drugs acyclovir (ACV), penciclovir (PCV) and ganciclovir (GCV) in foods, particularly in ready-to-eat products, pose a significant threat to human health, making it urgent to develop a rapid and sensitive method for their detection. Herein, we designed a novel magnetic molecularly imprinted three-dimensional covalent organic framework (MICOF@FeO) for selective extraction of these antiviral drugs from complicated food matrix. The prepared MICOF@FeO integrates molecular recognition ability, 3D COF structural advantages and magnetic responsiveness, providing high selectivity, large adsorption capacity and facile operation for magnetic solid-phase extraction (MSPE).

View Article and Find Full Text PDF