98%
921
2 minutes
20
Purpose: To examine if ad libitum drinking will adequately support hydration during exertional heat stress.
Methods: Ten endurance-trained runners ran for 2 h at 60% of maximum oxygen uptake under different conditions. Participants drank water ad libitum during separate trials at mean ambient temperatures of 22 °C, 30 °C and 35 °C. Participants also completed three trials at a mean ambient temperature of 35 °C while drinking water ad libitum in all trials, and with consumption of programmed glucose or whey protein hydrolysate solutions to maintain euhydration in two of these trials. Heart rate, oxygen uptake, rectal temperature, perceived effort, and thermal sensation were monitored, and nude body mass, hemoglobin, hematocrit, and plasma osmolality were measured before and after exercise. Water and mass balance equations were used to calculate hydration-related variables.
Results: Participants adjusted their ad libitum water intake so that the same decrease in body mass (1.1-1.2 kg) and same decrease in body water (0.8-0.9 kg) were observed across the range of ambient temperatures which yielded significant differences (p < .001) in sweat loss. Overall, water intake and total water gain replaced 57% and 66% of the water loss, respectively. The loss in body mass and body water associated with ad libitum drinking resulted in no alteration in physiological and psychophysiological variables compared with the condition when hydration was nearly fully maintained (0.3 L body water deficit) relative to pre-exercise status from programmed drinking.
Conclusions: Ad libitum drinking is an appropriate strategy for supporting hydration during running for 2 h duration under hot conditions.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1007/s00421-018-3996-7 | DOI Listing |
ACS Appl Mater Interfaces
September 2025
The Steve Sanghi College of Engineering, Mechanical Engineering, Northern Arizona University, Flagstaff, Arizona 86011, United States.
This study investigates the HO and CO sorption behavior of two chemically distinct polystyrene-divinylbenzene-based ion exchange sorbents: a primary amine and a permanently charged strong base quaternary ammonium (QA) group with (bi)carbonate counter anions. We compare their distinct interactions with HO and CO through simultaneous thermal gravimetric, calorimetric, gas analysis, and molecular modeling approaches to evaluate their performance for dilute CO separations like direct air capture. Thermal and hybrid (heat + low-temperature hydration) desorption experiments demonstrate that the QA-based sorbent binds both water and CO more strongly than the amine counterparts but undergoes degradation at moderate temperatures, limiting its compatibility with thermal swing regeneration.
View Article and Find Full Text PDFAnal Chem
September 2025
Department of Chemistry, The University of Akron, Akron, Ohio 44325, United States.
Tires are complex polymeric materials composed of rubber elastomers (both natural and synthetic), fillers, steel wire, textiles, and a range of antioxidant and curing systems. These constituents are distributed differently among the various tire parts, which are classified based on their function and proximity to the rim. This study presents a rapid and sensitive approach for the characterization of tire components using mild thermal desorption/pyrolysis (TDPy) coupled to direct analysis in real-time mass spectrometry (DART-MS).
View Article and Find Full Text PDFPlant Cell
September 2025
Department of Plant Sciences, College of Biological Sciences, State Key Laboratory of Plant Environmental Resilience, China Agricultural University, Beijing 100193, China.
Plant thermomorphogenesis is a critical adaptive response to elevated ambient temperatures. The transcription factor PHYTOCHROME-INTERACTING FACTOR 4 (PIF4) integrates diverse environmental and phytohormone signals to coordinate thermoresponsive growth. However, the cellular mechanisms underlying plant thermomorphogenic growth remain poorly understood.
View Article and Find Full Text PDFJ Refract Surg
September 2025
Department of Refractive Surgery, Shanghai Aier Eye Hospital, Shanghai.
Purpose: To analyze the effects of ablation interruption on ablation depths and clinical refractive outcomes to characterize the impact of ambient temperature changes and ablation interruption on ocular surface temperature (OST) during excimer laser ablation.
Methods: This prospective study was conducted on laser ablations in polymethylmethacrylate (PMMA) plates and porcine corneas to simulate laser in situ keratomileusis (LASIK) treatments using the EX500 laser (Alcon Laboratories, Inc) at ambient temperatures of 18, 20, and 22 °C. Ablation interruption was performed for 1, 2, 3, 4, and 5 seconds at the 10th second of the treatment of -9.
Adv Mater
September 2025
Center for Technology in Water and Wastewater, School of Civil and Environmental Engineering, University of Technology Sydney, Ultimo, NSW, 2007, Australia.
Global water scarcity demands next-generation desalination technologies that transcend the limitations of energy-intensive processes and salt accumulation. Herein, a groundbreaking interfacial solar steam generation system capable of simultaneous hypersaline desalination and ambient energy harvesting is introduced. Through hierarchical hydrogel architecture incorporating a central vertical channel and radial channels with gradient apertures, the design effectively decouples salt transport and water evaporation: solar-driven fluid convection directs water outward for evaporation, while inward salt migration prevents surface crystallization and redistributes excess heat.
View Article and Find Full Text PDF